Evaluation of the concentration of the toxic 2,3,6,7-tetrachlorobiphenylene in air after an electrical material fire.

It is known that when fires or explosions involve electrical systems, along with PCDDs and PCDFs, polychlorinated biphenylenes (PCBPs) are also produced. These chlorinated tricyclic aromatic pollutants were noticed in fire rubbles and after the World Trade Center destruction. However, the analytical difficulties in developing an efficient method have limited the knowledge of their environmental distribution.

Environmental impact of co-combustion of polyethylene wastes in a rice husks fueled plant: Evaluation of organic micropollutants and PM emissions.

Co-combustion of biomass and plastic waste has emerged as one of the most promising approach at the plastic waste management challenge. This strategy is particularly attractive since it can simultaneously solve the increasing energy demand and reduce the plastic wastes volume. However, since the combustion of both plastic wastes and natural materials is a potential source of organic micropollutants, such as polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), polychlorinated biphenyls (PCBs) and of polycyclic aromatic hydrocarbons (PAHs), beside particulate matter, the environmental sustainability of the waste to energy (WtE) co-combustion strategy has to be assessed.

Validation studies on activated carbon fiber passive sampler for PCDD/Fs and PCBs in water.

The toxicity of polychlorinated biphenyls (PCBs), polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs) is well known, and for this reason studying and monitoring these chemicals is fundamental. Activated carbon fibers (ACFs) are made of an adsorbent material widely used in the industrial field for the removal of micropollutants. The first step in this work was to perform a physico-chemical characterization of the adsorbent, focused on the analytical use of it.

Extraction of polycyclic aromatic hydrocarbons from polyhydroxyalkanoates before gas chromatography/mass spectrometry analysis.

Among the organic contaminants that could pass from waste to polyhydroxyalkanoates (PHAs), there are the polycyclic aromatic hydrocarbons (PAHs). For this reason, we have developed a rapid analytical method for the determination of sixteen PAHs in PHAs. PAHs were extracted by n-hexane, after matrix dispersion and crumbling into sand; the extract was purified by solid phase extraction using florisil as adsorbent.

Analysis of polychlorodibenzo-p-dioxins and polychlorodibenzofurans in stationary source emissions in GC-MS/MS using hydrogen as the carrier gas.

The European and American methods for the determination of polychlorodibenzo-p-dioxins and polychlorodibenzofurans in stationary source emissions require a high-resolution mass spectrometer detector. At the same time, all of the 17 toxic 2,3,7,8-chlorine-substituted isomers have to be separated by an appropriate chromatographic method. The resulting analysis has long runtimes and sometimes a double-column run is needed, which results in a huge waste of time, money and manual labor.

Emission of submicron aerosol particles in cement kilns: Total concentration and size distribution.

Cement plants are responsible for particle and gaseous emissions into the atmosphere. With respect to particle emission, the greater part of is in the range from 0.05 to 5.

Assessment of nitrous oxide emission from cement plants: real data measured with both Fourier transform infrared and nondispersive infrared techniques.

Nitrous oxide (N2O) is the third most important greenhouse gas after carbon dioxide and methane, and contributes about 6% to the greenhouse effect. Nitrous oxide is a minor component of the atmosphere, and it is a thousand times less than carbon dioxide (CO2). Nevertheless, it is much more potent than CO2 and methane, owing to its long stay in the atmosphere of approximately 120 yr and the high global warmingpotential (GWP) of298 times that of CO2.

Determination of 5-ethylidene-2-norbornene in industrial emission.

A method to measure the emissive concentration of 5-ethylidene-2-norbornene (ENB), a reactive compound used in industrial synthesis of terpolymers, has been developed. The starting points for the development of the presented method are European and Italian reference methods for the quantification of nonreactive volatile organic compounds in industrial emission. In this study, sampling conditions and desorption solvent have been optimized in laboratory and the method was applied in an industrial plant.

Development of a new automated clean-up system for the simultaneous analysis of polychlorinated dibenzo-p-dioxins (PCDDs), dibenzofurans (PCDFs) and 'dioxin-like' polychlorinated biphenyls (dl-PCB) in flue gas emissions by GPC-SPE.

A comprehensive clean-up method for quantitative analysis of polychlorinated biphenyls (PCBs) and polychlorinated dibenzo-p-dioxins and dibenzo-furans (PCDD/Fs) in one single extract of environmental samples was developed. Since the chemical nature and toxicity of planar PCBs are similar to those of PCDD/Fs, dioxin-like PCBs and PCDD/Fs are often surveyed together in their exposure assessments. The development of a method for the simultaneous analysis of PCBs and PCDD/Fs in environmental samples is invaluable.

Evaluation of a simultaneous sampling method of PAHs, PCDD/Fs and dl-PCBs in ambient air.

The Stockholm Convention on Persistent Organic Pollutants (POPs) was signed in May 2001 by 127 countries. Currently, 12 substances are regulated by the convention, and the work on finding new candidate chemicals to the convention has started. Among these 12 substances, dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs) and polychlorinated biphenyls (PCBs) are the objects of this study.

PCDD/Fs removal efficiency by electrostatic precipitator and wetfine scrubber in an iron ore sintering plant.

This study investigates the removal efficiency of polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) by the APCDs of an iron ore sintering plant, an electrostatic precipitator (ESP) and a wetfine scrubbing system (WS). The removal efficiencies of the ESP on the total PCDD/Fs concentration and the total PCDD/Fs I-TEQ concentration are 44.3% and 41.

Polycyclic aromatic hydrocarbon emission profiles and removal efficiency by electrostatic precipitator and wetfine scrubber in an iron ore sintering plant.

A monitoring campaign of polychlorinated dibenzo-p-dioxins and dibenzofurans, polyaromatic hydrocarbons (PAHs), and polychlorinated biphenyl was carried out in an Italian iron ore sintering plant by sampling the combustion gases at the electrostatic precipitator (ESP) outlet, at the Wetfine scrubber (WS) outlet, and by collecting the ESP dust. Few data are available on these micropollutants produced in iron ore sintering plants, particularly from Italian plants. This study investigates the PAH emission profiles and the removal efficiency of ESPs and WS.

Dioxins and furans formation in pilot incineration tests of sewage sludge spiked with organic chlorine.

The factors affecting polychlorinated dibenzo-p-dioxins (PCDD) and polychlorinated dibenzofurans (PCDF) formation were studied in sewage sludge incineration tests carried out on a demonstrative plant. The plant includes a circulating fluidised bed furnace (FBF) and a rotary kiln furnace (RKF), operating alternatively. During the tests sewage sludge was spiked with chlorinated hydrocarbons and the operating parameters of the afterburning chamber were varied.

Microorganic pollutants in the outskirts of Rome.

A short field campaign was performed in the outskirts of Rome at four sites located pretty along the four rose wind directions to city centre. Both chlorinated (PCB and PCDD/F) and non-chlorinated (n-alkanes, PAH, nitrated-PAH, n-alkanoic acids) organic micropollutants were investigated for their contents in the atmosphere. Concentrations reached by these pollutants in the outskirts were compared to those found in downtown Rome, both inside and outside of its largest city garden.