Bone regeneration by a bone substitute biomaterial containing hydroxyapatite, chitosan, xanthan and graphene oxide supplemented with conditioned medium from mesenchymal stem cells.

This study analyzed a recently developed bone substitute biomaterial made of chitosan-xanthanhydroxyapatite-graphene oxide (CXHAG). The CXHAG particles underwent in vitro structural and morphological characterization, and in vivo testing with or without osteogenic conditioned medium from mesenchymal stem cells. Aim: The aim of this study was to determine whether the CXHAG novel biomaterial, supplemented with conditioned medium from mesenchymal stem cells, could be useful for bone regeneration.

Conditioned Media from Human Pulp Stem Cell Cultures Improve Bone Regeneration in Rat Calvarial Critical-Size Defects.

The aim of this study was to test whether lyophilized conditioned media from human dental pulp mesenchymal stem cell cultures promote the healing of critical-size defects created in the calvaria of rats. Prior to the surgical procedure, the medium in which dental pulp stem cells were cultured was frozen and lyophilized. After general anesthesia, an 8 mm diameter bone defect was created in the calvaria of twenty-four rats.

In Vivo Evaluation of Collagen and Chitosan Scaffold, Associated or Not with Stem Cells, in Bone Repair.

Natural polymers are increasingly being used in tissue engineering due to their ability to mimic the extracellular matrix and to act as a scaffold for cell growth, as well as their possible combination with other osteogenic factors, such as mesenchymal stem cells (MSCs) derived from dental pulp, in an attempt to enhance bone regeneration during the healing of a bone defect. Therefore, the aim of this study was to analyze the repair of mandibular defects filled with a new collagen/chitosan scaffold, seeded or not with MSCs derived from dental pulp. Twenty-eight rats were submitted to surgery for creation of a defect in the right mandibular ramus and divided into the following groups: G1 (control group; mandibular defect with clot); G2 (defect filled with dental pulp mesenchymal stem cells-DPSCs); G3 (defect filled with collagen/chitosan scaffold); and G4 (collagen/chitosan scaffold seeded with DPSCs).

Short implants: Influence of different diameters, torques, and transmucosal heights of straight prosthetic abutments on screw preload loss after cycling.

This study evaluated the influence of different implant diameters, insertion torques, and transmucosal heights on the loosening of abutments installed on short implants, after mechanical cycling. The Morse taper connection implants (n = 96) tested were 5 mm high, divided according to the platform diameter: 4 or 6 mm. A universal abutment was coupled to each implant (with different transmucosal heights: 1 or 5 mm).

Stress distribution on implant- supported zirconia crown of maxillary first molar: effect of oblique load on natural and antagonist tooth.

This study evaluated the stress distribution on an implant-supported zirconia crown of a mandibular first molar subjected to oblique loading by occlusal contact with the natural maxillary first molar by using the 3D finite element method. Two virtual models were made to simulate the following situations: (1) occlusion between maxillary and mandibular natural first molars; (2) occlusion between zirconia implant-supported ceramic crown on a mandibular first molar and maxillary natural first molar. The models were designed virtually in a modeling program or CAD (Computer Aided Design) (Rhinoceros).

Horizontal Bone Augmentation With Autogenous and Collagenated Xenogeneic Bone Blocks: A Split-Mouth Prospective Clinical, Tomographic, and Histological Pilot Study.

The aim of this study was to compare the clinical, tomographic, and histological performance of collagenated xenogeneic bone blocks (CXBB) in horizontal bone augmentations for implant placement. Five patients with an absence of the 4 upper incisors and an HAC 3 horizontal bone defect, with a remaining of 3 to 5 mm, underwent a bone-grafting procedure with CXBB (test group [TG], n = 5) and autogenous graft (control group [CG], n = 5), with one type of graft used on the right side and other type on the left side. Changes in bone thickness and density (tomographic evaluation), levels of complications (clinically), and distribution pattern between mineralized and nonmineralized tissue (histomorphometrically) were analyzed.

Collagen-chitosan-hydroxyapatite composite scaffolds for bone repair in ovariectomized rats.

Lesions with bone loss may require autologous grafts, which are considered the gold standard; however, natural or synthetic biomaterials are alternatives that can be used in clinical situations that require support for bone neoformation. Collagen and hydroxyapatite have been used for bone repair based on the concept of biomimetics, which can be combined with chitosan, forming a scaffold for cell adhesion and growth. However, osteoporosis caused by gonadal hormone deficiency can thus compromise the expected results of the osseointegration of scaffolds.

Osteocalcin and Runx2 Expression in Anterior Maxillary Reconstructions Using Bone Xenografts Associated to Bone Marrow Aspirate Concentrate.

Background: It is known that a large number of mediators involved in osteogenesis can influence bone development and repair; however, whether these mediators could be used as markers of bone maturity has yet to be determined.

Aim: To evaluate the expression of osteocalcin (OC) and Runt-related transcription factor 2 (Runx2) in bone biopsies obtained during the reconstruction of atrophic anterior maxillae using particulate bone xenografts with or without association of autogenous bone marrow aspirate concentrate (BMAC).

Materials And Methods: Ten patients were distributed into two groups ( = 5), according to the type of grafting material used: Control group (CG), particulate bone xenograft alone, and test group (TG), particulate bone xenograft combined with BMAC.

In Vivo Study of Nasal Bone Reconstruction with Collagen, Elastin and Chitosan Membranes in Abstainer and Alcoholic Rats.

The aim of the present study was to evaluate the use of collagen, elastin, or chitosan biomaterial for bone reconstruction in rats submitted or not to experimental alcoholism. Wistar male rats were divided into eight groups, submitted to chronic alcohol ingestion (G5 to G8) or not (G1 to G4). Nasal bone defects were filled with clot in animals of G1 and G5 and with collagen, elastin, and chitosan grafts in G2/G6, G3/G7, and G4/G8, respectively.

Bone marrow aspirate concentrate and platelet-rich fibrin in fresh extraction sockets: A histomorphometric and immunohistochemical study in humans.

The aim of this study was to evaluate the level of mineralized tissue and expression of bone markers in sockets grafted with platelet-rich fibrin and bone marrow aspirate concentrate (BMAC). Patients requiring extraction of one maxillary anterior tooth were randomized into three groups. After tooth extraction, the sockets in the control group (CG) were permitted to fill with blood clot.

Can Finger-Generated Force Be Used Reliably to Connect the Transducer for Resonance Frequency Analysis in Determining Implant Stability?

Purpose: The purpose of this study was to determine the minimum torque required to attach the transducer to the implant to measure the implant stability quotient (ISQ) with two different devices and to estimate if finger-generated torque would be reliable for this purpose.

Materials And Methods: One hundred implants were inserted into a uniform polyurethane block. The implants were distributed into 10 groups, with 10 implants each.

Is there a need for standardization of tightening force used to connect the transducer for resonance frequency analysis in determining implant stability?

Purpose: The purpose of this in vitro study was to determine the minimum installation torque required to attach the transducer (measuring peg) to the implant to provide an accurate assessment of implant stability using resonance frequency analysis.

Materials And Methods: One hundred 4 ×11-mm screw-shaped titanium implants were inserted into a uniform polyurethane block with similar density to bone in a standardized surgical protocol. The implants were distributed into 10 groups, with 10 implants each (G1 to G10).

Horizontal Bone Reconstruction on sites with different amounts of native bone: a retrospective study.

The lack of guidelines for bone augmentation procedures might compromise decision making in implantology. The objective of this study was to perform a retrospective study to verify the outcomes of horizontal bone reconstruction in implant dentistry with different types of materials and amounts of native bone in the recipient bed to allow for a new guideline for horizontal bone reconstruction. One hundred preoperative CT scans were retrospectively evaluated and categorized in accordance to horizontal bone defects as presence (Group P) or absence (Group A) of cancellous bone in the recipient bed.

Distribution of stress on TMJ disc induced by use of chincup therapy: assessment by the finite element method.

Objective: To assess the distribution of stress produced on TMJ disc by chincup therapy, by means of the finite element method.

Methods: a simplified three-dimensional TMJ disc model was developed by using Rhinoceros 3D software, and exported to ANSYS software. A 4.

Use of Bone Allograft With or Without Bone Marrow Aspirate Concentrate in Appositional Reconstructions: A Tomographic and Histomorphometric Study.

Objectives: To evaluate bone allograft associated to bone marrow aspirate concentrate (BMAC), in maxillary reconstructions.

Materials And Methods: Ten patients with alveolar bone deficiency in the anterior maxilla were randomly divided into control group (CG) and test group (TG). A bone block allograft was placed in both groups, but the graft was impregnated with BMAC only in TG.

Comparative Study Between Mesenchymal Stem Cells Derived from Bone Marrow and from Adipose Tissue, Associated with Xenograft, in Appositional Reconstructions: Histomorphometric Study in Rabbit Calvaria.

Purpose: This study analyzed the use of bone marrow-derived mesenchymal stem cells and adipose tissue-derived stem cells, associated with xenograft, in appositional reconstructions in rabbit calvaria using histomorphometry.

Materials And Methods: Fifteen New Zealand rabbits, weighing 3.5 to 4.

Homologous transplantation with fresh frozen bone for dental implant placement can induce HLA sensitization: a preliminary study.

It has been related in orthopedic surgeries the HLA sensitization. Thus, we evaluate if the use of fresh-frozen homologous bone (FFHB) for dental implant placement induce anti-HLA sensitization. Six patients were treated with FFHB corticocancellous block grafts.

Can bone marrow aspirate concentrate change the mineralization pattern of the anterior maxilla treated with xenografts? A preliminary study.

Objective: To evaluate bony reconstruction of the atrophic anterior maxilla using particulate grafts with or without autologous bone marrow aspirate concentrate (BMAC).

Materials And Methods: Eight patients with atrophy of the anterior maxilla due to teeth loss were selected and split into groups according to the type of material used: Control Group (CG) (n = 4) - particulate xenograft only and Test Group (TG) (n = 4) - a combination of particulate xenograft and BMAC. Both groups received a collagen membrane to cover the xenograft.

Predictable Outcomes with Porcelain Laminate Veneers: A Clinical Report.

This clinical report describes how to achieve predictable outcomes for anterior teeth esthetic restorations with porcelain laminate veneers by associating the digital planning and design of the restoration with interim restorations. The previous digital smile design of the restoration eliminates the communication barrier with the patient and assists the clinician throughout patient treatment. Interim restorations (diagnostic mock-ups) further enhance communication with the patient and prevent unnecessary tooth reduction for conservative tooth preparation.

Maxillary Sinus Augmentation Combining Bio-Oss with the Bone Marrow Aspirate Concentrate: A Histomorphometric Study in Humans.

Purpose. To investigate the regenerative results obtained with the association of bone marrow aspirate concentrate using the Bone Marrow Aspirate Concentrate (BMAC) method to a xenogeneic bone graft (Bio-Oss) in sinus floor elevation. Materials and Methods.

Prospective study of a group of pre-university students evaluating anxiety and depression relationships with temporomandibular disorders.

Objectives: The aim of this prospective longitudinal study was to evaluate the relationships between anxiety, depression, and temporomandibular disorders (TMD) in a sample of pre-university students submitted to a stressful event.

Study Design: 153 students from a pre-university course (82 females and 71 males between 16 and 31 years old) were given a survey about TMD symptoms and a survey about anxiety and depression scale at the beginning and the end of the preparatory course (August 2009-T1, and November 2009-T2).

Results: Results were analyzed using a chi-square test and Odds Ratio (OR), significance level of α = 0.

Effect of gender, experience, and value on color perception.

Statement Of The Problem: Precise shade matching can be one of the most difficult tasks for the dentist and some variables may influence the process of shade comparison.

Purpose Of The Study: This study tested the differences in shade perception between genders, the influence of the observer's clinical experience, and the value of ceramics in correct shade selection.

Material And Methods: A total of 45 women and 54 men compared 16 pairs of ceramic disks according to shades.