Structural and compositional dependence of the CdTexSe1-x alloy layer photoactivity in CdTe-based solar cells.

The published external quantum efficiency data of the world-record CdTe solar cell suggests that the device uses bandgap engineering, most likely with a CdTexSe1-x alloy layer to increase the short-circuit current and overall device efficiency. Here atom probe tomography, transmission electron microscopy and electron beam-induced current are used to clarify the dependence of Se content on the photoactive properties of CdTexSe1-x alloy layers in bandgap-graded CdTe solar cells. Four solar cells were prepared with 50, 100, 200 and 400 nm-thick CdSe layers to reveal the formation, growth, composition, structure and photoactivity of the CdTexSe1-x alloy with respect to the degree of Se diffusion.

APT mass spectrometry and SEM data for CdTe solar cells.

Atom probe tomography (APT) data acquired from a CAMECA LEAP 4000 XHR for the CdS/CdTe interface for a non-CdCl treated CdTe solar cell as well as the mass spectrum of an APT data set including a GB in a CdCl-treated CdTe solar cell are presented. Scanning electron microscopy (SEM) data showing the evolution of sample preparation for APT and scanning transmission electron microscopy (STEM) electron beam induced current (EBIC) are also presented. These data show mass spectrometry peak decomposition of Cu and Te within an APT dataset, the CdS/CdTe interface of an untreated CdTe solar cell, preparation of APT needles from the CdS/CdTe interface in superstrate grown CdTe solar cells, and the preparation of a cross-sectional STEM EBIC sample.

Characterization of Sputtered CdTe Thin Films with Electron Backscatter Diffraction and Correlation with Device Performance.

The performance of polycrystalline CdTe photovoltaic thin films is expected to depend on the grain boundary density and corresponding grain size of the film microstructure. However, the electrical performance of grain boundaries within these films is not well understood, and can be beneficial, harmful, or neutral in terms of film performance. Electron backscatter diffraction has been used to characterize the grain size, grain boundary structure, and crystallographic texture of sputtered CdTe at varying deposition pressures before and after CdCl2 treatment in order to correlate performance with microstructure.

Grain-boundary-enhanced carrier collection in CdTe solar cells.

When CdTe solar cells are doped with Cl, the grain boundaries no longer act as recombination centers but actively contribute to carrier collection efficiency. The physical origin of this remarkable effect has been determined through a combination of aberration-corrected scanning transmission electron microscopy, electron energy loss spectroscopy, and first-principles theory. Cl substitutes for a large proportion of the Te atoms within a few unit cells of the grain boundaries.

Carrier separation at dislocation pairs in CdTe.

Through the use of aberration corrected scanning transmission electron microscopy, the atomic configuration of CdTe intragrain Shockley partial dislocation pairs has been determined: Single Cd and Te columns are present at opposite ends of both intrinsic and extrinsic stacking faults. These columns have threefold and fivefold coordination, indicating the presence of dangling bonds. Counterintuitively, density-functional theory calculations show that these dislocation cores do not act as recombination centers; instead, they lead to local band bending that separates electrons and holes and reduces undesirable carrier recombination.