Effects of vertically aligned carbon nanotubes on shear performance of laminated nanocomposite bonded joints.

The main objective is to improve the most commonly addressed weakness of the laminated composites (i.e. delamination due to poor interlaminar strength) using carbon nanotubes (CNTs) as reinforcement between the laminae and in the transverse direction.

Chirality dependence of carbon single-walled nanotube material properties: axial coefficient of thermal expansion.

Carbon nanotubes are one of the best candidates for applications where structural, thermal, and chemical stabilities are of great importance. Despite the fact that significant efforts have been devoted to study properties and behavior of the carbon nanotubes in recent years, there have not been sufficient results available on their thermoelastic properties. This paper investigates the chirality dependence of coefficient of thermal expansion of carbon single-walled nanotubes both analytically and numerically.

Chirality dependence of carbon single-walled nanotube material properties: axial Young's modulus.

The potential use of individual carbon nanotubes as nano devices warrants detailed investigation of their mechanical behavior based on structural and geometrical configurations. The objective of this paper is to unravel the structural and chirality dependence of the axial Young's modulus of a carbon single-walled nanotube by analytical and numerical approaches. In this work, we employ the general homogenization composite shell model developed based on the asymptotic homogenization technique for analytical modeling of single-walled nanotubes.

Multifunctional composites using reinforced laminae with carbon-nanotube forests.

Traditional fibre-reinforced composite materials with excellent in-plane properties fare poorly when out-of-plane through-thickness properties are important. Composite architectures with fibres designed orthogonal to the two-dimensional (2D) layout in traditional composites could alleviate this weakness in the transverse direction, but all of the efforts so far have only produced limited success. Here, we unveil an approach to the 3D composite challenge, without altering the 2D stack design, on the basis of the concept of interlaminar carbon-nanotube forests that would provide enhanced multifunctional properties along the thickness direction.

Super-compressible foamlike carbon nanotube films.

We report that freestanding films of vertically aligned carbon nanotubes exhibit super-compressible foamlike behavior. Under compression, the nanotubes collectively form zigzag buckles that can fully unfold to their original length upon load release. Compared with conventional low-density flexible foams, the nanotube films show much higher compressive strength, recovery rate, and sag factor, and the open-cell nature of the nanotube arrays gives excellent breathability.

Multifunctional brushes made from carbon nanotubes.

Brushes are common tools for use in industry and our daily life, performing a variety of tasks such as cleaning, scraping, applying and electrical contacts. Typical materials for constructing brush bristles include animal hairs, synthetic polymer fibres and metal wires (see, for example, ref. 1).