Publications by authors named "Min-Seong Yang"
J Adv Prosthodont
August 2022
Article Synopsis
- - The study aimed to evaluate how the build orientation (45° vs. 60°) and layer thickness (50 µm vs. 100 µm) impact the fit of three-unit resin prostheses created through stereolithography (SLA) printing.
- - Forty resin specimens were produced, and their fit was measured at various points, revealing that the fit was generally better at a 45° angle compared to a 60° angle, while layer thickness did not significantly influence fit.
- - The findings suggest that the area near the pontic had the largest gaps, emphasizing the importance of build orientation in achieving better overall fit, with a 45° orientation being the preferred choice.
