Charge Photogeneration and Recombination in Fluorine-Substituted Polymer Solar Cells.

In this contribution, we studied the effect of fluorine substitution on photogenerated charge generation, transport, and recombination in polymer solar cells. Two conjugated polymer materials, PBDTTT-E (fluorine free) and PTB7 (one fluorine substitution), were compared thoroughly. Meanwhile, various characterization techniques, including atomic force microscopy, steady-state spectroscopy, transient absorption spectroscopy, spectroelectrochemistry, and electrical measurements, were employed to analyse the correlation between molecular structure and device performance.

Morphology and carrier non-geminate recombination dynamics regulated by solvent additive in polymer/fullerene solar cells.

In this study, PBDTTT-E (based on benzo [1,2-b:4,5-b'] dithiophene (BDT) and thieno [3,4-b] thiophene (TT)) as a donor and fullerene derivative PCBM (phenyl-C-butyric acid methyl ester) as an acceptor with and without 1,8-diiodooctane (DIO)-treated copolymer solar cells were investigated. The device based on PBDTTT-E with treated DIO showed remarkably high current density ( ), fill factor (FF) and similar open-circuit voltage ( ). Charge carrier lifetime ( ), density () and non-geminate recombination rate ( ) in the photoactive layers were measured by employing transient photovoltage (TPV) and charge extraction (CE) techniques.

Enhanced Charge Transport in Conventional Polymer Solar Cells with a Perovskite-Type LaNiO Layer.

In this study, a novel metal oxide, lanthanum nickelate (LNO) with a perovskite structure, was introduced into a polymer solar cell (PSC) device, replacing the PEDOT:PSS hole transport layer (HTL). The results show that the LNO-based PTB7-Th:PCBM solar cell exhibits a higher circuit current density, power conversion efficiency, and stability compared with a device with PEDOT:PSS HTL. To understand the effect of LNO HTL on the performance of devices, the active layer morphology and charge transport characteristics in PSCs were systematically analyzed.

Working area effects on the energetic distribution of trap states and charge dynamics of dye-sensitized solar cells.

Measuring the transient photoelectric signals (photovoltage or photocurrent) after optically perturbing dye-sensitized solar cells (DSSCs) can provide information about electron transport and recombination. Herein, the energetic distribution of trap states in different working areas of DSSCs (0.16 cm 1 cm) and their impacts on charge transport and recombination were investigated by means of time-resolved charge extraction (TRCE), transient photovoltage (TPV) and transient photocurrent (TPC) measurements.

Acceptor Side-Chain Effects on the Excited State Dynamics of Two-Dimensional-Like Conjugated Copolymers in Solution.

Excited state dynamics of two-dimensional-like conjugated copolymers PFDCN and PFSDCN based on alternating fluorene and triphenylamine main chains and malononitrile pendant acceptor groups with thiophene as π-bridge, have been investigated by using transient absorption spectroscopy. There is an additional conjugated -C=C- bond in PFDCN, which distinguishes it from PFSDCN. The lowest energy absorption band of each copolymer absorption spectrum is attributed to the π-π* transition with intramolecular charge-transfer, which has a lower fluorescence contribution than those of higher energy absorption bands.

Impacts of side chain and excess energy on the charge photogeneration dynamics of low-bandgap copolymer-fullerene blends.

Primary charge photogeneration dynamics in neat and fullerene-blended films of a pair of alternating benzo[1,2-b:4,5-b(')]dithiophene (BDT) and thieno[3,4-b]thiophene (TT) copolymers are comparatively studied by using near-infrared, time-resolved absorption (TA) spectroscopy under low excitation photon fluence. PBDTTT-E and PBDTTT-C, differed merely in the respective TT-substituents of ester (-E) and carbonyl (-C), show distinctly different charge photogeneration dynamics. The pair of neat PBDTTT films show exciton lifetimes of ∼0.

Side-chain effects on the solution-phase conformations and charge photogeneration dynamics of low-bandgap copolymers.

Solution-phase conformations and charge photogeneration dynamics of a pair of low-bandgap copolymers based on benzo[1,2-b:4,5-b(')]dithiophene (BDT) and thieno[3,4-b]thiophene (TT), differed by the respective carbonyl (-C) and ester (-E) substituents at the TT units, were comparatively investigated by using near-infrared time-resolved absorption (TA) spectroscopy at 25 °C and 120 °C. Steady-state and TA spectroscopic results corroborated by quantum chemical analyses prove that both PBDTTT-C and PBDTTT-E in chlorobenzene solutions are self-aggregated; however, the former bears a relatively higher packing order. Specifically, PBDTTT-C aggregates with more π-π stacked domains, whereas PBDTTT-E does with more random coils interacting strongly at the chain intersections.

Subnanosecond charge recombination dynamics in P3HT/PC61BM films.

Ultrafast near-infrared absorption spectroscopy was used to investigate the influence of film morphology and excitation photon energy on the charge recombination (CR) dynamics in the initial nanosecond timescale in the P3HT/PC(61)BM blend films. With reference to the CS(2)-cast films, the solvent vapor annealed (SVA) ones show 2–3-fold improvement in hole mobility and more than 5-fold reduction in the polymer-localized trap states of holes. At Dt = 70 ps, the hole mobility (m(h)) and the bimolecular CR rate (γ(bi)) of the SVA films are μ(h) = 8.

Effect of end groups on the raman spectra of lycopene and β-carotene under high pressure.

The Raman spectra of all-trans-lycopene in n-hexane were measured under high pressure, and the results compared with those of β-carotene. The different pressure effects on Raman spectra are analyzed taking into account the different structures of lycopene and β-carotene molecules. It is concluded that: (a) the vibronic coupling between the S₁ and S₀ states of β-carotene is stronger than that of lycopene, (b) the diabatic frequency increment of the ν₁ mode is more susceptible to pressure than that of the ν₂ mode for lycopene, and (c) β-rings rotation can relieve the pressure effect on the C=C bond length in β-carotene.