Eco-friendly and strong lignin-containing microfibrillated cellulose films for high-performance separators of aqueous zinc batteries.

Aqueous zinc-ion batteries have gained significant interest, offering several distinct advantages over conventional lithium-ion batteries owing to their compelling low cost, enhanced battery safety, and excellent environmental friendliness. Nevertheless, the unfortunate growth of zinc dendrites during cycling leads to poor electrochemical performance of zinc batteries, primarily attributed to the diminished wet mechanical properties and limited electrolyte uptake of existing commercial separators. Herein, a bio-based separator was developed from sustainable resources using natural polymers derived from wood pulp to replace fossil-based polyolefin separators.

Fundamental Insights on the Physical and Chemical Properties of Organosolv Lignin from Norway Spruce Bark.

The interest in the bark and the attempt to add value to its utilization have increased over the last decade. By applying an integrated bark biorefinery approach, it is possible to investigate the recovery of compounds that can be used to develop green and sustainable alternatives to fossil-based materials. In this work, the focus is on extracting Norway spruce () bark lignin via organosolv extraction.

A modified ionization difference UV-vis method for fast quantitation of guaiacyl-type phenolic hydroxyl groups in lignin.

An ionization difference UV-Vis method (Δε-spectrum method) is the most potentially simple method for fast quantitation of phenolic hydroxyl groups (ph-OH) in lignin. However, the underestimated results were calculated from the conventional Δε-spectrum method using one- or two-point wavelengths measurement. In this study, a modified Δε-spectrum method using multi-point wavelengths measurement was developed and the negative absorbance was also considered.

Macromolecular Model of the Pectic Polysaccharides Isolated from the Bark of Norway Spruce ().

The bark of Norway spruce () contains up to 13% pectins that can be extracted by pressurized hot water, which constitute a valuable renewable resource in second-generation lignocellulosic biorefineries. This article proposes, for the first time, structural molecular models for the pectins present in spruce bark. Pectin fractions of tailored molar masses were obtained by fractionation of the pressurized hot water extract of the inner bark using preparative size-exclusion chromatography.

Hydrophobization of cellulose oxalate using oleic acid in a catalyst-free esterification suitable for preparing reinforcement in polymeric composites.

It is common practice to use cellulose as reinforcement and fatty acid as compatibilizer in the preparation of polymeric composites. However, the used catalysts (e.g.

Bactericidal surfaces prepared by femtosecond laser patterning and layer-by-layer polyelectrolyte coating.

Antimicrobial surfaces are important in medical, clinical, and industrial applications, where bacterial infection and biofouling may constitute a serious threat to human health. Conventional approaches against bacteria involve coating the surface with antibiotics, cytotoxic polymers, or metal particles. However, these types of functionalization have a limited lifetime and pose concerns in terms of leaching and degradation of the coating.

In Situ Preparation of Silver Nanoparticles in Paper by Reduction with Alkaline Glucose Solutions.

Percolation of contaminated water through paper sheets containing silver nanoparticles is a promising way to provide emergency drinking water. The silver nanoparticles are deposited by the in situ reduction of silver nitrate on the cellulose fibers of an absorbent blotting paper sheet. Sodium borohydride has been used as the reductant but is toxic and expensive.

Influence of Cellulose Charge on Bacteria Adhesion and Viability to PVAm/CNF/PVAm-Modified Cellulose Model Surfaces.

A contact-active antibacterial approach based on the physical adsorption of a cationic polyelectrolyte onto the surface of a cellulose material is today regarded as an environment-friendly way of creating antibacterial surfaces and materials. In this approach, the electrostatic charge of the treated surfaces is considered to be an important factor for the level of bacteria adsorption and deactivation/killing of the bacteria. In order to clarify the influence of surface charge density of the cellulose on bacteria adsorption as well as on their viability, bacteria were adsorbed onto cellulose model surfaces, which were modified by physically adsorbed cationic polyelectrolytes to create surfaces with different positive charge densities.

Preparation of cellulose nanomaterials via cellulose oxalates.

Nanocellulose prepared from cellulose oxalate has been discussed as an alternative to other methods to prepare cellulose nanofibrils or crystals. The current work describes the use of a bulk reaction between pulp and oxalic acid dihydrate to prepare cellulose oxalate followed by homogenization to produce nanocellulose. The prepared nanocellulose is on average 350 nm long and 3-4 nm wide, with particles of size and shape similar to both cellulose nanofibrils and cellulose nanocrystals.

Changes in chemical structures of wheat straw auto-hydrolysis lignin by 3-hydroxyanthranilic acid as a laccase mediator.

3-Hydroxyanthranilic acid (3-HAA), as a potential natural laccase mediator, was shown to mediate the oxidation of non-phenolic lignin subunits. The problem of cost and toxicity of artificial mediators could be solved to some extent by a further study about the detailed changes of lignin chemistry structures in laccase 3-HAA system (LHS). In this work, wheat straw auto-hydrolysis lignin (AL) was prepared.

Water Purification Using Functionalized Cellulosic Fibers with Nonleaching Bacteria Adsorbing Properties.

Portable purification systems are easy ways to obtain clean drinking water when there is no large-scale water treatment available. In this study, the potential to purify water using bacteria adsorbing cellulosic fibers, functionalized with polyelectrolytes according to the layer-by-layer method, is investigated. The adsorbed polyelectrolytes create a positive charge on the fiber surface that physically attracts and bonds with bacteria.

Bacterial adhesion to polyvinylamine-modified nanocellulose films.

Cellulose nanofibril (CNF) materials have been widely studied in recent years and are suggested for a wide range of applications, e.g., medical and hygiene products.

Contact-active antibacterial aerogels from cellulose nanofibrils.

The use of cellulose aerogels as antibacterial materials has been investigated by applying a contact-active layer-by-layer modification to the aerogel surface. Studying the adsorption of multilayers of polyvinylamine (PVAm) and polyacrylic acid to aerogels comprising crosslinked cellulose nanofibrils and monitoring the subsequent bacterial adhesion revealed that up to 26mgPVAmgaerogel(-1) was adsorbed without noticeably affecting the aerogel structure. The antibacterial effect was tested by measuring the reduction of viable bacteria in solution when the aerogels were present.

Cellulose Nanocrystals from Forest Residues as Reinforcing Agents for Composites: A Study from Macro- to Nano-Dimensions.

This study investigates for the first time the feasibility of extracting cellulose nanocrystals (CNCs) from softwood forestry logging residues (woody chips, branches and pine needles), with an obtained gravimetric yield of over 13%. Compared with the other residues, woody chips rendered a higher yield of bleached cellulosic fibers with higher hemicellulose, pectin and lignin content, longer diameter, and lower crystallinity and thermal stability. The isolation of CNCs from these bleached cellulosic fibers was verified by the removal of most of their amorphous components, the increase in the crystallinity index, and the nano-dimensions of the individual crystals.

Bioinspired composites from cross-linked galactoglucomannan and microfibrillated cellulose: Thermal, mechanical and oxygen barrier properties.

In this study, new wood-inspired films were developed from microfibrillated cellulose and galactoglucomannan-lignin networks isolated from chemothermomechanical pulping side streams and cross-linked using laccase enzymes. To the best of our knowledge, this is the first time that cross-linked galactoglucomannan-lignin networks have been used for the potential development of composite films inspired by woody-cell wall formation. Their capability as polymeric matrices was assessed based on thermal, structural, mechanical and oxygen permeability analyses.

Thermal degradation behavior and kinetic analysis of spruce glucomannan and its methylated derivatives.

The thermal degradation behavior and kinetics of spruce glucomannan (SGM) and its methylated derivatives were investigated using thermogravimetric analysis to characterize its temperature-dependent changes for use in specific applications. The results were compared with those obtained for commercial konjac glucomannan (KGM). The SGM and the KGM exhibited two overlapping peaks from 200 to 375°C, which correspond to the intensive devolatilization of more than 59% of the total weight.

Hot-water extracts from the inner bark of Norway spruce with immunomodulating activities.

The inner bark of Norway spruce (Picea abies) was sequentially extracted with hot water at 100°C, 140°C and 160°C. The hot-water extracts (IB 100°C, IB 140°C and IB 160°C) contained pectic polysaccharides and showed immunostimulating activities. Structural analyses of their carbohydrate content, including glycosidic linkage analyses, revealed the presence of pectins with a large rhamnogalacturonan RG-I domain ramified with highly-branched arabinans.

Bacterial-growth inhibiting properties of multilayers formed with modified polyvinylamine.

New methods are needed to fight antibiotic-resistant bacteria. One alternative that has been proposed is non-leaching, permanently antibacterial surfaces. In this study, we test multilayers formed with antibacterial cationic polyvinylamine (PVAm) and polyacrylic acid (PAA) in a growth-inhibition assay.

Combination of alkaline and enzymatic treatments as a process for upgrading sisal paper-grade pulp to dissolving-grade pulp.

A sequence of treatments consisting of an initial xylanase treatment followed by cold alkaline extraction and a final endoglucanase treatment was investigated as a process for upgrading non-wood paper-grade pulps to dissolving-grade pulps for viscose production. Five commercial dried bleached non-wood soda/AQ paper pulps, from flax, hemp, sisal, abaca, and jute, were studied for this purpose. Commercial dried bleached eucalyptus dissolving pulp was used as reference sample.

Interactions of hydrophobically modified polyvinylamines: adsorption behavior at charged surfaces and the formation of polyelectrolyte multilayers with polyacrylic acid.

The structure and adsorption behaviors of two types of hydrophobically modified polyvinylamines (PVAm) containing substituents of hexyl and octyl chains were compared to a native polyvinylamine sample. The conformation of dissolved polyvinylamines was studied in aqueous salt solutions using dynamic light scattering. Modified PVAm showed hydrodynamic diameters similar to native PVAm, which indicated that all PVAm polymers were present as single molecules in solution.

CYP3A4 catalytic activity is induced in confluent Huh7 hepatoma cells.

Drug-induced hepatotoxicity is an important cause for disapproval, limitations of use, or withdrawal of drugs, and there is a high need for reproducible in vitro systems that can predict such toxicity. In this study, we show that confluent growth of the human hepatoma cell line Huh7 up to 5 weeks results in increased gene expression of several cytochromes P450 (P450s), UDP-glucuronosyltransferases, transporters, transcription factors, and several liver-specific genes, as measured by low-density array. The most striking effect was seen for CYP3A4 expression.

Hepatocyte-like cells derived from human embryonic stem cells specifically via definitive endoderm and a progenitor stage.

Human embryonic stem cells offer a potential unlimited supply for functional hepatocytes, since they can differentiate into hepatocyte-like cells displaying a characteristic hepatic morphology and expressing various hepatic markers. These cells could be used in various applications such as studies of drug metabolism and hepatotoxicity, which however, would require a significant expression of drug metabolizing enzymes. To derive these cells we use a stepwise differentiation protocol where growth- and maturation factors are added.

Characterization and engraftment of long-term serum-free human fetal liver cell cultures.

Background Aims: Cultured human hepatocytes have extensive diagnostic and clinical applications. However, the setting-up of new in vitro culture techniques allowing the long-term survival and functional maintenance of adult human hepatocytes represents a formidable challenge. Fetal liver cells (FLC) are attractive candidate donor cells because of their high proliferative capacity.

Increased sensitivity for troglitazone-induced cytotoxicity using a human in vitro co-culture model.

Drug-induced hepatotoxicity is a major reason for withdrawal of drugs from development as well as from the market. A major problem predicting hepatotoxicity is the lack of suitable predictive in vitro system. Drug-induced hepatotoxicity is usually associated with the recruitment of immune cells to the liver accelerating an inflammatory response often initiated by activation of the Kupffer cells.