Solid with infused reactive liquid (SWIRL): A novel liquid-based separation approach for effective CO capture.

Economical CO capture demands low-energy separation strategies. We use a liquid-infused surface (LIS) approach to immobilize reactive liquids, such as amines, on a textured and thermally conductive solid substrate with high surface-area to volume ratio (A/V) continuum geometry. The infused, micrometer-thick liquid retains that high A/V and directly contacts the gas phase, alleviating mass transport resistance typically encountered in mesoporous solid adsorbents.

Differences in the mechanics of takeoff in reverse and forward springboard somersaulting dives.

Forward and reverse springboard somersaulting dives use similar approaches with a hurdle step prior to the final board contact phase during which forward rotation is produced in forward takeoffs and backward rotation in reverse takeoffs. This study compared forward and reverse takeoffs for joint strength, activation complexity, technique kinematics, and rotation potential. A planar 8-segment torque-driven computer simulation model of springboard diving takeoff was used to determine isometric joint strength by matching performances of a forward 2½ somersault dive and a reverse 1½ somersault dive.

Comparing power hitting kinematics between skilled male and female cricket batters.

Organismic, task, and environmental constraints are known to differ between skilled male and female cricket batters during power hitting tasks. Despite these influences, the techniques used in such tasks have only been investigated in male cricket batters. This study compared power hitting kinematics between 15 male and 15 female batters ranging from university to international standard.

A lateral ankle sprain during a lateral backward step in badminton: A case report of a televised injury incident.

Background: This study presents a kinematic analysis of an acute lateral ankle sprain incurred during a televised badminton match. The kinematics of this injury were compared to those of 19 previously reported cases in the published literature.

Methods: Four camera views of an acute lateral ankle sprain incurred during a televised badminton match were synchronized and rendered in 3-dimensional animation software.

Scaling the cricket pitch to fit junior players.

Studies in several sports have shown the benefits of adapting the playing environment to fit junior players. Frequently the changes are pragmatic choices based on space constraints or existing line markings, or the result of simple scaling based on stature. In this study, a method of scaling the cricket pitch length is presented which is based on the age-specific size and performance of the bowlers and batters.

Effect of racket-shuttlecock impact location on shot outcome for badminton smashes by elite players.

A logarithmic curve fitting methodology for the calculation of badminton racket-shuttlecock impact locations from three-dimensional motion capture data was presented and validated. Median absolute differences between calculated and measured impact locations were 3.6 [IQR: 4.

Optimising the front foot contact phase of the cricket fast bowling action.

Cricket fast bowling is a dynamic activity in which a bowler runs up and repeatedly delivers the ball at high speeds. Experimental studies have previously linked ball release speed and several technique parameters with conflicting results. As a result, computer simulation models are increasingly being used to understand the effects of technique on performance.

Functional variability in the takeoff phase of one metre springboard forward dives.

In springboard diving consistency of body orientation at water entry is necessary for a good dive and is likely to be dependent on the consistency of conditions at takeoff. The aim of the present study was to investigate whether a diver modifies his technique from dive to dive during the board contact phase in order to be more consistent at takeoff in one metre springboard forward dives. Two-dimensional video analysis was used to calculate orientation and configuration angles of 12 forward pike dives and 12 forward 2½ somersault pike dives, performed by an international diver.

Passive range of motion of the hips and shoulders and their relationship with ball spin rate in elite finger spin bowlers.

Objectives: Investigate rotational passive range of motion of the hips and shoulders for elite finger spin bowlers and their relationship with spin rate.

Design: Correlational.

Methods: Spin rates and twelve rotational range of motion measurements for the hips and shoulders were collected for sixteen elite male finger spin bowlers.

A shorter cricket pitch improves decision-making by junior batters.

This study sought to determine whether playing on a shorter cricket pitch would lead batters to make more appropriate decisions about whether to play front foot or back foot shots. Based on an analysis of the shots played by top order batters against seam bowling in county under-10 matches, an age-specific "good length" region between 5.0 yards and 6.

Maximising forward somersault rotation in springboard diving.

Performance in the flight phase of springboard diving is limited by the amounts of linear and angular momentum generated during the takeoff phase. A planar 8-segment torque-driven simulation model combined with a springboard model was used to investigate optimum takeoff technique for maximising rotation in forward dives from the one metre springboard. Optimisations were run by varying the torque activation parameters to maximise forward rotation potential (angular momentum × flight time) while allowing for movement constraints, anatomical constraints, and execution variability.

Are Planar Simulation Models Affected by the Assumption of Coincident Joint Centers at the Hip and Shoulder?

Planar simulation models which assume coincident joint centers at the hip and shoulder are often used to investigate subject-specific maximal performances rather than 3-dimensional models due to the viability of determining subject-specific parameters. To investigate the effect of coincident joint centers on model accuracy, 3 variants of a 16-segment planar subject-specific angle-driven model were evaluated using an elite cricket fast bowling performance: (a) planar representation assuming coincident joint centers, (b) planar representation with noncoincident hip joint centers, and (c) planar representation with noncoincident hip and shoulder joint centers. Model (c) with noncoincident hip and shoulder joint centers best matched the recorded performance with better estimates of the ground reaction force (mean RMS differences: (a) 18%, (b) 12%, and (c) 11%) and ball release velocity (mean RMS differences: (a) 3.

Implementation of an Innovative Tablet-based Curriculum for Radiology Resident Education.

Rationale And Objectives: The aim of this study was to prospectively examine the impact of a tablet-based curriculum on the radiology resident educational experience.

Materials And Methods: A comprehensive tablet-based curriculum was developed by creating subspecialty modules with appropriate content level for each required rotation at our diagnostic radiology residency program. Daily assignments included key learning points, readings, and reference presentation slides, covering all objectives published by the ABR Core Exam Study Guide.

Functional variability in the flight phase of one metre springboard forward dives.

In springboard diving, low variability in takeoff conditions and in the somersault orientation angle at water entry is to be expected since consistency and accuracy are necessary for a good dive. A diver's adjustment of body configuration during flight may be a deliberate compensation for variations in takeoff conditions, leading to increased joint angle variability and decreased entry angle variability. The aim of this research was to investigate the extent to which a diver pre-plans the aerial phase and then makes adjustments in flight to control the entry angle in one metre springboard forward dives.

Does shortening the pitch make junior cricketers bowl better?

In order to get bounce and movement seam bowlers need to bowl the ball "into" the pitch. Standard deliveries by elite players are typically projected at around 7° below horizontal. In contrast, young players currently often need to release the ball almost horizontally in an effort to get the ball to bounce close enough to the batter.

The effect of increasing strength and approach velocity on triple jump performance.

The triple jump is an athletic event comprising three phases in which the optimal phase ratio (the proportion of each phase to the total distance jumped) is unknown. This study used a planar whole body torque-driven computer simulation model of the ground contact parts of all three phases of the triple jump to investigate the effect of strength and approach velocity on optimal performance. The strength and approach velocity of the simulation model were each increased by up to 30% in 10% increments from baseline data collected from a national standard triple jumper.

Risk Factors Associated With Quantitative Evidence of Lung Emphysema and Fibrosis in an HIV-Infected Cohort.

Introduction: The disease spectrum for HIV-infected individuals has shifted toward comorbid non-AIDS conditions including chronic lung disease, but quantitative image analysis of lung disease has not been performed.

Objectives: To quantify the prevalence of structural changes of the lung indicating emphysema or fibrosis on radiographic examination.

Methods: A cross-sectional analysis of 510 HIV-infected participants in the multicenter Lung-HIV study was performed.

Optimisation of phase ratio in the triple jump using computer simulation.

The triple jump is an athletic event comprising three phases in which the optimal proportion of each phase to the total distance jumped, termed the phase ratio, is unknown. This study used a whole-body torque-driven computer simulation model of all three phases of the triple jump to investigate optimal technique. The technique of the simulation model was optimised by varying torque generator activation parameters using a Genetic Algorithm in order to maximise total jump distance, resulting in a hop-dominated technique (35.

The effect of marker placement around the elbow on calculated elbow extension during bowling in cricket.

The elbow extension angle during bowling in cricket may be calculated from the positions of markers attached around the shoulder, elbow and wrist using an automated laboratory-based motion analysis system. The effects of two elbow-marker sets were compared. In the first, a pair of markers was placed medially and laterally close to the condyles while in the second a triad of markers was placed on the back of the upper arm close to the elbow.

Gender Differences in Pulmonary Function, Respiratory Symptoms, and Macrophage Proteomics among HIV-Infected Smokers.

Background. HIV-infected subjects have an increased incidence of pulmonary emphysema. There are known gender differences in COPD phenotypic expression and diagnosis, but this is not well characterized in lung disease related to HIV.

Trade-offs between horizontal and vertical velocities during triple jumping and the effect on phase distances.

The triple jump is an athletic event involving three ground contact phases during which athletes must trade off the maintenance of horizontal velocity against the generation of vertical velocity. Previous studies have indicated that individual athletes have a linear relationship between the loss in horizontal velocity and the gain in vertical velocity during each phase. This study used computer simulation to investigate the effects of constraining the takeoff velocities in the hop phase on the velocity trade-offs in this and subsequent phases.

An isovelocity dynamometer method to determine monoarticular and biarticular muscle parameters.

This study aimed to determine whether subject-specific individual muscle models for the ankle plantar flexors could be obtained from single joint isometric and isovelocity maximum torque measurements in combination with a model of plantar flexion. Maximum plantar flexion torque measurements were taken on one subject at six knee angles spanning full flexion to full extension. A planar three-segment (foot, shank and thigh), two-muscle (soleus and gastrocnemius) model of plantar flexion was developed.

Relationships between fast bowling technique and ball release speed in cricket.

The aim of this study was to identify the key aspects of technique that characterize the fastest bowlers. Kinematic data were collected for 20 elite male fast bowlers with 11 kinematic parameters calculated, describing elements of fast bowling technique that have previously been linked to ball release speed. Four technique variables were identified as being the best predictors of ball release speed, explaining 74% of the observed variation in ball release speed.

Are joint torque models limited by an assumption of monoarticularity?

This study determines whether maximal voluntary ankle plantar flexor torque could be more accurately represented using a torque generator that is a function of both knee and ankle kinematics. Isovelocity and isometric ankle plantar flexor torques were measured on a single participant for knee joint angles of 111° to 169° (approximately full extension) using a Contrex MJ dynamometer. Maximal voluntary torque was represented by a 19-parameter two-joint function of ankle and knee joint angles and angular velocities with the parameters determined by minimizing a weighted root mean square difference between measured torques and the two-joint function.

Quantitative computerized two-point correlation analysis of lung CT scans correlates with pulmonary function in pulmonary sarcoidosis.

Background: Chest CT scans are commonly used to clinically assess disease severity in patients presenting with pulmonary sarcoidosis. Despite their ability to reliably detect subtle changes in lung disease, the utility of chest CT scans for guiding therapy is limited by the fact that image interpretation by radiologists is qualitative and highly variable. We sought to create a computerized CT image analysis tool that would provide quantitative and clinically relevant information.