Sample port design for ballast water sampling: Refinement of guidance regarding the isokinetic diameter.

By using an appropriate in-line sampling system, it is possible to obtain representative samples of ballast water from the main ballast line. An important parameter of the sampling port is its "isokinetic diameter" (DISO), which is the diameter calculated to determine the velocity of water in the sample port relative to the velocity of the water in the main ballast line. The guidance in the U.

How many organisms are in ballast water discharge? A framework for validating and selecting compliance monitoring tools.

As regulations governing the discharge of living organisms in ships' ballast water enter into force, tools to rapidly and easily measure compliance with the discharge standards will be essential. To assess, validate, and select compliance tools, a framework-consisting of three parts-is presented: proof-of-concept, validation and verification, and final selection stages. Next, a case study describing the proof-of-concept stage is discussed.

3D imaging provides a high-resolution, volumetric approach for analyzing biofouling.

A volumetric approach for determining the fouling burden on surfaces is presented, consisting of a 3D camera imaging system with fine (5 μm) resolution. Panels immersed in an estuary on the southwest coast of Florida, USA were imaged and the data were used to quantify seasonal changes in the biofouling community. Test panels, which were submerged in seawater for up to one year, were analyzed before and after gentle scrubbing to quantify the biovolume of the total fouling community (ie soft and hard organisms) and the hard fouling community.

Validation trials of a shipboard filter skid (p3SFS) demonstrate its utility for collecting living zooplankton.

Relatively large volumes of water-on the order of cubic meters-must be sampled and analyzed to generate statistically valid estimates of sparsely concentrated organisms, such as in treated ballast water. To this end, a third prototype of a shipboard filter skid (p3SFS) was designed and constructed. It consisted of two housings (each containing a 35 μm mesh filter bag) and its own pump and computer controller.

Stratification of living organisms in ballast tanks: how do organism concentrations vary as ballast water is discharged?

Vertical migrations of living organisms and settling of particle-attached organisms lead to uneven distributions of biota at different depths in the water column. In ballast tanks, heterogeneity could lead to different population estimates depending on the portion of the discharge sampled. For example, concentrations of organisms exceeding a discharge standard may not be detected if sampling occurs during periods of the discharge when concentrations are low.

Ciliate ingestion and digestion: flow cytometric measurements and regrowth of a digestion-resistant Campylobacter jejuni.

We measured ingestion and digestion rates of the pathogenic bacterium Campylobacter jejuni by a freshwater ciliate Colpoda sp. to determine whether Campylobacter is able to resist protist digestion. Campylobacter and the nonpathogenic bacterium Pseudomonas putida LH1 were labeled with a 5-chloromethylfluorescein diacetate, which fluoresces in intact and active cells but fades when exposed to low pH environments, such as protistan food vacuoles.