Coherent Terahertz Detection via Ultrafast Dynamics of Hot Dirac Fermions in Graphene.

Graphene has recently been shown to exhibit ultrafast conductivity modulation due to periodic carrier heating by either terahertz (THz) waves, leading to self-induced harmonic generation, or the intensity beat note of two-color optical radiation. We exploit the latter to realize an optoelectronic photomixer for coherent, continuous-wave THz detection, based on a photoconductive antenna with multilayer CVD-grown graphene in the gap. While for biased THz emitters the dark current would pose a serious detriment for performance, we show that this is not the case for bias-free THz detection and demonstrate detection up to frequencies of at least 700 GHz at room temperature, even without optimized tuning of the doping.

600-GHz Fourier imaging based on heterodyne detection at the 2nd sub-harmonic.

Fourier imaging is an indirect imaging method which records the diffraction pattern of the object scene coherently in the focal plane of the imaging system and reconstructs the image using computational resources. The spatial resolution, which can be reached, depends on one hand on the wavelength of the radiation, but also on the capability to measure - in the focal plane - Fourier components with high spatial wave-vectors. This leads to a conflicting situation at THz frequencies, because choosing a shorter wavelength for better resolution usually comes at the cost of less radiation power, concomitant with a loss of dynamic range, which limits the detection of higher Fourier components.

Strong coupling of plasmonic bright and dark modes with two eigenmodes of a photonic crystal cavity.

Dark modes represent a class of forbidden transitions or transitions with weak dipole moments between energy states. Due to their low transition probability, it is difficult to realize their interaction with light, let alone achieve the strong interaction of the modes with the photons in a cavity. However, by mutual coupling with a bright mode, the strong interaction of dark modes with photons is possible.

Determining the absolute temporal field of ultra-broadband terahertz-infrared pulses with field-induced second-harmonic spectrograms.

We demonstrate the use of spectrograms of the field-induced second-harmonic (FISH) signal generated in ambient air, to reconstruct the absolute temporal electric field of ultra-broadband terahertz-infrared (THz-IR) pulses with bandwidths exceeding 100 THz. The approach is applicable even with relatively long (150-femtosecond) optical detection pulses, where the relative intensity and phase can be extracted from the moments of the spectrogram, as demonstrated by transmission spectroscopy of very thin samples. Auxiliary EFISH/ABCD measurements are used to provide the absolute field and phase calibration, respectively.

Coherent coupling of metamaterial resonators with dipole transitions of boron acceptors in Si.

We investigate the coherent coupling of metamaterial resonators with hydrogen-like boron acceptors in Si at cryogenic temperatures. When the resonance frequency of the metamaterial, chosen to be in the range 7-9 THz, superimposes the transition frequency from the ground state of the acceptor to an excited state, Rabi splitting as large as 0.4 THz is observed.

Can a terahertz metamaterial sensor be improved by ultra-strong coupling with a high-Q photonic resonator?

When a metamaterial (MM) is embedded in a one-dimensional photonic crystal (PC) cavity, the ultra-strong coupling between the MM plasmons and the photons in the PC cavity gives rise to two new polariton modes with high quality factor. Here, we investigate by simulations whether such a strongly coupled system working in the terahertz (THz) frequency range has the potential to be a better sensor than a MM (or a PC cavity) alone. Somewhat surprisingly, one finds that the shift of the resonance frequency induced by an analyte applied to the MM is smaller in the case of the dual resonator (MM and cavity) than that obtained with the MM alone.

Terahertz photoconductive waveguide emitter with excitation by a tilted optical pulse front.

We explore the tilted-pulse-front excitation technique to control the superradiant emission of terahertz (THz) pulses from large-area photonconductive semiconductor switches. Two cases are studied. First, a photoconductive antenna emitting into free space, where the propagation direction of the optically generated THz beam is controlled by the choice of the tilt angle of the pump pulse front.

Direct Near-Field Observation of Surface Plasmon Polaritons on Silver Nanowires.

Surface plasmon polaritons on (silver) nanowires are promising components for future photonic technologies. Here, we study near-field patterns on silver nanowires with a scattering-type scanning near-field optical microscope that enables the direct mapping of surface waves. We analyze the spatial pattern of the plasmon signatures for different excitation geometries and polarization and observe a plasmon wave pattern that is canted relative to the nanowire axis, which we show is due to a superposition of two different plasmon modes, as supported by electromagnetic simulations including the influence of the substrate.

Nonlocal collective ultrastrong interaction of plasmonic metamaterials and photons in a terahertz photonic crystal cavity.

Light-matter interaction in the strong coupling regime is of profound interest for fundamental quantum optics, information processing and the realization of ultrahigh-resolution sensors. Here, we report a new way to realize strong light-matter interaction, by coupling metamaterial plasmonic "quasi-particles" with photons in a photonic cavity, in the terahertz frequency range. The resultant cavity polaritons exhibit a splitting which can reach the ultra-strong coupling regime, even with the comparatively low density of quasi-particles, and inherit the high Q-factor of the cavity despite the relatively broad resonances of the Swiss-cross and split-ring-resonator metamaterials used.

Software compensation in particle flow reconstruction.

The particle flow approach to calorimetry benefits from highly granular calorimeters and sophisticated software algorithms in order to reconstruct and identify individual particles in complex event topologies. The high spatial granularity, together with analogue energy information, can be further exploited in software compensation. In this approach, the local energy density is used to discriminate electromagnetic and purely hadronic sub-showers within hadron showers in the detector to improve the energy resolution for single particles by correcting for the intrinsic non-compensation of the calorimeter system.

Saturable absorption of femtosecond optical pulses in multilayer turbostratic graphene.

We investigate the nonlinear transmission of a ~280-layer turbostratic graphene sheet for near-infrared amplifier laser pulses (775 nm, Ti:sapphire laser) with a duration of 150-fs and 20-fs. Saturable absorption is observed in both cases, however it is not very strong, amounting to ~13% transmittance change for the 20-fs (150-fs) pulses at a peak intensity of 30 GW/cm (4 GW/cm). The dependence on incident peak intensity is reproduced well using a theoretical model for the time-dependent saturable absorption, where the excited carriers vacate the photo-excited energy range within 3-5 fs, which we attribute to energy redistribution due to carrier-carrier scattering.

Optimization of single-cycle terahertz generation in LiNbO3 for sub-50 femtosecond pump pulses.

We compare different tilted-pulse-front pumping schemes for single-cycle THz generation in LiNbO(3) crystals both theoretically and experimentally in terms of conversion efficiency. The conventional setup with a single lens as an imaging element has been found to be highly inefficient in the case of sub-50 fs pump pulses, mainly due to the resulting chromatic aberrations. These aberrations are avoided in the proposed new setup, which employs two concave mirrors in a Keplerian telescope arrangement as the imaging sequence.

Terahertz white-light pulses from an air plasma photo-induced by incommensurate two-color optical fields.

We demonstrate plasma-THz generation in ambient air with two-color (ω-2ω) optical excitation using input pulses with a bandwidth supporting sub-20-fs duration, yielding a continuous bandwidth exceeding 100 THz with no significant roll-off and a pulse energy of 360 nJ at a 1-kHz repetition rate. The key aspect in achieving this performance is an optimized geometry of the second-harmonic generation (SHG) crystal, producing a 2ω-field detuned from the second-harmonic of the ω-field, which promotes both a high polarization bandwidth and optimal ω-2ω temporal overlap in the plasma, as supported by theoretical results.

Characterizing large-area electro-optic crystals toward two-dimensional real-time terahertz imaging.

We have characterized the homogeneity of large-area (>10 mm x 10 mm) CdTe(110) and ZnTe(110) crystals using a raster electro-optic scanning method to assess their usability in two-dimensional electro-optic terahertz (THz) imaging with parallel read out. The spatial variation in the detected THz signal (at 0.2 and 0.

Synthesis, structure, photoluminescence and photoreactivity of 2,3-diphenyl-4-neopentyl-1-silacyclobut-2-enes.

A series of six 2,3-diphenyl-4-neopentyl-1-silacyclobut-2-enes with different 1,1-substituents has been prepared and characterized by single-crystal X-ray crystallography. These compounds possess a cis-stilbene-like chromophore involving also the four-membered ring, and exhibit a photophysical behavior similar to that of previously reported 1,2-diphenyl-cycloalkenes. This chromophore system is confirmed by a theoretical investigation of the electronic structure and excitation spectra.

Terahertz profilometry at 600 GHz with 0.5 microm depth resolution.

Characterization of the topography of materials by interferometry in the visible or near-IR wavelength regime becomes difficult or impossible if the surface is rough on the length scale of a tenth of the wavelength and more. In this case, THz radiation can provide an interesting alternative. We demonstrate heterodyne profilometry at 600 GHz as a method for the accurate determination of surface topography with an achievable expanded standard uncertainty of 0.

All-optoelectronic continuous-wave terahertz systems.

We discuss the optoelectronic generation and detection of continuous-wave terahertz (THz) radiation by the mixing of visible/near-infrared laser radiation in photoconductive antennas. We review attempts to reach higher THz output-power levels by reverting from mobility-lifetime-limited photomixers to transit-time-limited p-i-n photodiodes. We then describe our implementation of a THz spectroscopy and imaging-measurement system and demonstrate its imaging performance with several examples.

Terahertz-pulse generation by photoionization of air with laser pulses composed of both fundamental and second-harmonic waves.

Intense radiation in the terahertz (THz) frequency range can be generated by focusing of an ultrashort laser pulse composed of both a fundamental wave and its second-harmonic field into air, as reported previously by Cook et al. [Opt. Lett.

Neutrino oscillations.

The wave theory of light, and in particular the principle of interference, was formulated by Thomas Young in 1801. In the 20th century, the principle of interference was extended to the quantum mechanical wave functions describing matter. The phenomenon of quantum mechanical interference of different neutrino states, neutrino oscillations, has provided one of the most exciting developments in high energy particle physics of the last decade.

All-optoelectronic continuous wave THz imaging for biomedical applications.

We present an all-optoelectronic THz imaging system for ex vivo biomedical applications based on photomixing of two continuous-wave laser beams using photoconductive antennas. The application of hyperboloidal lenses is discussed. They allow for f-numbers less than 1/2 permitting better focusing and higher spatial resolution compared to off-axis paraboloidal mirrors whose f-numbers for practical reasons must be larger than 1/2.