Spatial Bessel-like beams along arbitrary convex trajectories based on a 3D-printed metasurface.

A 3D-printed all-dielectric metasurface is presented in this Letter which can generate an accelerating beam with a circularly symmetric non-spreading transverse profile that can propagate along arbitrary convex trajectories. The curved trajectory is mapped to the corresponding direct-space spatial phases by the basic cube units with different geometrical heights. The required phase distribution is derived in detail based on the enveloping theory of differential geometry and the Bessel beam generation method.

3D printed metasurface for generating a Bessel beam with arbitrary focusing directions.

In this Letter, a metasurface combined with emerging 3D printing technology is proposed. The proposed metasurface regards the simple cube as the unit cell, and the height of the cube is the only variable. A nearly linear transmission phase range covering 360° operating at 20 GHz is obtained when the height is regulated in [2.

Ischemia postconditioning preventing lung ischemia-reperfusion injury.

Objective: This study evaluates the inhibitory effect of IPO against ischemia reperfusion (I/R) induced lung injury in rats.

Methods: Anesthetized and mechanically ventilated adult Sprague-Dawley rats were randomly assigned to one of the following groups (n=12 each): the sham operated control group, the ischemia-reperfusion (IR) group (30min of left-lung ischemia and 24h of reperfusion), the IPO group (three successive cycles of 30-s reperfusion per 30-s occlusion before restoring full perfusion), and the dexamethasone plus IPO group (rats were injected with dexamethasone (3mg/kg·day(-1)) 10min prior to the experiment and the rest of the procedures were the same as the IPO group). Lung injury was assessed by wet-to-dry lung weight ratio and tissue apoptosis and biochemical changes.