Sensitivity and Stability Enhancement of Surface Plasmon Resonance Biosensors based on a Large-Area Ag/MoS Substrate.

Surface plasmon resonance (SPR) sensors based on a silver film suffer from signal degradation due to silver oxidation in aqueous sensing environments. To overcome this limitation, we fabricated the planar plasmonic substrate employing an atomic MoS layer on a silver surface. Successful production of a large-area MoS monolayer blocks the penetration of oxygen and water molecules.

Improved biomolecular detection based on a plasmonic nanoporous gold film fabricated by oblique angle deposition.

We demonstrated an enhanced surface plasmon resonance (SPR) detection by incorporating a nanoporous gold film on a thin gold substrate. Nanoscale control of thickness and roughness of the nanoporous layer was successfully accomplished by oblique angle deposition. In biosensing experiments, the results obtained by biotin-streptavidin interaction showed that SPR samples with a nanoporous gold layer provided a notable sensitivity improvement compared to a conventional bare gold film, which is attributed to an excitation of local plasmon field and an increased surface reaction area.

Plasmonic metal-dielectric-metal stack structure with subwavelength metallic gratings for improving sensor sensitivity and signal quality.

In this study, we investigated the performance improvement of a localized surface plasmon resonance (LSPR) biosensor by incorporating a metal-dielectric-metal (MDM) stack structure and subwavelength metallic nanograting. The numerical results showed that the LSPR substrate with a MDM stack can provide not only a better sensitivity by more than five times but also a notably improved signal quality. While the gold nanogratings on a gold film inevitably lead to a broad and shallow reflectance curve, the presence of a MDM stack can prevent propagating surface plasmons from interference by locally enhanced fields excited at the gold nanogratings, finally resulting in a strong and deep absorption band at resonance.

How to avoid a negative shift in reflection-type surface plasmon resonance biosensors with metallic nanostructures.

We experimentally demonstrate that introduction of a dielectric film can prevent the surface plasmon resonance (SPR) curve from being shifted to a smaller angle, called negative shift, which occurs unpredictably when metallic nanostructures deposited on a metal film are exposed to an adsorption of binding analytes. From parylene coating experiments, we find that the proposed reflection-type SPR system with a low refractive index MgF2 film and gold nanorods can provide an enhanced sensitivity by more than 6 times as well as a reliable positive shift. It is due to the fact that use of a dielectric film can contribute to the compensation of an anomalous dispersion relation and the prevention of a destructive interaction of propagating surface plasmons with multiple localized plasmon modes.

Development of a large-area plasmonic sensor substrate with dielectric subwavelength gratings using nanoimprint lithography.

We demonstrated an enhanced surface plasmon resonance (SPR) detection by incorporating subwavelength SiO2 gratings built on a thin silver film. Large-area SiO2 gratings were fabricated by nanoimprint lithographic technique and dry etching processes and used to sense a surface-limited biomolecular interaction. Numerical results based on rigorous coupled-wave analysis method exhibited that the dielectric gratings can provide a notable sensitivity improvement by 2 times, which is attributed to an increase in surface reaction area.

Enhancement of field-analyte interaction at metallic nanogap arrays for sensitive localized surface plasmon resonance detection.

We investigated the near-field enhancement of a localized surface plasmon resonance (LSPR) structure based on gold nanograting pairs with a nanosized gap. The results calculated by finite-difference time-domain and rigorous coupled-wave analysis methods presented that the nanogap enclosed by two neighboring nanogratings produced significant confinement and enhancement of electromagnetic fields and allowed a sensitive detection in sensing of surface binding events. Gold gratings with a narrow gap distance less than 10 nm showed enhanced refractive index sensitivity due to the intensified optical field at the nanogap, outperforming the LSPR structure with noninteracting nanogratings.

Plasmonic wavelength splitter based on a large-area dielectric grating and white light illumination.

An optical process by which transmission wavelengths can be divided selectively by changing a resonance condition of surface plasmons (SPs) is demonstrated. When white light is incident to an SP resonance substrate with a dielectric grating, SP waves are excited at resonance and transmitted into the air via diffraction by a large-area grating pattern fabricated by nanoimprint lithography. While only a limited range of certain wavelengths is allowed to transmit, the peak transmission wavelength can be tuned continuously in the visible band.

Numerical study on an application of subwavelength dielectric gratings for high-sensitivity plasmonic detection.

Although subwavelength dielectric gratings can be employed to achieve a high sensitivity of the surface plasmon resonance (SPR) biosensor, the plasmonic interpretation verifying the resulting sensitivity improvement remains unclear. The aim of this study is to elucidate the effects of the grating's geometric parameters on the amplification of SPR responses and to understand the physical mechanisms associated with the enhancement. Our numerical results show that the proposed SPR substrate with a dielectric grating can provide a better sensitivity due to the combined effects of surface reaction area and field distribution at the binding region.