Nano-Cr-film-based solar selective absorber with high photo-thermal conversion efficiency and good thermal stability.

Optical properties and thermal stability of the solar selective absorber based on the metal/dielectric four-layer film structure were investigated in the variable temperature region. Numerical calculations were performed to simulate the spectral properties of multilayer stacks with different metal materials and film thickness. The typical four-layer film structure using the transition metal Cr as the thin solar absorbing layer [SiO(2)(90nm)/Cr(10nm)/SiO(2)(80nm)/Al (≥100nm)] was fabricated on the Si or K9 glass substrate by using the magnetron sputtering method.

A solar photovoltaic system with ideal efficiency close to the theoretical limit.

In order to overcome some physical limits, a solar system consisting of five single-junction photocells with four optical filters is studied. The four filters divide the solar spectrum into five spectral regions. Each single-junction photocell with the highest photovoltaic efficiency in a narrower spectral region is chosen to optimally fit into the bandwidth of that spectral region.

Lateral shift effect on the spatial interference of light wave propagating in the single-layered dielectric film.

Under the oblique incidence condition, the multiple reflection of wave packets in a layered film structure will have a lateral shift increasing with the film thickness. In the analysis of the spatial interference with consideration of the lateral shift effect, a set of new analytic formulae to normalize the intensity of the s-and p-polarized wave packet was obtained to reduce the error of the ellipsometry parameters significantly as the optical path difference delta is close to mpi. The principle and method developed in this work also can be applied to other film structures in more general applications.

Spatial effect on the interference of light propagated in a film structure.

The interference of light has been analyzed for a film structure by considering that a spatial separation exists for the two neighboring light beams to be interfered in the space. There is a significant difference between the situations of the interference with or without consideration of the spatial effect, especially around the region where the phase delay delta=pi and 2pi by taking the example of the one-layered SiO2/Si structure. It is reasonable to extract the optical parameters by neglecting the spatial effect only for the thinner film with a thickness much smaller than a wavelength, which satisfies the condition that delta View Article and Find Full Text PDF