Fretting corrosion behavior of nitinol spinal rods in conjunction with titanium pedicle screws.

Untypical corrosion damage including erosions combined with the build-up of titanium oxide as a corrosion product on the surface of explanted Nitinol spinal rods in the areas where it was in contact with titanium pedicle screw head is reported. It was suggested that Nitinol rods might have inferior fretting corrosion resistance compared with that made of titanium or CoCr. Fretting corrosion of Nitinol spinal rods with titanium (Ti6Al4V) pedicle screws were tested in-vitro by conducting a series of potentiostatic measurements of the peak-to-peak values of fretting corrosion current under bending in a 10% solution of calf serum in PBS.

Metal concentrations in the blood and tissues after implantation of titanium growth guidance sliding instrumentation.

Background: Growth guidance sliding treatment devices, such as Shilla (Medtronic, Minneapolis, MN USA) or LSZ-4D (CONMET, Moscow, Russia), used for the treatment of scoliosis in children who have high growth potential have unlocked fixtures that allow rods to slide during growth of the spine, which avoids periodical extensions. However, the probability of clinical complications associated with metallosis after implantation of such devices is poorly understood. The content of metal ions in the blood and tissues of pediatric patients treated for scoliosis using fusionless growth guidance sliding instrumentation has not yet been investigated.

Analysis of retrieved growth guidance sliding LSZ-4D devices for early onset scoliosis and investigation of the use of nitinol rods for this system.

Study Design: Analysis of volumetric wear loss of retrieved growth guidance sliding devices LSZ-4D for treatment of early onset scoliosis and laboratory in vitro wear test for comparison of wear resistance of alloys Nitinol, Ti, and cobalt chromium (CoCr).

Objective: To evaluate quantitatively the amount of wear debris from the sliding LSZ-4D device and to investigate the potential of using Nitinol for replacing Ti alloys in spinal instrumentation. To do that, wear resistance of Nitinol, Ti, and CoCr was compared.