Fabrication and Deformation of 3D Multilayered Kirigami Microstructures.

Mechanically guided 3D microassembly with controlled compressive buckling represents a promising emerging route to 3D mesostructures in a broad range of advanced materials, including single-crystalline silicon (Si), of direct relevance to microelectronic devices. During practical applications, the assembled 3D mesostructures and microdevices usually undergo external mechanical loading such as out-of-plane compression, which can induce damage in or failure of the structures/devices. Here, the mechanical responses of a few mechanically assembled 3D kirigami mesostructures under flat-punch compression are studied through combined experiment and finite element analyses.

Fast Self-Healing of Polyelectrolyte Multilayer Nanocoating and Restoration of Super Oxygen Barrier.

A self-healable gas barrier nanocoating, which is fabricated by alternate deposition of polyethyleneimine (PEI) and polyacrylic acid (PAA) polyelectrolytes, is demonstrated in this study. This multilayer film, with high elastic modulus, high glass transition temperature, and small free volume, has been shown to be a super oxygen gas barrier. An 8-bilayer PEI/PAA multilayer assembly (≈700 nm thick) exhibits an oxygen transmission rate (OTR) undetectable to commercial instrumentation (<0.

Influence of Graphene Reduction and Polymer Cross-Linking on Improving the Interfacial Properties of Multilayer Thin Films.

Graphene is a versatile composite reinforcement candidate due to its strong mechanical, tunable electrical and optical properties, and chemical stability. However, one drawback is the weak interfacial bonding, which results in weak adhesion to substrates. This could be overcome by adding polymer layers to have stronger adherence to the substrate and between graphene sheets.

Nanomechanical Behavior of High Gas Barrier Multilayer Thin Films.

Nanoindentation and nanoscratch experiments were performed on thin multilayer films manufactured using the layer-by-layer (LbL) assembly technique. These films are known to exhibit high gas barrier, but little is known about their durability, which is an important feature for various packaging applications (e.g.

Ultrastrong, Chemically Resistant Reduced Graphene Oxide-based Multilayer Thin Films with Damage Detection Capability.

Multilayer thin films of graphene oxide (GO) and poly(vinylamine) (PVAm) were deposited via layer-by-layer assembly. Poly(vinylamine) pH was used to tailor film thickness and GO layer spacing. Graphene oxide concentration in the films was controlled through simple pH adjustment.