Developing dynamic digital image techniques with continuous parameters to detect structural damage.

Several earthquakes with strong magnitude occurred globally at various locations, especially the unforgettable tsunami disaster caused by the earthquake in Indonesia and Japan. If the characteristics of structures can be well understood to implement new technology, the damages caused by most natural disasters can be significantly alleviated. In this research, dynamic digital image correlation method for using continuous parameter is applied for developing a low-cost digital image correlation coefficient method with advanced digital cameras and high-speed computers.

Time domain system identification of unknown initial conditions.

System identification is a method for using measured data to create or improve a mathematical model of the object being tested. From the measured data however, noise is noticed at the beginning of the response. One solution to avoid this noise problem is to skip the noisy data and then use the initial conditions as active parameters, to be found by using the system identification process.

Investigation of newly developed added damping and stiffness device with low yield strength steel.

Energy dissipators, isolated-resistant and specific structural forms for earthquake resistance are popular topics in the research to improve shock-resistance. In this work, experimental methods were used to investigate the property of low yield strength steel. Carbon content in LYS material is lower than that in other steels; the ultimate stress is three times the yield stress.

Analytical method for promoting process capability of shock absorption steel.

Mechanical properties and low cycle fatigue are two factors that must be considered in developing new type steel for shock absorption. Process capability and process control are significant factors in achieving the purpose of research and development programs. Often-used evaluation methods failed to measure process yield and process centering; so this paper uses Taguchi loss function as basis to establish an evaluation method and the steps for assessing the quality of mechanical properties and process control of an iron and steel manufacturer.