350 mJ electro-optically Q-switched 2.79 µm Cr:Er:YSGG MOPA.

We report on developing three flashlamp-pumped electro-optically Q-switched Cr:Er:YSGG lasers with the Q-switch based on a LaGaSiO crystal. The "short" laser cavity was optimized for high peak power applications. In this cavity, 300 mJ output energy in 15 ns pulses at a 3 Hz repetition rate was demonstrated with pump energy below 52 J.

Spectral narrowing and broadening of Cr:ZnS/Se laser oscillation due to mode competition and spatial hole burning in the gain element.

In this paper, we demonstrate the laser characterization of Cr:ZnS/Se polycrystalline gain media in non-selective unpolarized, linearly polarized, and twisted mode cavities. Lasers were based on post-growth diffusion-doped, commercially available antireflective-coated Cr:ZnSe and Cr:ZnS polycrystals with a length of 9 mm. The spectral output of lasers based on these gain elements in non-selective unpolarized and linearly polarized cavities was measured to be broadened to ∼20-50 nm due to the spatial hole burning (SHB) effect.

Longwave infrared (6.6-11.4 µm) dual-comb spectroscopy with 240,000 comb-mode-resolved data points at video rate.

Using sub-3-cycle pulses from mode-locked Cr:ZnS lasers at λ ≈ 2.4 µm as a driving source, we performed high-resolution dual-frequency-comb spectroscopy in the longwave infrared (LWIR) range. A duo of highly coherent broadband (6.

Feature issue introduction: advanced solid-state lasers.

This joint issue of Optics Express and Optical Materials Express features 36 state-of-the art articles written by authors who participated in the international conference advanced solid state lasers held online from October 3-7, 2021. This review provides a summary of these articles covering a wide spectrum of topics around solid-state lasers from materials research to sources and from design innovation to applications.

Lasing in 15 atm CO cell optically pumped by a Fe:ZnSe laser.

10 µm lasing is studied in a compact CO-He cell pressurized up to 15 atm when optically pumped by a ∼50 mJ Fe:ZnSe laser tunable around 4.3 µm. The optimal pump wavelength and partial pressure of CO for generating 10 µm pulses are found to be ∼4.

Focus issue introduction: Advanced Solid-State Lasers 2020.

This Joint Issue of Optics Express and Optical Materials Express features 15 articles written by authors who participated in the international online conference Advanced Solid State Lasers held 13-16 October, 2020. This review provides a summary of the conference and these articles from the conference which sample the spectrum of solid state laser theory and experiment, from materials research to sources and from design innovation to applications.

High energy (0.8 J) mechanically Q-switched 2.94 μm Er:YAG laser.

We report a flashlamp pumped mechanically Q-switched (MQS) 2.94 μm Er:YAG laser based on a spinning mirror with a highest output energy of 805 mJ at a pulse duration of 61 ns and 13 MW of peak power at 1 Hz repetition rate. This record output energy was achieved with the use of 300 mm long MQS Er:YAG laser cavity consisting of a 70% output coupler, 7 × 120 mm AR coated Er(50%):YAG crystal, and 4200 rad/s angular speed of the spinning mirror.

Kerr-lens mode-locked Cr:ZnS oscillator reaches the spectral span of an optical octave.

We report, to the best of our knowledge, the first super-octave femtosecond polycrystalline Cr:ZnS laser at the central wavelength 2.4 µm. The laser is based on a non-polarizing astigmatic X-folded resonator with normal incidence mounting of the gain element.

Room temperature, nanosecond, 60 mJ/pulse Fe:ZnSe master oscillator power amplifier system operating at 3.8-5.0 µm.

We report on a RT gain-switched Fe:ZnSe master oscillator power amplifier (MOPA) system tunable over 3.8-5.0 µm pumped by radiation of Er:YAG laser operating at 2.

Two-octave-wide (3-12 µm) subharmonic produced in a minimally dispersive optical parametric oscillator cavity.

We report a subharmonic (frequency-divide-by-2) optical parametric oscillator (OPO) with a continuous wavelength span of 3 to 12 µm (-37 level) that covers most of the molecular rovibrational "signature" region. The key to obtaining such a wide spectral span is the use of an OPO with a minimal dispersion-through the choice of intracavity elements, the use of all gold-coated mirrors, and a special "injector" mirror. The system delivers up to 245 mW of the average power with the conversion efficiency exceeding 20% from a 2.

Octave-spanning mid-infrared femtosecond OPA in a ZnGeP pumped by a 2.4 μm Cr:ZnSe chirped-pulse amplifier.

We report on the highly efficient, octave-spanning mid-infrared (mid-IR) optical parametric amplification (OPA) in a ZnGeP (ZGP) crystal, pumped by a 1 kHz, 2.4 μm, 250 fs Cr:ZnSe chirped-pulse amplifier. The full spectral coverage of 3-10 μm with the amplified signal and idler beams is demonstrated.

Advanced Solid-State Lasers 2019: focus issue introduction.

This joint issue of Optics Express and Optical Materials Express features 17 state-of-the art articles written by authors who participated in the international conference Advanced Solid-State Lasers held in Vienna, Austria, from September 29 to October 3, 2019. This introduction provides a summary of these articles that cover numerous areas of solid-state lasers from materials research to sources and from design to experimental demonstration.

Middle-IR frequency comb based on Cr:ZnS laser.

We report, to the best of our knowledge, the first fully referenced Cr:ZnS optical frequency comb. The comb features few cycle output pulses with 3.25 W average power at 80 MHz repetition rate, spectrum spanning 60 THz in the middle-IR range 1.

Focus issue introduction: advanced solid-state lasers.

This joint issue of Optics Express and Optical Materials Express features 28 state-of-the-art articles written by authors who participated in the international "Advanced Solid State Lasers" conference, held in Boston November 4-8, 2018. This review provides a summary of these articles that cover the spectrum of solid state lasers from materials research to sources and from design innovation to applications.

Q-switched and gain-switched Fe:ZnSe lasers tunable over 3.60-5.15 µm.

We report on room temperature gain-switched and Q-switched Fe:ZnSe lasers tunable over 3.60-5.15 µm pumped by radiation of an 2.

Multi-octave visible to long-wave IR femtosecond continuum generated in Cr:ZnS-GaSe tandem.

We report a technique for generation of broad and coherent femtosecond (fs) continua that span several octaves from visible to long-wave IR parts of the spectrum (0.4-18 µm). The approach is based on simultaneous amplification of few-cycle pulses at 2.

Vimentin intermediate filament assembly regulates fibroblast invasion in fibrogenic lung injury.

Idiopathic pulmonary fibrosis (IPF) is a progressive disease, with a median survival of 3-5 years following diagnosis. Lung remodeling by invasive fibroblasts is a hallmark of IPF. In this study, we demonstrate that inhibition of vimentin intermediate filaments (VimIFs) decreases the invasiveness of IPF fibroblasts and confers protection against fibrosis in a murine model of experimental lung injury.

Feature issue introduction: Advanced Solid-State Lasers 2017.

The Advanced Solid State Lasers 2017 Conference (ASSL) was held from October 1 to 5, 2017. It was an extraordinary conference at the Nagoya Congress Center in Nagoya, Japan. ASSL 2017 again suggested an impressive platform where miscellaneous perceptions with a variety of approaches to optics, photonics, sensing, laser technology, laser systems, and solid state lasers were presented.

High power single-mode delivery of mid-infrared sources through chalcogenide fiber.

Mechanically robust and low loss single-mode arsenic sulfide fibers are used to deliver high power mid-infrared sources. Anti-reflection coatings were deposited on the fiber facets, enabling 90% transmission through 20 cm length fibers. 10.

Low-dose cadmium exposure induces peribronchiolar fibrosis through site-specific phosphorylation of vimentin.

Exposure to cadmium (Cd) has been associated with development of chronic obstructive lung disease (COPD). The mechanisms and signaling pathways whereby Cd causes pathological peribronchiolar fibrosis, airway remodeling, and subsequent airflow obstruction remain unclear. We aimed to evaluate whether low-dose Cd exposure induces vimentin phosphorylation and Yes-associated protein 1 (YAP1) activation leading to peribronchiolar fibrosis and subsequent airway remodeling.

140 W Cr:ZnSe laser system.

We report a significant breakthrough in the development of fiber-pumped high-power CW laser systems based on Cr:ZnS and Cr:ZnSe gain media. We demonstrate output power levels of up to 140 W near 2500 nm, and 32 W at 2940 nm with corresponding optical efficiencies of 62% and 29%. Our novel approach is based on rapid simultaneous scanning of the collinear laser mode and pump beam across the Cr:ZnS/Se gain element which allows us to virtually eliminate thermal lensing effects and obtain unprecedented levels of output power with very high optical-to-optical efficiency.

Mid-IR spectroscopy of Fe:ZnSe quantum dots.

We report spectroscopic characterization of Fe:ZnSe quantum dots (for 2% of Zn/Fe molar ratio) fabricated by microemulsion hydrothermal synthesis. Mid-IR photoluminescence of the E↔T transition of Fe ions over 3.5-4.

Multi-Watt mid-IR femtosecond polycrystalline Cr(2+):ZnS and Cr(2+):ZnSe laser amplifiers with the spectrum spanning 2.0-2.6 µm.

We demonstrate efficient amplification of few-optical-cycle mid-IR pulses in single-pass continuously pumped laser amplifiers based on polycrystalline Cr(2+):ZnS and Cr(2+):ZnSe. The 1.7 W output of a Kerr-lens mode-locked master oscillator at 2.

Cr:ZnS laser-pumped subharmonic GaAs optical parametric oscillator with the spectrum spanning 3.6-5.6 μm.

Using a subharmonic optical parametric oscillator (OPO) based on orientation-patterned GaAs, we produced a broadband instantaneous output that spans 3.6-5.6 μm at 50-dB level (4.