Magnetically confined plasma experiments generate a wealth of spectroscopic data. The first step toward extracting physical parameters is to fit a spectral model to the often complex spectra. The CXSFIT (Charge eXchange Spectroscopy FITting) spectral fitting code was originally developed for fitting charge exchange spectra on JET from the late 1980s onward and has been further developed over decades to keep up with the needs of the users.
View Article and Find Full Text PDFCapacitive plasma pickup is a well-known and difficult problem for plasma-facing edge diagnostics. This problem must be addressed to ensure an accurate and robust interpretation of the real signal measurements vs noise. The Faraday cup fast ion loss detector array of the Joint European Torus (JET) is particularly prone to this issue and can be used as a testbed to prototype solutions.
View Article and Find Full Text PDFRev Sci Instrum
October 2018
Charge-exchange spectroscopy on JET has become particularly challenging with the introduction of the ITER-like wall. The line intensities are weaker and contaminated by many nuisance lines. We have therefore upgraded the instrumentation to improve throughput and allow the simultaneous measurement of impurity and fuel-ion charge exchange by splitting the light between two pairs of imaging spectrometers using dichroic beam splitters.
View Article and Find Full Text PDFSince 2010, an in-vessel calibration light source (ICLS) has been used periodically on JET to calibrate a range of diagnostics at UV, visible, and IR wavelengths. During shutdowns, the ICLS (which is essentially an integrating sphere) is positioned within the vacuum vessel by the remote handling (RH) system. Following the 2013 calibration runs, several changes were made to improve the efficiency and quality of the calibrations.
View Article and Find Full Text PDFThe in situ absolute calibration of the JET real-time protection imaging system has been performed for the first time by means of radiometric light source placed inside the JET vessel and operated by remote handling. High accuracy of the calibration is confirmed by cross-validation of the near infrared (NIR) cameras against each other, with thermal IR cameras, and with the beryllium evaporator, which lead to successful protection of the JET first wall during the last campaign. The operation temperature ranges of NIR protection cameras for the materials used on JET are Be 650-1600 °C, W coating 600-1320 °C, and W 650-1500 °C.
View Article and Find Full Text PDFThe mirror-linked divertor spectroscopy diagnostic on JET has been upgraded with a new visible and near-infrared grating and filtered spectroscopy system. New capabilities include extended near-infrared coverage up to 1875 nm, capturing the hydrogen Paschen series, as well as a 2 kHz frame rate filtered imaging camera system for fast measurements of impurity (Be II) and deuterium Dα, Dβ, Dγ line emission in the outer divertor. The expanded system provides unique capabilities for studying spatially resolved divertor plasma dynamics at near-ELM resolved timescales as well as a test bed for feasibility assessment of near-infrared spectroscopy.
View Article and Find Full Text PDFOne of the main approaches to thermonuclear fusion relies on confining high temperature plasmas with properly shaped magnetic fields. The determination of the magnetic topology is, therefore, essential for controlling the experiments and for achieving the required performance. In Tokamaks, the reconstruction of the fields is typically formulated as a free boundary equilibrium problem, described by the Grad-Shafranov equation in toroidal geometry and axisymmetric configurations.
View Article and Find Full Text PDFRev Sci Instrum
October 2012
In preparation for ITER, JET has been upgraded with a new ITER-like wall (ILW), whereby the main plasma facing components, previously of carbon, have been replaced by mainly Be in the main chamber and W in the divertor. As part of the many diagnostic enhancements, a new, survey, visible spectroscopy diagnostic has been installed for the characterization of the ILW. An array of eight lines-of-sight (LOS) view radially one of the two JET neutral beam shine through areas (W coated carbon fibre composite tiles) at the inner wall.
View Article and Find Full Text PDFSince 1994, JET has had a mirror-link spectroscopy system with a poloidal view of 150 mm of the outer divertor split into three ranges: near-ultraviolet (near-UV) (∼ 300–450 nm), visible (450–750 nm), and near-infrared (near-IR) (750–1200 nm). The system consists of three Czerny–Turner/charge coupled device (CCD) pairs: 1 m focal length for the near-UV, 0.75 m focal length for the visible, and 0.
View Article and Find Full Text PDFA 60 kV neutral Li beam is injected into the edge plasma of JET to measure the electron density. The beam observation system has been improved by replacing a Czerny-Turner spectrometer with a high-resolution transmission-grating spectrometer and a fast back-illuminated frame-transfer camera. The larger throughput of the spectrometer, the increased sensitivity, and the faster readout of the new camera allow inter-ELM (edge localized mode) measurements (frame rate of 100 Hz).
View Article and Find Full Text PDFThe core charge-exchange diagnostic at the Joint European Torus (JET) provides measurements of the impurity ion temperature T(i), toroidal velocity V(phi), and impurity ion densities n(imp), across the whole minor radius. A contribution to the uncertainty of the measured quantities is the error resulting from the multi-Gaussian fit and photon statistics, usually quoted for each measured data. Absolute intensity calibration and especially alignment of the viewing directions can introduce an important systematic error.
View Article and Find Full Text PDFChanges of the toroidal plasma rotation induced by directed waves in the ion-cyclotron range of frequencies (ICRF) have been identified experimentally for the first time on the JET tokamak. The momentum carried by the waves is initially absorbed by fast resonating ions, which subsequently transfer it to the bulk plasma. Thus, the results provide evidence for the influence of ICRF heated fast ions on plasma rotation.
View Article and Find Full Text PDFThe interaction between tectonism and erosion produces rugged landscapes in actively deforming regions. In the northwestern Himalaya, the form of the landscape was found to be largely independent of exhumation rates, but regional trends in mean and modal elevations, hypsometry (frequency distribution of altitude), and slope distributions were correlated with the extent of glaciation. These observations imply that in mountain belts that intersect the snowline, glacial and periglacial processes place an upper limit on altitude, relief, and the development of topography irrespective of the rate of tectonic processes operating.
View Article and Find Full Text PDF