Electric Resistance of Elastic Strain Sensors-Fundamental Mechanisms and Experimental Validation.

Elastic strain sensor nanocomposites are emerging materials of high scientific and commercial interest. This study analyzes the major factors influencing the electrical behavior of elastic strain sensor nanocomposites. The sensor mechanisms were described for nanocomposites with conductive nanofillers, either dispersed inside the polymer matrix or coated onto the polymer surface.

Biofabrication and Characterization of Alginate Dialdehyde-Gelatin Microcapsules Incorporating Bioactive Glass for Cell Delivery Application.

The effect of the incorporation of 45S5 bioactive glass (BG) microparticles (mean particle size ≈ 2 µm) on the fabrication and physicochemical properties of alginate dialdehyde-gelatin hydrogel capsules is investigated. The addition of BG particles decreases the hydrogel gelation time by ≈79% and 91% for the samples containing 0.1% w/v and 0.

Biocompatible, Flexible Strain Sensor Fabricated with Polydopamine-Coated Nanocomposites of Nitrile Rubber and Carbon Black.

A flexible, biocompatible, nitrile butadiene rubber (NBR)-based strain sensor with high stretchability, good sensitivity, and excellent repeatability is presented for the first time. Carbon black (CB) particles were embedded into an NBR matrix via a dissolving-coating technique, and the obtained NBR/CB composite was coated with polydopamine (PDA) to preserve the CB layer. The mechanical properties of the NBR films were found to be significantly improved with the addition of CB and PDA, and the produced composite films were noncytotoxic and highly biocompatible.

Electrical conductivity of anisotropic PMMA composite filaments with aligned carbon fibers - predicting the influence of measurement direction.

In order to study the electrical conductivity of anisotropic PMMA/carbon fiber (CF) composites, cylindrical PMMA/CF filaments were extruded through a capillary rheometer, resulting in an induced CF orientation along the extrusion direction. The aspect ratios of the CFs in the filaments were accurately regulated using a two-step melt mixing process. By measuring the vertical and horizontal resistances of filaments where the outermost layer was successively peeled off, the anisotropic conductivities could be calculated.

Novel definition of the synergistic effect between carbon nanotubes and carbon black for electrical conductivity.

Anisotropic ternary composites comprising poly(methy-methacrylate) (PMMA), carbon black (CB), and carbon nanotubes (CNTs) were extruded using a capillary rheometer and the electrical conductivities of the composites were measured and presented in a detailed contour plot covering a large range of filler fractions (up to 30 vol% CNTs, 20 vol% CB). A recent generic conductivity model for ternary composites was successfully validated using the conductivity measurements. When analyzing the conductivity measurements using four traditional definitions of 'synergy' between two conductive fillers, no clear synergetic effect was observed between CB and CNT.