Characterization of Outer Insulation in Long-Term-Implanted Leads.

Success of pacemakers and implantable cardioverter defibrillators may be limited by premature lead failure. Lead insulation polymers, such as polyurethane (PU) and polydimethylsiloxane (PDMS), are reported to degrade over time in vivo. PU is known to undergo oxidation, whereas PDMS undergoes surface hydrolysis.

Effects of gamma and e-beam sterilization on the chemical, mechanical and tribological properties of a novel hydrogel.

Hydrogels are known to possess cartilage-like mechanical and lubrication properties; however, hydrogel sterilization is challenging. Cyborgel(™), a proprietary hydrogel, is intended for use as a cartilage replacement implant. This study evaluated the effect of 30-35 kGy e-beam and gamma radiation on the polymer swell ratio, and the mechanical, chemical and tribological behavior of this hydrogel.

Can pin-on-disk testing be used to assess the wear performance of retrieved UHMWPE components for total joint arthroplasty?

The objective of this study was to assess the suitability of using multidirectional pin-on-disk (POD) testing to characterize wear behavior of retrieved ultrahigh molecular weight polyethylene (UHMWPE). The POD wear behavior of 25 UHMWPE components, retrieved after 10 years in vivo, was compared with 25 that were shelf aged for 10-15 years in their original packaging. Components were gamma sterilized (25-40 kGy) in an air or reduced oxygen (inert) package.

Mechanically assisted taper corrosion in modular TKA.

The purpose of this study was to characterize the prevalence of taper damage in modular TKA components. One hundred ninety-eight modular components were revised after 3.9±4.