Large arrays and properties of 3-terminal graphene nanoelectromechanical switches.

Large arrays of 3-terminal nanoelectromechanical graphene switches are fabricated. The switch is designed with a novel geometry that leads to low actuation voltages and improved mechanical integrity, while reducing adhesion forces, which improves the reliability of the switch. A finite element model including non-linear electromechanics is used to simulate the switching behavior and to deduce a scaling relation between the switching voltage and device dimensions.

Graphene blisters with switchable shapes controlled by pressure and adhesion.

We created graphene blisters that cover and seal an annular cylinder-shaped microcavity in a SiO2 substrate filled with a gas. By controlling the pressure difference between the gas inside and outside of the microcavity, we switch the graphene membrane between multiple stable equilibrium configurations. We carried out experiments starting from the situation where the pressure of the gas inside and outside of the microcavity is set equal to a prescribed charging pressure, p0 and the graphene membrane covers the cavity like an annular drum, adhered to the central post and the surrounding substrate due to van der Waals forces.

Observation of pull-in instability in graphene membranes under interfacial forces.

We present a unique experimental configuration that allows us to determine the interfacial forces on nearly parallel plates made from the thinnest possible mechanical structures, single and few layer graphene membranes. Our approach consists of using a pressure difference across a graphene membrane to bring the membrane to within ~10-20 nm above a circular post covered with SiOx or Au until a critical point is reached whereby the membrane snaps into adhesive contact with the post. Continuous measurements of the deforming membrane with an AFM coupled with a theoretical model allow us to deduce the magnitude of the interfacial forces between graphene and SiOx and graphene and Au.

Ultrastrong adhesion of graphene membranes.

As mechanical structures enter the nanoscale regime, the influence of van der Waals forces increases. Graphene is attractive for nanomechanical systems because its Young's modulus and strength are both intrinsically high, but the mechanical behaviour of graphene is also strongly influenced by the van der Waals force. For example, this force clamps graphene samples to substrates, and also holds together the individual graphene sheets in multilayer samples.