Influence of Microstructure and Alloy Composition on the Machinability of α/β Titanium Alloys.

A comparative study was conducted for the machining of two α/β titanium alloys, namely Ti-6Al-4V (Ti64) and Ti-6Al-7Nb (Ti67), using wire electric discharge machining (WEDM). The influence of cutting speed and cutting mode on the machined surfaces in terms of surface roughness (Ra), recast layer (RL), and micro-hardness have been evaluated. Rough cut (RC) mode at a cutting speed of 50 µm/s resulted in thermal damage; Ra was equal to 5.

Elution of TEGDMA and HEMA from polymerized resin-based bonding systems.

Objectives: In this study the amount of TEGDMA and HEMA eluted from several adhesive systems was quantified.

Methods: The adhesive systems were applied according to manufacturers' instructions in an analytic vial. The adhesive systems used were (abbreviation and producer in parenthesis): cmf adhesive system(®) (CMF) (Saremco), ENAbond (EB) (Micerium), Optibond FL (OB) (Kerr), Adper Scotchbond Multi-Purpose (SB) (3M ESPE), Silorane System Adhesive (SSA) (3M ESPE), Syntac Classic (SC) (Ivoclar Vivadent) and XP Bond (XPB) (Dentsply).