Chemicals of emerging concern in coastal aquifers: Assessment along the land-ocean interface.

Submarine Groundwater Discharge (SGD) is recognized as a relevant source of pollutants to the sea, but little is known about its relevance as a source of chemicals of emerging concern (CECs). Here, both the presence and distribution of a wide range of CECs have been evaluated in the most comprehensive manner to date, in a well-characterized Mediterranean coastal aquifer near Barcelona (Spain). Samples from coastal groundwater and seawater allowed for the unique spatial characterization of the pollutants present in the land-ocean interface, an outstanding research gap that required attention.

Tritium transport in non-saturated concrete under temperature fluctuations.

This work studies the effect of the environmental conditions on tritium transport in concrete cells storing radioactive waste. Water with high concentration of tritium was leaking from drains situated in these concrete cells, which indicates flow of water and tritium transport in these cells. 2D numerical models together with temperature and humidity measurements suggested that this leak of tritiated water is caused by a combination of thermo-hydraulic processes occurring in the unsaturated concrete, that comprise capillary rise from the groundwater, evaporation and condensation due to temperature gradients caused by seasonal temperature fluctuations outside.

Vapor flow control in dune sediments under dry bare soil conditions.

The study presents daily values of inward and outward vapor flux crossing the soil-atmosphere boundary in dependence on meteorological parameters and soil moisture. Measurements of vapor flux, soil moisture and meteorological parameters were evaluated during days without rainfall between 2015 and 2019. Vapor flux data were obtained at 1 min intervals by a precision lysimeter installed in the Doñana National Park, southwest Spain.

Evaluation of self-combustion risk in tire derived aggregate fills.

Lightweight tire derived aggregate (TDA) fills are a proven recycling outlet for waste tires, requiring relatively low cost waste processing and being competitively priced against other lightweight fill alternatives. However its value has been marred as several TDA fills have self-combusted during the early applications of this technique. An empirical review of these cases led to prescriptive guidelines from the ASTM aimed at avoiding this problem.

Bacterial transformation and biodegradation processes simulation in horizontal subsurface flow constructed wetlands using CWM1-RETRASO.

The performance and reliability of the CWM1-RETRASO model for simulating processes in horizontal subsurface flow constructed wetlands (HSSF CWs) and the relative contribution of different microbial reactions to organic matter (COD) removal in a HSSF CW treating urban wastewater were evaluated. Various different approaches with diverse influent configurations were simulated. According to the simulations, anaerobic processes were more widespread in the simulated wetland and contributed to a higher COD removal rate [72-79%] than anoxic [0-1%] and aerobic reactions [20-27%] did.

Experimental and modeling investigation of multicomponent reactive transport in porous media.

We present an experimental and modeling study of solute transport in porous media in the presence of mixing-induced precipitation of a solid phase. Conservative and reactive transport experiments were performed in a quasi-two-dimensional laboratory flow cell, filled with homogeneous and heterogeneous porous media. Conservative experiments were performed by injecting solutions containing sodium chloride and calcium chloride into the domain.

Analysis of a deep well recharge experiment by calibrating a reactive transport model with field data.

This paper describes the modeling of the hydrogeochemical effects of deep well recharge of oxic water into an anoxic pyrite-bearing aquifer. Kinetic expressions have been used for mineral dissolution-precipitation rates and organic matter oxidation. Hydrological and chemical parameters of the model were calibrated to field measurements.