The effect of lithium intercalation on the electronic structure of the ternary compound semiconductors ZrSe(2-x)S(x).

The electronic properties of the lithium intercalated layered transition metal dichalcogenide semiconductors ZrS(x)Se(2-x) for x = 0-2 have been calculated by density functional theory (DFT) using the WIEN2k code. The calculations have been carried out by the PBE functional and the TB-MBJ potential as proposed by Tran and Blaha. The calculations have been performed with and without spin-orbit coupling and reveal that the intercalation of lithium causes the conduction bands of LiZrS(x)Se(2-x) to shift by about 2 eV towards lower binding energy.

Myocardial perfusion reserve assessed by T2-prepared steady-state free precession blood oxygen level-dependent magnetic resonance imaging in comparison to fractional flow reserve.

Background: Blood oxygen level-dependent (BOLD) cardiac magnetic resonance imaging (CMR) has been shown to be able to detect myocardial perfusion differences. However, validation of BOLD CMR against fractional flow reserve (FFR) is lacking. The aim of our study was to analyze the potential diagnostic accuracy of BOLD CMR in comparison to invasively measured FFR, which served as gold standard for a hemodynamic significant coronary lesion.

Charge-density-wave phase of 1T-TiSe2: the influence of conduction band population.

The charge-density-wave phase of TiSe(2) was studied by angle-resolved photoelectron spectroscopy and resistivity measurements investigating the influence of the band gap size and of a varying population of the conduction band. A gradual suppression of the charge-density-wave-induced electronic superstructure is observed for a variation of the band gap in the ternary compounds TiC(x)Se(2-x) with C=(S,Te) as well as for an occupation of only the conduction band by H(2)O adsorption-induced band bending. These observations point to an optimum band gap and support an excitonic driving force for the charge-density wave.

Acceleration of tissue phase mapping with sensitivity encoding at 3T.

Background: The objective of this study was to investigate the impact of sensitivity encoding on the quantitative assessment of cardiac motion in black blood cine tissue phase mapping (TPM) sequences. Up to now whole volume coverage of the heart is still limited by the long acquisition times. Therefore, a significant increase in imaging speed without deterioration of quantitative motion information is indispensable.

Absence of left ventricular apical rocking and atrial-ventricular dyssynchrony predicts non-response to cardiac resynchronization therapy.

Aims: Current imaging techniques attempt to identify responders to cardiac resynchronization therapy (CRT). However, because CRT response may depend upon several factors, it may be clinically more useful to identify patients for whom CRT would not be beneficial even under optimal conditions. We aimed to determine the negative predictive value of a composite echocardiographic index evaluating atrial-ventricular dyssynchrony (AV-DYS) and intraventricular dyssynchrony.

SAR reduced black-blood cine TPM for increased temporal resolution at 3T.

Object: The objective was to improve the temporal resolution in black-blood CINE tissue phase mapping sequences at high field MR systems. The temporal resolution is limited due to SAR constraints causing idle times into the sequence. The aim was to avoid these idle times and therefore providing an increased number of heart phases.

Acceleration of tissue phase mapping by k-t BLAST: a detailed analysis of the influence of k-t-BLAST for the quantification of myocardial motion at 3T.

Background: The assessment of myocardial motion with tissue phase mapping (TPM) provides high spatiotemporal resolution and quantitative motion information in three directions. Today, whole volume coverage of the heart by TPM encoding at high spatial and temporal resolution is limited by long data acquisition times. Therefore, a significant increase in imaging speed without deterioration of the quantitative motion information is required.

Assessment of the coronary venous system in heart failure patients by blood pool agent enhanced whole-heart MRI.

Objective: To investigate the feasibility of MRI for non-invasive assessment of the coronary sinus (CS) and the number and course of its major tributaries in heart failure patients.

Methods: Fourteen non-ischaemic heart failure patients scheduled for cardiac resynchronisation therapy (CRT) underwent additional whole-heart coronary venography. MRI was performed 1 day before device implantation.

Automatic segmentation of rotational x-ray images for anatomic intra-procedural surface generation in atrial fibrillation ablation procedures.

Since the introduction of 3-D rotational X-ray imaging, protocols for 3-D rotational coronary artery imaging have become widely available in routine clinical practice. Intra-procedural cardiac imaging in a computed tomography (CT)-like fashion has been particularly compelling due to the reduction of clinical overhead and ability to characterize anatomy at the time of intervention. We previously introduced a clinically feasible approach for imaging the left atrium and pulmonary veins (LAPVs) with short contrast bolus injections and scan times of approximately 4 -10 s.

Blood oxygen level-dependent magnetic resonance imaging using T2-prepared steady-state free-precession imaging in comparison to contrast-enhanced myocardial perfusion imaging.

Background: Diagnosis of inducible myocardial ischemia is important for deciding further diagnosis and therapy in coronary artery disease (CAD). Blood oxygen level-dependent (BOLD) cardiac magnetic resonance imaging (CMR) is a potential method to evaluate myocardial perfusion reserve alternatively to first-pass perfusion using contrast agents.

Methods And Results: We imaged 46 patients with suspected CAD on a 1.

1T-TiSe2: semimetal or semiconductor?

Even though the semimetallic behavior of 1T-TiSe2 seemed to be well established by band structure calculations and photoemission results, this conclusion has been challenged recently. Two high-resolution photoemission investigations deduced semiconducting behavior, however with a very small band gap. Such conclusion from photoemission is afflicted, in principle, by the problem of determining an unoccupied conduction band by photoemission.

Automatic intra-operative generation of geometric left atrium/pulmonary vein models from rotational X-ray angiography.

Pre-procedural imaging with cardiac CT or MR has become popular for guiding complex electrophysiology procedures such as those used for atrial fibrillation ablation therapy. Electroanatomical mapping and ablation within the left atrium and pulmonary veins (LAPV) is facilitated using such data, however the pre-procedural anatomy can be quite different from that at the time of intervention. Recently, a method for intra-procedural LAPV imaging has been developed based on contrast-enhanced 3-D rotational X-ray angiography (3-D RA).

Estimation of radial strain and rotation using a new algorithm based on speckle tracking.

Background: The aim of this study was to test the ability of a new algorithm to accurately measure point-to-point Lagrangian strain (LS) and local rotation (ROT). Change in distance between 2 separate regions of interest (ROIs) can theoretically be computed with speckle tracking (SpT) and used to calculate LS in any tissue location with angle independence and high spatial resolution. Similarly, tracking an ROI relative to a fixed point should provide an estimate of ROT.

Intraprocedural volume imaging of the left atrium and pulmonary veins with rotational X-ray angiography: implications for catheter ablation of atrial fibrillation.

Introduction: The use of preprocedural CT or MR imaging to generate patient-specific cardiac anatomy greatly facilitates catheter ablation of the left atrium and pulmonary veins (LA-PVs) to treat atrial fibrillation (AF). This report details the accuracy and utility of an intraprocedural means to generate 3-D volumetric renderings of the LA-PV anatomy: contrast-enhanced rotational X-ray angiography (3DRA).

Methods And Results: Preprocedural CT or MR imaging and intraprocedural rotational angiography was performed in 42 patients undergoing AF ablation procedures.

Usefulness of high-speed rotational coronary venous angiography during cardiac resynchronization therapy.

Standard coronary venous angiography (SCVA) provides a static, fixed projection of the coronary venous (CV) tree. High-speed rotational coronary venous angiography (RCVA) is a novel method of mapping CV anatomy using dynamic, multiangle visualization. The purpose of this study was to assess the value of RCVA during cardiac resynchronization therapy.

Integrating functional and anatomical information to facilitate cardiac resynchronization therapy.

Multiple imaging modalities are required in patients receiving cardiac resynchronization therapy. We have developed a strategy to integrate echocardiographic and angiographic information to facilitate left ventricle (LV) lead position. Full three-dimensional LV-volumes (3DLVV) and dyssynchrony maps were acquired before and after resynchronization.

Intra-operative volume imaging of the left atrium and pulmonary veins with rotational X-ray angiography.

Complex electrophysiology (EP) procedures, such as catheter-based ablation in the left atrium and pulmonary veins (LAPV) for treatment of atrial fibrillation, require knowledge of heart chamber anatomy. Electroanatomical mapping (EAM) is typically used to define cardiac structures by combining electromagnetic spatial catheter localization with surface models which interpolate the anatomy between EAM point locations in 3D. Recently, the incorporation of pre-operative volumetric CT or MR data sets has allowed for more detailed maps of LAPV anatomy to be used intra-operatively.

Automatic determination of minimal cardiac motion phases for computed tomography imaging: initial experience.

Low motion phases for cardiac computed tomography reconstructions are currently detected manually in a user-dependent selection process which is often time consuming and suboptimal. The concept of motion maps was recently introduced to achieve automatic phase selection. This pilot study compared the accuracy of motion-map phase selection to that with manual iterative selection.

Cardiac cone-beam CT volume reconstruction using ART.

Modern computed tomography systems allow volume imaging of the heart. Up to now, approximately two-dimensional (2D) and 3D algorithms based on filtered backprojection are used for the reconstruction. These algorithms become more sensitive to artifacts when the cone angle of the x-ray beam increases as it is the current trend of computed tomography (CT) technology.

Helical cardiac cone beam CT reconstruction with large area detectors: a simulation study.

Retrospectively gated cardiac volume CT imaging has become feasible with the introduction of heart rate adaptive cardiac CT reconstruction algorithms. The development in detector technology and the rapid introduction of multi-row detectors has demanded reconstruction schemes which account for the cone geometry. With the extended cardiac reconstruction (ECR) framework, the idea of approximate helical cone beam CT has been extended to be used with retrospective gating, enabling heart rate adaptive cardiac cone beam reconstruction.

Evaluation of spatial and temporal resolution for ECG-gated 16-row multidetector CT using a dynamic cardiac phantom.

Measurements of spatial and temporal resolution for ECG-gated scanning of a stationary and moving heart phantom with a 16-row MDCT were performed. A resolution phantom with cylindrical holes from 0.4 to 3.

Automatic phase determination for retrospectively gated cardiac CT.

The recent improvements in CT detector and gantry technology in combination with new heart rate adaptive cone beam reconstruction algorithms enable the visualization of the heart in three dimensions at high spatial resolution. However, the finite temporal resolution still impedes the artifact-free reconstruction of the heart at any arbitrary phase of the cardiac cycle. Cardiac phases must be found during which the heart is quasistationary to obtain outmost image quality.

Noninvasive coronary angiography with 16-detector row CT: effect of heart rate.

Purpose: To evaluate the effect of heart rate on the quality of coronary angiograms obtained with 16-detector row computed tomography (CT) by using temporally enhanced three-dimensional (3D) approaches.

Materials And Methods: The local ethics committee approved the study, and informed consent was obtained from all patients. Fifty patients underwent coronary CT angiography (heart rate range, 45-103 beats per minute).