Electrochemical nanobiosensor based on reduced graphene oxide and gold nanoparticles for ultrasensitive detection of microRNA-128.

Acute lymphoblastic leukemia (ALL) is one of the most prevalent cancers in children and microRNA-128 is amongst the most useful biomarkers not only for diagnosis of ALL, but also for discriminating ALL from acute myeloid leukemia (AML). In this study, a novel electrochemical nanobiosensor based on reduced graphene oxide (RGO) and gold nanoparticles (AuNPs) has been fabricated to detect miRNA-128. Cyclic Voltametery (CV), Square Wave Voltametery (SWV) and Electrochemical Impedance Spectroscopy (EIS) have been applied to characterize the nanobiosensor.

Optimization of the Modular Reinforced Bone Scaffold for Customized Alveolar Bone Defects.

A modular reinforced bone scaffold with enhanced mechanical properties has recently been developed by our group. It includes: 1) A load-bearing module: a skeleton which is made of a slowly degradable material, undertaking mechanical necessities of the scaffold, and 2) A bioreactive module: a porous and biodegradable component undertaking biological necessities of the scaffold. The load-bearing module is placed into the bio-reactive module to reinforce it.

3D-printed bi-layered polymer/hydrogel construct for interfacial tissue regeneration in a canine model.

Objectives: There are complications in applying regenerative strategies at the interface of hard and soft tissues due to the limited designs of constructs that can accommodate different cell types in different sites. The problem originates from the challenges in the adhesion of dissimilar materials, such as polymers and hydrogels, that can be suitable for regenerating different tissues such as bone and soft tissues. This paper presents a design of a new hybrid construct in which a polymer (polycaprolactone (PCL)) membrane firmly adheres to a layer of hydrogen (gelatin).

Culture and maintenance of neural progressive cells on cellulose acetate/graphene‑gold nanocomposites.

In this study, the first CA nanofibers were fabricated by electrospinning under optimal conditions: flow rate of 0.5 ml/h, a voltage of 20 kV, electrospinning distance of 15 cm, and an internal temperature of 25 °C, and humidity of 38%. The used Graphene/gold nanoparticles for CA performance improvement were examined by TGA, XRD, and SEM analysis.

Osteogenic Differentiation Potential of Adipose-Derived Mesenchymal Stem Cells Cultured on Magnesium Oxide/Polycaprolactone Nanofibrous Scaffolds for Improving Bone Tissue Reconstruction.

Recently, bone tissue engineering as a new strategy is used to repair and replace bone defects due to limitations in allograft and autograft methods. In this regard, we prepared nanofibrous scaffolds composed of polycaprolactone (PCL) and magnesium oxide (MgO) nanoparticles using the electrospinning technique for possible bone tissue engineering applications. The fabricated composites were characterized via scanning electron microscopy (SEM) imaging of scaffolds and seeded cells, water contact angle, DAPI staining, and MTT assay.

Ultra pH-sensitive detection of total and free prostate-specific antigen using electrochemical aptasensor based on reduced graphene oxide/gold nanoparticles emphasis on TiO/carbon quantum dots as a redox probe.

The development of a rapid, sensitive, and straightforward detection method of prostate-specific antigen (PSA) is indispensable for the early diagnosis of prostate cancer (PCa). This work relates an electrochemical method using functionalized single-stranded DNA aptamer to diagnose PCa and benign prostate hyperplasia. The sensing platform relies on PSA recognition by aptamer/Au/GO-nanohybrid-modified glassy carbon electrode.

Impact of Lipid/Magnesium Hydroxide Hybrid Nanoparticles on the Stability of Vascular Endothelial Growth Factor-Loaded PLGA Microspheres.

The purpose of the present study is to characterize poly(d,l-lactide--glycolide) (PLGA) composite microcarriers for vascular endothelial growth factor (VEGF) delivery. To reduce the initial burst release and protect the bioactivity, VEGF is encapsulated in soybean l-α-phosphatidylethanolamine (PE) and l-α-phosphatidylcholine (PC) anhydrous reverse micelle (VEGF-RM) nanoparticles. Also, mesoporous nano-hexagonal Mg(OH) nanostructure (MNS)-loaded PE/PC anhydrous reverse micelle (MNS-RM) nanoparticles are synthesized to suppress the induced inflammation of PLGA acidic byproducts and regulate the release profile.

Theranostic applications of stimulus-responsive systems based on carbon dots.

Over recent years, many different nanoparticle-based drug delivery systems (NDDSs) have been developed. Recently the development of stimulus-responsive NDDSs has come into sharper focus. Carbon dots (CDs) possess outstanding features such as useful optical properties, good biocompatibility, and the ability for easy surface modification.

In-situ porcine corneal matrix hydrogel as ocular surface bandage.

Purpose: Bioactive substrates can be used therapeutically to enhance wound healing. Here, we evaluated the effect of an in-situ thermoresponsive hydrogel from decellularized porcine cornea ECM, COMatrix (COrnea Matrix), for application as an ocular surface bandage for corneal epithelial defects.

Methods: COMatrix hydrogel was fabricated from decellularized porcine corneas.

Fabrication, Rheological, and Compositional Characterization of Thermoresponsive Hydrogel from Cornea.

Fabricating thermoresponsive hydrogels from decellularized tissues is a trending and promising approach to develop novel biomaterials for tissue engineering and therapeutic purposes. There are differences in the characteristics of the produced hydrogels related to the source tissue as well as the decellularization and solubilization protocols used. Detailed characterization of the hydrogels will support the efforts to optimize their application as biomaterials for tissue engineering and therapeutics.

Synthesis of a novel nanocomposite containing chitosan as a three-dimensional printed wound dressing technique: Emphasis on gene expression.

In this study, a highly porous three-dimensional (3D)-printed wound healing core/shell scaffold fabricated using poly-lactic acid (PLA). The core of scaffold was composed of hyaluronic acid (HA), copper carbon dots (Cu-CDs), rosmarinic acid, and chitosan hydrogel. Cu-CDs were synthesized using ammonium hydrogen citrate under hydrothermal conditions.

A bioprinted composite hydrogel with controlled shear stress on cells.

In recent decades, three dimensional (3D) bio-printing technology has found widespread use in tissue engineering applications. The aim of this study is to scrutinize different parameters of the bioprinter - with the help of simulation software - to print a hydrogel so much so that avoid high amounts of shear stress which is detrimental for cell viability and cell proliferation. The results have led to the combination of percentages collagen:alginate:gelatin (1:4:8)% as the best condition which makes sol-gel transition at room temperature possible.

Bone tissue engineering gelatin-hydroxyapatite/graphene oxide scaffolds with the ability to release vitamin D: fabrication, characterization, and in vitro study.

Developing smart scaffolds with drug release capability is one of the main approaches to bone tissue engineering. The current study involves the fabrication of novel gelatin (G)-hydroxyapatite (HA)-/vitamin D (VD)-loaded graphene oxide (GO) scaffolds with different concentrations through solvent-casting method. Characterizations confirmed the successful synthesis of HA and GO, and VD was loaded in GO with 36.

Chitosan/carbon quantum dot/aptamer complex as a potential anticancer drug delivery system towards the release of 5-fluorouracil.

Nowadays, nanotechnology contributes diminishing side effects rather than traditional therapeutic methods like chemotherapy. Thus, designing a biocompatible specific targeted nanocarrier with prolonged half-life and enhanced bio-availability using simultaneous cell imaging seems urgent. To meet this demand, 5-fluorouracil-chitosan‑carbon quantum dot-aptamer (5-FU-CS-CQD-Apt) nanoparticle was successfully synthesized for specific targeted delivery of 5-FU anti-cancer drug used in breast cancer treatment and this was done by following facile water-in-oil (W/O) emulsification method.

Graphite/gold nanoparticles electrode for direct protein attachment: characterization and gas sensing application.

In this work, graphite/gold nanoparticles (G/AuNPs) were synthesized through a facile chemical method, and its potential application for direct protein attachment for electrochemical detection of carbon monoxide (CO) was investigated. The preparation of G/AuNPs electrodes was optimized by synthesizing the nanoparticles in different concentration of HAuCl.3HO at various temperatures.

Microfluidic-assisted fabrication of reverse micelle/PLGA hybrid microspheres for sustained vascular endothelial growth factor delivery.

In this study, poly (d, l-lactide-co-glycolide) (PLGA) composite microspheres containing anhydrous reverse micelle (R.M.) dipalmitoylphosphatidylcholine (DPPC) nanoparticles loaded vascular endothelial growth factor (VEGF) were produced using microfluidic platforms.

Polyvinyl alcohol modified polyvinylidene fluoride-graphene oxide scaffold promotes osteogenic differentiation potential of human induced pluripotent stem cells.

Tissue engineering is fast becoming a key approach in bone medicine studies. Designing the ideally desirable combination of stem cells and scaffolds are at the hurt of efforts for producing implantable bone substitutes. Clinical application of stem cells could be associated with serious limitations, and engineering scaffolds that are able to imitate the important features of extracellular matrix is a major area of challenges within the field.

A glassy carbon electrode modified with reduced graphene oxide and gold nanoparticles for electrochemical aptasensing of lipopolysaccharides from Escherichia coli bacteria.

An electrochemical aptasensor is described for the voltammetric determination of lipopolysaccharide (LPS) from Escherichia coli 055:B5. Aptamer chains were immobilized on the surface of a glassy carbon electrode (GCE) via reduced graphene oxide and gold nanoparticles (RGO/AuNPs). Fast Fourier transform infrared, X-ray diffraction and transmission electron microscopy were used to characterize the nanomaterials.

Microfluidic synthesis of PLGA/carbon quantum dot microspheres for vascular endothelial growth factor delivery.

In this study, vascular endothelial growth factor (VEGF) loaded poly(d,l-lactide--glycolide) (PLGA) - carbon quantum dot microspheres were produced using microfluidic platforms. The microcapsules were fabricated in flow-focusing geometry with a biphasic flow to generate solid/oil/water (s-o-w) droplets. To avoid any damage to protein functional and structural stability during the encapsulation process, the VEGF was PEGylated.

Antagonistic effect of co-exposure to short-multiwalled carbon nanotubes and benzo[a]pyrene in human lung cells (A549).

In theenvironment, co-exposure to short-multiwalled carbon nanotubes (S-MWCNTs) and polycyclic aromatic compounds (PAHs) has been reported. In the co-exposure condition, the adsorption of PAHs onto MWCNTs may reduce PAHs toxic effect. The objective of this study was to investigate the cytotoxicity of S-MWCNTs and benzo[a]pyrene (B[a]P) individually, and in combination in human lung cell lines (A549).

Graphene oxide-l-arginine nanogel: A pH-sensitive fluorouracil nanocarrier.

Nowadays, putting forward an accurate cancer therapy method with minimal side effects is an important topic of research. Nanostructures, for their ability in controlled and targeted drug release on specific cells, are critical materials in this field. In this study, a pH-sensitive graphene oxide-l-arginine nanogel was synthesized to carry and release 5-fluorouracil.

Egg shell-derived calcium phosphate/carbon dot nanofibrous scaffolds for bone tissue engineering: Fabrication and characterization.

Recent exciting findings of the particular properties of Carbon dot (CDs) have shed light on potential biomedical applications of CDs-containing composites. While CDs so far have been widely used as biosensors and bioimaging agents, in the present study for the first time, we evaluate the osteoconductivity of CDs in poly (ε-caprolactone) (PCL)/polyvinyl alcohol (PVA) [PCL/PVA] nanofibrous scaffolds. Moreover, further studies were performed to evaluate egg shell-derived calcium phosphate (TCP3) and its cellular responses, biocompatibility and in vitro osteogenesis.

Individual and combined toxicity of carboxylic acid functionalized multi-walled carbon nanotubes and benzo a pyrene in lung adenocarcinoma cells.

Co-exposure to carboxylic acid functionalized multi-walled carbon nanotubes (F-MWCNTs) and polycyclic aromatic hydrocarbons (PAHs) such as benzo a pyrene (BaP) in ambient air have been reported. Adsorption of BaP to F-MWCNTs can influence combined toxicity. Studying individual toxicity of F-MWCNTs and BaP might give unrealistic data.