Ultralow Density, Monolithic WS2, MoS2, and MoS2/Graphene Aerogels.

We describe the synthesis and characterization of monolithic, ultralow density WS2 and MoS2 aerogels, as well as a high surface area MoS2/graphene hybrid aerogel. The monolithic WS2 and MoS2 aerogels are prepared via thermal decomposition of freeze-dried ammonium thio-molybdate (ATM) and ammonium thio-tungstate (ATT) solutions, respectively. The densities of the pure dichalcogenide aerogels represent 0.

Potential-induced electronic structure changes in supercapacitor electrodes observed by in operando soft X-ray spectroscopy.

The dynamic physiochemical response of a functioning graphene-based aerogel supercapacitor is monitored in operando by soft X-ray spectroscopy and interpreted through ab initio atomistic simulations. Unanticipated changes in the electronic structure of the electrode as a function of applied voltage bias indicate structural modifications across multiple length scales via independent pseudocapacitive and electric double layer charge storage channels.

Mechanically robust 3D graphene macroassembly with high surface area.

We report the synthesis of a three-dimensional (3D) macroassembly of graphene sheets with electrical conductivity (∼10(2) S m(-1)) and Young's modulus (∼50 MPa) orders of magnitude higher than those previously reported, super-compressive deformation behavior (∼60% failure strain), and surface areas (>1300 m(2) g(-1)) approaching theoretically maximum values.

Performance of a pilot-scale continuous flow microbial electrolysis cell fed winery wastewater.

A pilot-scale (1,000 L) continuous flow microbial electrolysis cell was constructed and tested for current generation and COD removal with winery wastewater. The reactor contained 144 electrode pairs in 24 modules. Enrichment of an exoelectrogenic biofilm required ~60 days, which is longer than typically needed for laboratory reactors.

Use of carbon mesh anodes and the effect of different pretreatment methods on power production in microbial fuel cells.

Flat electrodes are useful in microbial fuel cells (MFCs) as close electrode spacing improves power generation. Carbon cloth and carbon paper materials typically used in hydrogen fuel cells, however, are prohibitively expensive for use in MFCs. An inexpensive carbon mesh material was examined here as a substantially less expensive alternative to these materials for the anode in an MFC.

High surface area stainless steel brushes as cathodes in microbial electrolysis cells.

Microbial electrolysis cells (MECs) are an efficient technology for generating hydrogen gas from organic matter, but alternatives to precious metals are needed for cathode catalysts. We show here that high surface area stainless steel brush cathodes produce hydrogen at rates and efficiencies similar to those achieved with platinum-catalyzed carbon cloth cathodes in single-chamber MECs. Using a stainless steel brush cathode with a specific surface area of 810 m2/m3, hydrogen was produced at a rate of 1.