Treating wastewater for microplastics to a level on par with nearby marine waters.

Retention of microplastics (MPs) at the third largest wastewater treatment plant (WWTP) in Sweden was investigated. The plant is one of the most modern and advanced of its kind, with rapid sand filter for tertiary treatment in combination with mechanical, biological, and chemical treatment. It achieved a significantly high treatment efficiency, which brought the MP concentration in its discharge on par with concentrations measured in marine waters of the same region.

The role of turbulence in the deposition of intrinsically buoyant MPs.

Intrinsically floating microplastics (MP) such as polyethene (PE) or polypropylene (PP) are among the most common MPs found in aquatic sediments. There must hence be mechanisms that cause lighter-than-water MPs to deposit despite them being buoyant. How these MPs end up in the sediment bed is only partly understood.

What is hiding below the surface - MPs including TWP in an urban lake.

Inland lakes play an important role as habitats for local species and are often essential drinking water reservoirs. However, there is limited information about the presence of microplastics (MPs) in these water bodies. Thirteen sediment samples were collected across a Danish urban lake to map MPs, including tyre wear particles (TWP).

Buoyant microplastics in freshwater sediments - How do they get there?

The accumulation of microplastics (MPs) in the sediments of a stormwater treatment pond was studied to gain knowledge on how these facilities protect the natural environment against this emerging pollutant. Thirteen sediment samples were analyzed for MPs down to 10 μm, mapping the pattern of accumulation in the pond. The average abundance in terms of MP-number and mass was 11.