Remote Excitation of Tip-Enhanced Photoluminescence with a Parallel AgNW Coupler.

Tip-enhanced photoluminescence (TEPL) microscopy allows for the correlation of scanning probe microscopic images and photoluminescent spectra at the nanoscale level in a similar way to tip-enhanced Raman scattering (TERS) microscopy. However, due to the higher cross-section of fluorescence compared to Raman scattering, the diffraction-limited background signal generated by far-field excitation is a limiting factor in the achievable spatial resolution of TEPL. Here, we demonstrate a way to overcome this drawback by using remote excitation TEPL (RE-TEPL).

Liquid-phase photo-induced covalent modification (PICM) of single-layer graphene by short-chain fatty acids.

We report an efficient photo-induced covalent modification (PICM) of graphene by short-chain fatty acids (SCFAs) with an alkyl chain at the liquid-solid interface for spatially resolved chemical functionalization of graphene. Light irradiation on monolayer graphene under an aqueous solution of the SCFAs with an alkyl chain efficiently introduces sp-hybridized defects, where the reaction rates of PICM are significantly higher than those in pure water. Raman and IR spectroscopy revealed that a high density of methyl, methoxy, and acetate groups is covalently attached to the graphene surface while it was partially oxidized by other oxygen-containing functional groups, such as OH and COOH.

All-Optical and One-Color Rewritable Chemical Patterning on Pristine Graphene under Water.

We report a facile all-optical method for spatially resolved and reversible chemical modification of a graphene monolayer. A tightly focused laser on graphene under water introduces an sp-type chemical defect by photo-oxidation. The sp-type defects can be reversibly restored to sp carbon centers by the same laser with higher intensity.

Li@C thin films: characterization and nonlinear optical properties.

Organic materials have attracted considerable attention in nonlinear optical (NLO) applications as they have several advantages over inorganic materials, including high NLO response, and fast response time as well as low-cost and easy fabrication. Lithium-containing C (Li@C) is promising for NLO over other organic materials because of its strong NLO response proven by theoretical and experimental studies. However, the low purity of Li@C has been a bottleneck for applications in the fields of solar cells, electronics and optics.

Label-free visualization of heterogeneities and defects in metal-organic frameworks using nonlinear optics.

Defects influence the properties of metal-organic frameworks (MOFs), such as their storage amount and the diffusion kinetics of gas molecules. However, the spatial distribution of defects is still poorly understood due to a lack of visualization methods. Here, we present a new method using nonlinear optics (NLO) that allows the visualization of defects within MOFs.

Controlled Fabrication of Optical Signal Input/Output Sites on Plasmonic Nanowires.

Silver nanowires have attracted considerable attention as subdiffraction limited diameter waveguides in a variety of applications including cell endoscopy and photonic integrated circuitry. Optical signal transport occurs by coupling light into propagating surface plasmons, which scatter back into light further along the wire. However, these interconversions only occur efficiently at wire ends, or at defects along the wire, which are not controlled during synthesis.

Facilitating Tip-Enhanced Raman Scattering on Dielectric Substrates via Electrical Cutting of Silver Nanowire Probes.

TERS is a powerful tool for nanoscale optical characterization of surfaces. However, even after 20 years of development, the parameters for optimal TERS tips are still up for debate. As a result, routine measurements on bulk or dielectric substrates remain exceptionally challenging.

Clinical evaluation of a computer-aided diagnosis (CAD) prototype for the detection of pulmonary embolism.

Rationale And Objectives: To evaluate the performance of a prototype computer-aided diagnosis (CAD) tool using artificial intelligence techniques for the detection of pulmonary embolism (PE) and the possible benefit for general radiologists.

Materials And Methods: Forty multidetector row computed tomography datasets (16/64- channel scanner) using 100 kVp, 100 mAs effective/slice, and 1-mm axial reformats in a low-frequency reconstruction kernel were evaluated. A total of 80 mL iodinated contrast material was injected at a flow rate of 5 mL/seconds.