Influence on the properties of TMCs of ceramic and intermetallic composite reinforcements (BC, TiAl and TiSi) fabricated by inductive hot pressing.

Ambitious and competitive, the aerospace industry continuously demonstrates to be one of the leading engineering sectors either at exigence and new technologies development. As lightning the weight of aircrafts is one of the main targets, the spotlight is usually on material research by which new ones may be produced to pursue this aim and still offer the necessary performances. The combination of the properties of titanium and other materials as reinforcements provides really interesting results as titanium matrix composite materials, also known as TMCs.

Influence of Binder Composition and Material Extrusion (MEX) Parameters on the 3D Printing of Highly Filled Copper Feedstocks.

This work aims to better understand the type of thermoplastic binders required to produce highly loaded copper filaments that can be successfully printed via low-cost filament-based material extrusion (MEX). Compounding feedstock material with 55 vol.% of copper and three multi-component binder systems has been performed.

Tailoring a Refractory High Entropy Alloy by Powder Metallurgy Process Optimization.

This paper reports the microstructural evolution and mechanical properties of a low-density AlNbTaTiVZr refractory high-entropy alloy (RHEA) prepared by means of a combination of mechanical alloying and spark plasma sintering (SPS). Prior to sintering, the morphology, chemical homogeneity and crystal structures of the powders were thoroughly investigated by varying the milling times to find optimal conditions for densification. The sintered bulk RHEAs were produced with diverse feedstock powder conditions.

Influence of Ti on the Tensile Properties of the High-Strength Powder Metallurgy High Entropy Alloys.

The focus of this study is the evaluation of the influence of Ti concentration on the tensile properties of powder metallurgy high entropy alloys. Three NiCoCrFeTi alloys with X = 0.3; 0.

Analysis of the Microstructure and Mechanical Properties of Titanium-Based Composites Reinforced by Secondary Phases and B₄C Particles Produced via Direct Hot Pressing.

In the last decade, titanium metal matrix composites (TMCs) have received considerable attention thanks to their interesting properties as a consequence of the clear interface between the matrix and the reinforcing phases formed. In this work, TMCs with 30 vol % of B₄C are consolidated by hot pressing. This technique is a powder metallurgy rapid process.

Influence of Sintering Temperature on the Microstructure and Mechanical Properties of In Situ Reinforced Titanium Composites by Inductive Hot Pressing.

This research is focused on the influence of processing temperature on titanium matrix composites reinforced through Ti, Al, and B₄C reactions. In order to investigate the effect of Ti-Al based intermetallic compounds on the properties of the composites, aluminum powder was incorporated into the starting materials. In this way, in situ TiAl were expected to form as well as TiB and TiC.

Analysis of the Influence of Starting Materials and Processing Conditions on the Properties of W/Cu Alloys.

In this work, a study of the influence of the starting materials and the processing time used to develop W/Cu alloys is carried out. Regarding powder metallurgy as a promising fabrication route, the difficulties in producing W/Cu alloys motivated us to investigate the influential factors on the final properties of the most industrially demanding alloys: 85-W/15-Cu, 80-W/20-Cu, and 75-W/25-Cu alloys. Two different tungsten powders with large variation among their particle size-fine (W) and coarse (W) powders-were used for the preparation of W/Cu alloys.