Redox-Active Ruthenium-Organic Polyhedra with Tunable Surface Functionality and Porosities.

Dinuclear ruthenium paddlewheel complexes exhibit high structural stability in redox reactions. The use of these chemical motifs for the construction of Ru-based metal-organic polyhedra (RuMOPs) provides a route for redox-active porous materials. However, there are few studies on the synthesis and characterization of RuMOPs due to the difficulty in controlling the assembly process via the ligand-exchange reaction of equatorial acetates of the diruthenium tetraacetate precursors with dicarboxylic acid ligands.

Photoexcited Anhydrous Proton Conductivity in Coordination Polymer Glass.

Optically switchable proton-conductive materials will enable the development of artificial ionic circuits. However, most switchable platforms rely on conformational changes in crystals to alter the connectivity of guest molecules. Guest dependency, low transmittance, and poor processability of polycrystalline materials hinder overall light responsiveness and contrast between on and off states.

Synthesis, X-ray structure, photophysical properties, and theoretical studies of six-membered cyclometalated iridium(iii) complexes: revisiting Ir(pnbi)(acac).

We have determined the X-ray structure of Ir(pnbi)2(acac) (pnbi = 2-phenanthren-9-yl-1-phenyl-1H-benzimidazole; acac = acetylacetonate), which exhibits a six-membered metallocycle around the Ir center. This result stands in sharp contrast to previously postulated structures of Ir(pnbi)2(acac), which assumed a five-membered metallocycle. In this paper, we focus on the relative stability of five- and six-membered Ir(C^N) ring structures.

A Peanut-Shaped Polyaromatic Capsule: Solvent-Dependent Transformation and Electronic Properties of a Non-Contacted Fullerene Dimer.

Synthesis of molecular containers capable of incorporating multiple fullerenes remains challenging. Reported here is that room-temperature mixing of metal ions with W-shaped bispyridine ligands featuring polyaromatic panels results in the quantitative formation of a peanut-shaped M L capsule. The capsule reversibly converts into two molecules of an ML double tube in response to changes in the solvent.

Bio-inspired protonic memristor devices based on metal complexes with proton-coupled electron transfer.

A new type of memristor inspired by bio-membranes is presented, based on the proton movement resulting from proton-coupled electron transfer (PCET) processes in dinuclear Ru complexes, whereby a two-terminal device based on said Ru complexes and a proton-conducting polymer was constructed as a proof-of-concept. Two ITO electrodes were modified separately with dinuclear Ru complexes that bear tetraphosphonic acid linkers at both ends and a 2,6,2',6'-tetrakis(benzimidazol-2-yl)-4,4'-bipyridine (RuNH-OH) or 1,3,1',3'-tetrakis(benzimidazol-2-yl)-5,5'-biphenyl (RuCH-OH) bridging ligand, and both ITO electrodes exhibit PCET processes with different Ru(ii/iii) redox potentials and pKa values. Poly(4-vinylpyridine) (P4VP; pKa = 4-5), a proton-conducting polymer, was sandwiched between the two modified ITO electrodes to construct a two-terminal device of the type ITO|(RuNH-OH)3|P4VP|(RuCH-OH)3|ITO.

Proton-Rocking-Chair-Type Redox Capacitors Based on Indium Tin Oxide Electrodes with Multilayer Films Containing Ru Complexes.

A rechargeable proton-rocking-chair-type redox capacitor was fabricated using scalable layer-by-layer-(LbL)-assembled films composed of two dinuclear Ru complexes that exhibit proton-coupled electron-transfer (PCET) reactions with different Ru(II/III) redox potentials (RuNH-OH and RuCH-OH). RuNH-OH and RuCH-OH contain different coordination environments that involve two phosphonate linker ligands at both ends and bridging 2,6,2',6'-tetrakis(benzimidazol-2-yl)-4,4'-bipyridine or 1,3,1',3'-tetrakis(benzimidazol-2-yl)-5,5'-biphenyl ligands, respectively. The molecular units were assembled onto indium tin oxide (ITO) electrodes by complexation between the phosphonate groups and zirconium(IV) ions.

Hydrogen-bonded metallo-supramolecular polymers based on ruthenium or iron complexes for the selective extraction of single-walled carbon nanotubes.

The chemical functionalization of nano-carbon materials such as single-walled carbon nanotubes (SWNTs) and graphene by metal complexes has attracted much attention due to the multitude of potential applications in efficient energy-conversion and -storage devices. The solubilization and single-chirality separation of SWNTs by surface modifications is a useful approach to manipulate SWNTs in the liquid phase. In this study, several Ru and Fe complexes containing two terminal quadruple hydrogen-bonded (H-bonded) ureidopyrimidinedione (UPy) groups were synthesized (Ru-1, Ru-UPy, and Fe-UPy) to form H-bonded supramolecular polymers by self-association.

Robust Nanowrapping of Reduced Graphene Oxide by Metal-Organic Network Films between Fe Ions and Tetra(Catechol-Substituted) Porphyrin.

We found the utilization of porphyrin-based metal-organic network films composed of tetra(catechol-substituted)porphyrin (cPor) and Fe ions for robust wrapping materials of graphene oxide (GO), which can keep the dispersion state under the chemical reduction of GO to reduced graphene oxide (rGO) in water. The tetra(catechol-substituted)porphyrin (cPor) was designed for soft-wrapping methods because the aromatic porphyrin moieties can be strongly adsorbed onto the surface of GO or rGO via both π-π interactions and the catechol-Fe coordination network formation. The GO sheets covered with the cPor-Fe films were reduced chemically in water under retention of the wrapped nanostructure of the cPor-Fe/GO sheets.

Wisely Designed Phthalocyanine Derivative for Convenient Molecular Fabrication on a Substrate.

An axial-substituted silicon phthalocyanine derivative, SiPc(OR) (R = CH), that is soluble in organic solvent is conveniently synthesized. This silicon phthalocyanine derivative reacts with a hydroxyl group on a substrate and then with another phthalocyanine derivative under mild conditions. The accumulation number of the phthalocyanine molecules on the substrates is easily controlled by the immersion time.

Controlling the Molecular Direction of Dinuclear Ruthenium Complexes on HOPG Surface through Noncovalent Bonding.

We synthesized three types of binuclear Ru complexes (1-3) that contain pyrene anchors for the adsorption of 1-3 onto nanocarbon materials via noncovalent π-π interactions, in order to investigate their adsorption onto and their desorption from highly ordered pyrolytic graphite (HOPG). The adsorption saturation for 1 (6.22 pmol/cm), 2 (2.

Stable anchoring chemistry for room temperature charge transport through graphite-molecule contacts.

An open challenge for single-molecule electronics is to find stable contacts at room temperature with a well-defined conductance. Common coinage metal electrodes pose fabrication and operational problems due to the high mobility of the surface atoms. We demonstrate how molecules covalently grafted onto mechanically robust graphite/graphene substrates overcome these limitations.

Energy-Storage Applications for a pH Gradient between Two Benzimidazole-Ligated Ruthenium Complexes That Engage in Proton-Coupled Electron-Transfer Reactions in Solution.

The judicious selection of pairs of benzimidazole-ligated ruthenium complexes allowed the construction of a rechargeable proton-coupled electron-transfer (PCET)-type redox battery. A series of ruthenium(II) and -(III) complexes were synthesized that contain substituted benzimidazoles that engage in PCET reactions. The formation of intramolecular Ru-C cyclometalation bonds stabilized the resulting ruthenium(III) complexes, in which pK values of the imino N-H protons on the benzimidazoles are usually lower than those for the corresponding ruthenium(II) complexes.

Simultaneous Formation and Spatial Patterning of ZnO on ITO Surfaces by Local Laser-Induced Generation of Microbubbles in Aqueous Solutions of [Zn(NH)].

We demonstrate the simultaneous formation and spatial patterning of ZnO nanocrystals on an indium-tin oxide (ITO) surface upon local heating using a laser (1064 nm) and subsequent formation of microbubbles. Laser irradiation of an ITO surface in aqueous [Zn(NH)] solution (1.0 × 10 M at pH 12.

Stepwise fabrication of donor/acceptor thin films with a charge-transfer molecular wire motif.

Novel thin films composed of a donor (D)/acceptor (A) charge-transfer chain compound were fabricated by a layer-by-layer technique using complexation of a paddlewheel-type diruthenium(ii, ii) complex with an N,N'-dicyanoquinonediimine derivative on an ITO substrate with a pyridine-substituted phosphonate anchor. The stepwise growth of an electron-transfer DA-chain thin film was confirmed.

Synthesis and Single-Molecule Conductance Study of Redox-Active Ruthenium Complexes with Pyridyl and Dihydrobenzo[b]thiophene Anchoring Groups.

The ancillary ligands 4'-(4-pyridyl)-2,2':6',2''-terpyridine and 4'-(2,3-dihydrobenzo[b]thiophene)-2,2'-6',2"-terpyridine were used to synthesize two series of mono- and dinuclear ruthenium complexes differing in their lengths and anchoring groups. The electrochemical and single-molecular conductance properties of these two series of ruthenium complexes were studied experimentally by means of cyclic voltammetry and the scanning tunneling microscopy-break junction technique (STM-BJ) and theoretically by means of density functional theory (DFT). Cyclic voltammetry data showed clear redox peaks corresponding to both the metal- and ligand-related redox reactions.

Controlling the Adsorption of Ruthenium Complexes on Carbon Surfaces through Noncovalent Bonding with Pyrene Anchors: An Electrochemical Study.

Surface modifications of carbon nanomaterials, such as graphene or carbon nanotubes, through noncovalent π-π interactions between π-conjugated carbon surfaces and pyrene anchors have received much attention on account of the applications of these materials in organic electronic and sensor devices. Despite the rapidly expanding use of pyrene anchors, little is known about the number of pyrene groups required in order to achieve a stable attachment of molecules on nanocarbon surfaces. So far, systematic studies on such surface modifications through adsorption isotherms and desorption behavior of molecules still remain scarce.

Controlling the Direction of the Molecular Axis of Rod-Shaped Binuclear Ruthenium Complexes on Single-Walled Carbon Nanotubes.

We report the synthesis of a mixed-valence ruthenium complex, bearing pyrene moieties on one side of the ligands as anchor groups. Composites consisting of mixed-valence ruthenium complexes and SWNTs were prepared by noncovalent π-π interactions between the SWNT surface and the pyrene anchors of the Ru complex. In these composites, the long axis of the Ru complexes was aligned in parallel to the principal direction of the SWNT.

Effects of Fe cations in ruthenium-complex multilayers fabricated by a layer-by-layer method.

Molecular multilayers were fabricated using a Ru complex containing Fe cations on an indium tin oxide surface to control the properties of the Ru-complex multilayers such as the multilayer orientation and the electron transport. The Ru-complex multilayer films containing Fe cations were thicker than those containing Zr cations, which have been used previously. The electron transport properties of the multilayers containing Fe cations were evaluated.

Photoresponsive Molecular Memory Films Composed of Sequentially Assembled Heterolayers Containing Ruthenium Complexes.

Photoresponsive molecular memory films were fabricated by a layer-by-layer (LbL) assembling of two dinuclear Ru complexes with tetrapodal phosphonate anchors, containing either 2,3,5,6-tetra(2-pyridyl)pyrazine or 1,2,4,5-tetra(2-pyridyl)benzene as a bridging ligand (Ru-NP and Ru-CP, respectively), using zirconium phosphonate to link the layers. Various types of multilayer homo- and heterostructures were constructed. In the multilayer heterofilms such as ITO||(Ru-NP)m |(Ru-CP)n , the difference in redox potentials between Ru-NP and Ru-CP layers was approximately 0.

Observation of an Orientation Change in Highly Oriented Layer-by-Layer Films of a Ruthenium Complex upon Oxidation Reaction.

Layer-by-layer films composed of redox-active ruthenium dimer and Zr(IV) ions were fabricated on an indium tin oxide electrode. The fabricating behavior was monitored by cyclic voltammetry and UV-vis absorption spectral measurements. The orientation of the film was also monitored by grazing-incidence small-angle and wide-angle X-ray scattering (GISAXS) measurements, and it has been clarified that this film has a crystalline structure.

Layer-by-layer grown scalable redox-active ruthenium-based molecular multilayer thin films for electrochemical applications and beyond.

Here we report the first study on the electrochemical energy storage application of a surface-immobilized ruthenium complex multilayer thin film with anion storage capability. We employed a novel dinuclear ruthenium complex with tetrapodal anchoring groups to build well-ordered redox-active multilayer coatings on an indium tin oxide (ITO) surface using a layer-by-layer self-assembly process. Cyclic voltammetry (CV), UV-Visible (UV-Vis) and Raman spectroscopy showed a linear increase of peak current, absorbance and Raman intensities, respectively with the number of layers.

Potential Tuning of Nanoarchitectures Based on Phthalocyanine Nanopillars: Construction of Effective Photocurrent Generation Systems.

Nanopillars composed of a photoresponsive phthalocyanine derivative have been conveniently fabricated using a continuous silane coupling reaction on a substrate. The chemical potentials of phthalocyanine nanopillars (PNs) are precisely controlled by changing the number of phthalocyanine derivatives on the substrate. In addition, photocurrent generation efficiencies have been strongly influenced by the number of phthalocyanine derivatives.