Evaluating the Efficacy of Pre-Emptive Peribulbar Blocks with Different Local Anesthetics or Paracetamol Using the Adequacy of Anesthesia Guidance for Vitreoretinal Surgeries: A Preliminary Report.

Background/objectives: Precisely selected patients require vitreoretinal surgeries (VRS) performed under general anesthesia (GA) when intravenous rescue opioid analgesics (IROA) are administered intraoperatively, despite a risk of adverse events, to achieve hemodynamic stability and proper antinociception and avoid the possibility of intolerable postoperative pain perception (IPPP). Adequacy of anesthesia guidance (AoA) optimizes the titration of IROA. Preventive analgesia (PA) techniques and intravenous or preoperative peribulbar block (PBB) using different local anesthetics (LAs) are performed prior to GA to optimize IROA.

The analysis of e-liquids: A study on chemical diversity and metal content using gas chromatography-mass spectrometry and inductively coupled plasma-mass spectrometry.

This work aimed to determine the chemical composition of 22 e-liquids available on the Slovenian market. Four different gas chromatography (GC) sample introduction techniques; headspace-GC-mass spectrometry (HS-GC-MS), liquid injection-GC-MS (LI-GC-MS), HS-solid-phase microextraction-GC-MS (HS-SPME-GC-MS), and direct-immersion-SPME-GC-MS (DI-SPME-GC-MS) were employed for qualitative analysis. Various experimental parameters were assessed for each GC sample introduction technique to maximize compound identification.

Optimizing carry-over in automated dissolution system dissoBOT for paracetamol and diclofenac sodium analysis.

In this work, an automated dissolution system (dissoBOT) was used for dissolution testing for the first time. Carry-over (CO) of the dissoBOT was determined for paracetamol (PA) and diclofenac sodium (DS), which are active pharmaceutical ingredients (APIs). Initially, partial method validation of the UV-VIS spectrophotometry method for PA and DS determination was performed by defining the limit of detection (LOD), the limit of quantification (LOQ), linear concentration range, accuracy, and precision.

Preparation of Food Samples Using Homogenization and Microwave-Assisted Wet Acid Digestion for Multi-Element Determination with ICP-MS.

Sample preparation is crucial for elemental determination, and various techniques are available, one of which involves homogenization followed by acid digestion. Special care is required during sample handling in the preparation stage to eliminate or minimize potential contamination and analyte loss. Homogenization is a process that simultaneously reduces particle size and uniformly distributes sample components.

The development of an electropolymerized, molecularly imprinted polymer (MIP) sensor for insulin determination using single-drop analysis.

An electrochemical sensor for the detection of insulin in a single drop (50 μL) was developed based on the concept of molecularly imprinted polymers (MIP). The synthetic MIP receptors were assembled on a screen-printed carbon electrode (SPCE) by the electropolymerization of pyrrole (Py) in the presence of insulin (the protein template) using cyclic voltammetry. After electropolymerization, insulin was removed from the formed polypyrrole (Ppy) matrix to create imprinting cavities for the subsequent analysis of the insulin analyte in test samples.

The Effect of Preconditioning Strategies on the Adsorption of Model Proteins onto Screen-Printed Carbon Electrodes.

The preconditioning and modification of the supporting electrode surface is an essential step in every biosensor architecture. In particular, when using screen-printed carbon electrodes (SPEs) as inexpensive and convenient disposable sensor substrates, their somewhat lower electrochemical (surface) reproducibility might represent a complex hurdle. Herein, we investigated the effect of selected preconditioning strategies, such as cyclic voltammetric pretreatment, in HSO and HO and plasma pretreatment with a positive and negative glow discharge, which all improved the electrochemical stability of the unmodified SPEs.

Single-Drop Analysis of Epinephrine and Uric Acid on a Screen-Printed Carbon Electrode.

This work demonstrates the analysis of epinephrine (EP) and uric acid (UA) in a single drop (the volume of the test solution was only 50 µL) using a screen-printed carbon electrode (SPCE) sensor and square-wave voltammetry (SWV). The limit of detection, limit of quantification, linearity, accuracy, precision, and robustness were validated. The normality of the experimental data was tested and confirmed for both methods.

General health condition of patients hospitalized after an incident of in-hospital or out-of hospital sudden cardiac arrest with return of spontaneous circulation.

Background: Sudden cardiac arrest (SCA) is one of the main reasons for admission to the intensive care unit (ICU), which influences discharge in a good neurological state.

Hypothesis: To analyze patients who had recovery of spontaneous circulation (ROSC) during hospitalization in the ICU using the Glasgow Outcome Scale (GOS).

Methods: The study group comprised 78 patients after SCA (35 after out-of-hospital cardiac arrest [OHCA] and 43 after in-hospital cardiac arrest [IHCA]) with ROSC who were admitted to the ICU of Regional Hospital No.

An Advanced Statistical Approach Using Weighted Linear Regression in Electroanalytical Method Development for Epinephrine, Uric Acid and Ascorbic Acid Determination.

In this study, the use of weighted linear regression in the development of electrochemical methods for the determination of epinephrine (EP), ascorbic acid (AA), and uric acid (UA) is presented. The measurements were performed using a glassy carbon electrode and square-wave voltammetry (SWV). All electroanalytical methods were validated by determination of the limit of detection, limit of quantification, linear concentration range, accuracy, and precision.

Reusability of SPE and Sb-modified SPE Sensors for Trace Pb(II) Determination.

In this work, unmodified screen-printed electrode (bare SPE) and Sb-film modified SPE (SbFSPE) sensors were employed for the analysis of trace amounts of Pb(II) in non-deaerated water solutions. The modified electrode was performed in situ in 0.5 mg/L Sb(III) and 0.

Femtosecond pulse-shape modulation at nanosecond rates.

We report high-rate, computer-controlled femtosecond pulse shaping by use of an electro-optical gallium arsenide optical phased-array modulator with 2304 controlled waveguides. It provides fast modulation speed of both spectral phases and amplitudes. Limited by the driving electronics of our current setup, we were able to update a pulse shape in approximately 30 ns.

Electron photodetachment cross sections of small carbon clusters: evidence for nonlinear isomers.

Absolute cross sections for photodetachment of negative carbon clusters are reported for Cn (n = 3, ...