Technical Note: Scanning of parallel-plate ionization chamber and diamond detector for measurements of water-dose profiles in the vicinity of a narrow x-ray microbeam.

Purpose: Scanning of dosimeters facilitates dose distribution measurements with fine spatial resolutions. This paper presents a method of conversion of the scanning results to water-dose profiles and provides an experimental verification.

Methods: An Advanced Markus chamber and a diamond detector were scanned at a resolution of 6 μm near the beam edges during irradiation with a 25-μm-wide white narrow x-ray beam from a synchrotron radiation source.

Photon source term after single collision in targets of silicon, copper and lead for 50-500 keV X-ray beams.

Single-scattered X-ray doses at 1 m from silicon, copper and lead targets were calculated using an analytical point-kernel method considering the self-absorption, and the calculated values were compared with detailed results of a Monte Carlo calculation with respect to the emission angle. In the calculations, a slab slanted at 3° to the beam axis was used for silicon in addition to the cylindrical targets for the three materials, and the slab geometry showed the largest doses. The analytical calculations were underestimated compared with the Monte Carlo calculations by less than 24% for silicon and 40% for copper, particularly at large-angle scattering, which was attributable to the buildup effect of the single-scattered X-rays in the targets.

Optimization of X-ray microplanar beam radiation therapy for deep-seated tumors by a simulation study.

A Monte Carlo simulation was applied to study the energy dependence on the transverse dose distribution of microplanar beam radiation therapy (MRT) for deep-seated tumors. The distribution was found to be the peak (in-beam) dose and the decay from the edge of the beam down to the valley. The area below the same valley dose level (valley region) was decreased with the increase in the energy of X-rays at the same beam separation.

New soft X-ray beamline BL07LSU at SPring-8.

A new soft X-ray beamline, BL07LSU, has been constructed at SPring-8 to perform advanced soft X-ray spectroscopy for materials science. The beamline is designed to achieve high energy resolution (E/ΔE> 10000) and high photon flux [>10(12) photons s(-1) (0.01% bandwidth)(-1)] in the photon energy range 250-2000 eV with controllable polarization.