Shaping Thermal Transport and Temperature Distribution via Anisotropic Carbon Fiber Reinforced Composites.

With the ongoing electrification of vehicles, thermal management is on everyone's lips. To prevent overheating in electronic systems, new design strategies for thermal dissipation are needed. Thermally anisotropic materials enable targeted directional heat transport due to their anisotropic thermal conduction.

Synthesis and evaluation of novel urethane macromonomers for the formulation of fracture tough 3D printable dental materials.

3D printing of materials which combine fracture toughness, high modulus and high strength is quite challenging. Most commercially available 3D printing resins contain a mixture of multifunctional (meth)acrylates. The resulting 3D printed materials are therefore brittle and not adapted for the preparation of denture bases.

Mechanical Properties of the Carbon Nanotube Modified Epoxy-Carbon Fiber Unidirectional Prepreg Laminates.

The effect of plasma treatment of the multi-walled carbon nanotube (MWCNT) surface on the fracture toughness of an aerospace grade epoxy resin and its unidirectional (UD) carbon fiber prepreg laminates has attracted scientific interest. A prepreg route eliminates the possible risk of carbon nanotube filtration by unidirectional carbon fibers. X-ray photoelectron spectroscopy results suggested that oxygen atom concentration at the nanotube surface was increased from 0.

Effect of Curing Agent on the Compressive Behavior at Elevated Test Temperature of Carbon Fiber-Reinforced Epoxy Composites.

The aim of the underlying research is to understand the effect of elevated test temperatures on the mechanical properties of carbon fiber-reinforced laminates based on three different hardeners. A high-temperature stable adhesive was developed for the end tabs of the specimen. Bifunctional bisphenol A diglycidyl ether (DGEBA) epoxy cured with triethylenetetramine (TETA), isophorone diamine (IPDA), and 4,4'-diaminodiphenylsulfone (DDS) were cured and tested in a Celanese compressive test up to 250 °C.

Copper and Nickel Coating of Carbon Fiber for Thermally and Electrically Conductive Fiber Reinforced Composites.

In this paper, the thermal and electrical conductivity and mechanical properties of fiber reinforced composites produced from nickel- and copper-coated carbon fibers compared to uncoated fibers are presented. The carbon fibers were processed by our prepreg line and cured to laminates. In the fiber direction, the thermal conductivity doubled from ~3 W/mK for the uncoated fiber, to ~6 W/mK for the nickel, and increased six times to ~20 W/mK for the copper-coated fiber for a fiber volume content of ~50 vol %.

Influence of Fiber Volume Content on Thermal Conductivity in Transverse and Fiber Direction of Carbon Fiber-Reinforced Epoxy Laminates.

Thermal conductivity is an important material property for thermo-mechanical calculations, as mechanical properties strongly depend on the temperature and heat distribution in the manufactured parts. Although several suggestions for approximation formulae have been made, existing experimental data are rare and are not comparable due to different measurement methods. In addition, scarcely has the thermal conductivity in both the fiber direction and transverse direction been studied.