Planar waveguide to vertical mode couplers covering the visible to IR spectral range.

Planar 45 turning mirrors with metal coating embedded in SU8 polymer waveguides enable waveguide to vertical mode coupling across a broad range of wavelengths from the visible to IR. The fabrication of these 2.5D structures is achieved using relatively simple grayscale lithography in thin film resists, compatible with standard planar lithography methods.

High speed single pixel imaging using a microLED-on-CMOS light projector.

Achieving high frame-rate operation in single pixel imaging schemes normally demands significant compromises in the flexibility of the imaging system, requiring either complex optical setups or a hardware-limited pattern mask set. Here, we demonstrate a single pixel imaging capability with pattern frame-rates approaching 400 kfps with a recently developed microLED light projector and an otherwise simple optical setup. The microLED array has individually addressable pixels and can operate significantly faster than digital micromirror devices, allowing flexibility with regards to the pattern masks employed for imaging even at the fastest frame-rates.

optogenetics using a Utah Optrode Array with enhanced light output and spatial selectivity.

Optogenetics allows the manipulation of neural circuitswith high spatial and temporal precision. However, combining this precision with control over a significant portion of the brain is technologically challenging (especially in larger animal models).Here, we have developed, optimised, and tested, the Utah Optrode Array (UOA), an electrically addressable array of optical needles and interstitial sites illuminated by 181LEDs and used to optogenetically stimulate the brain.

Simultaneous mapping of cathodoluminescence spectra and backscatter diffraction patterns in a scanning electron microscope.

Electron backscatter diffraction and cathodoluminescence are complementary scanning electron microscopy modes widely used in the characterisation of semiconductor films, respectively revealing the strain state of a crystalline material and the effect of this strain on the light emission from the sample. Conflicting beam, sample and detector geometries have meant it is not generally possible to acquire the two signals together during the same scan. Here, we present a method of achieving this simultaneous acquisition, by collecting the light emission through a transparent sample substrate.

Spectral characterization of a blue light-emitting micro-LED platform on skin-associated microbial chromophores.

The therapeutic application of blue light (380 - 500nm) has garnered considerable attention in recent years as it offers a non-invasive approach for the management of prevalent skin conditions including acne vulgaris and atopic dermatitis. These conditions are often characterised by an imbalance in the microbial communities that colonise our skin, termed the skin microbiome. In conditions including acne vulgaris, blue light is thought to address this imbalance through the selective photoexcitation of microbial species expressing wavelength-specific chromophores, differentially affecting skin commensals and thus altering the relative species composition.

optogenetics using a Utah Optrode Array with enhanced light output and spatial selectivity.

Optogenetics allows manipulation of neural circuits with high spatial and temporal precision. However, combining this precision with control over a significant portion of the brain is technologically challenging (especially in larger animal models). Here, we have developed, optimised, and tested in vivo, the Utah Optrode Array (UOA), an electrically addressable array of optical needles and interstitial sites illuminated by 181 µLEDs and used to optogenetically stimulate the brain.

An optrode array for spatiotemporally-precise large-scale optogenetic stimulation of deep cortical layers in non-human primates.

Optogenetics has transformed studies of neural circuit function, but remains challenging to apply to non-human primates (NHPs). A major challenge is delivering intense, spatiotemporally-precise, patterned photostimulation across large volumes in deep tissue. Such stimulation is critical, for example, to modulate selectively deep-layer corticocortical feedback circuits.

Waveguide-Integrated Colloidal Nanocrystal Supraparticle Lasers.

Supraparticle (SP) microlasers fabricated by the self-assembly of colloidal nanocrystals have great potential as coherent optical sources for integrated photonics. However, their deterministic placement for integration with other photonic elements remains an unsolved challenge. In this work, we demonstrate the manipulation and printing of individual SP microlasers, laying the foundation for their use in more complex photonic integrated circuits.

Additive GaN Solid Immersion Lenses for Enhanced Photon Extraction Efficiency from Diamond Color Centers.

Effective light extraction from optically active solid-state spin centers inside high-index semiconductor host crystals is an important factor in integrating these pseudo-atomic centers in wider quantum systems. Here, we report increased fluorescent light collection efficiency from laser-written nitrogen-vacancy (NV) centers in bulk diamond facilitated by micro-transfer printed GaN solid immersion lenses. Both laser-writing of NV centers and transfer printing of micro-lens structures are compatible with high spatial resolution, enabling deterministic fabrication routes toward future scalable systems development.

MicroLED biosensor with colloidal quantum dots and smartphone detection.

A fluorescence sensor with the capability for spatially multiplexed measurements utilizing smartphone detection is presented. Bioconjugated quantum dots are used as the fluorescent tag and are excited using a blue-emitting microLED (µLED). The 1-dimensional GaN µLED array is butt-coupled to one edge of the glass slide to take advantage of total internal reflection fluorescence (TIRF) principles.

Hundred-meter Gb/s deep ultraviolet wireless communications using AlGaN micro-LEDs.

We demonstrate the use of deep ultraviolet (DUV) micro-light-emitting diodes (LEDs) for long-distance line-of-sight optical wireless communications. With a single 285 nm-emitting micro-LED, we have respectively achieved data rates greater than 6.5 Gb/s at a distance of 10 m and 4 Gb/s at 60 m.

A Warhead Substitution Study on the Coronavirus Main Protease Inhibitor Nirmatrelvir.

The SARS-CoV-2 pandemic is currently causing an unprecedented global health emergency since its emergence in December 2019. In December 2021, the FDA granted emergency use authorization to nirmatrelvir, a SARS-CoV-2 main protease inhibitor, for treating infected patients. This peptidomimetic is designed with a nitrile warhead, which forms a covalent bond to the viral protease.

High precision integrated photonic thermometry enabled by a transfer printed diamond resonator on GaN waveguide chip.

We demonstrate a dual-material integrated photonic thermometer, fabricated by high accuracy micro-transfer printing. A freestanding diamond micro-disk resonator is printed in close proximity to a gallium nitride on a sapphire racetrack resonator, and respective loaded Q factors of 9.1 × 10 and 2.

Combining time of flight and photometric stereo imaging for 3D reconstruction of discontinuous scenes.

Time of flight and photometric stereo are two three-dimensional (3D) imaging techniques with complementary properties, where the former can achieve depth accuracy in discontinuous scenes, and the latter can reconstruct surfaces of objects with fine depth details and high spatial resolution. In this work, we demonstrate the surface reconstruction of complex 3D fields with discontinuity between objects by combining the two imaging methods. Using commercial LEDs, a single-photon avalanche diode camera, and a mobile phone device, high resolution of surface reconstruction is achieved with a RMS error of 6% for an object auto-selected from a scene imaged at a distance of 50 cm.

High-sensitivity inter-satellite optical communications using chip-scale LED and single-photon detector hardware.

Small satellites have challenging size weight and power requirements for communications modules, which we address here by using chip-scale light-emitting diode (LED) transmitters and single-photon avalanche diode receivers. Data rates of 100 Mb/s have been demonstrated at a sensitivity of -55.2 dBm, and simulations with supporting experimental work indicate ranges in excess of 1 km are feasible with a directional gain of up to 52 dBi and comparatively modest pointing requirements.

Synchronization-free top-down illumination photometric stereo imaging using light-emitting diodes and a mobile device.

Three dimensional reconstruction of objects using a top-down illumination photometric stereo imaging setup and a hand-held mobile phone device is demonstrated. By employing binary encoded modulation of white light-emitting diodes for scene illumination, this method is compatible with standard lighting infrastructure and can be operated without the need for temporal synchronization of the light sources and camera. The three dimensional reconstruction is robust to unmodulated background light.

Automated Nanoscale Absolute Accuracy Alignment System for Transfer Printing.

The heterogeneous integration of micro- and nanoscale devices with on-chip circuits and waveguide platforms is a key enabling technology, with wide-ranging applications in areas including telecommunications, quantum information processing, and sensing. Pick and place integration with absolute positional accuracy at the nanoscale has been previously demonstrated for single proof-of-principle devices. However, to enable scaling of this technology for realization of multielement systems or high throughput manufacturing, the integration process must be compatible with automation while retaining nanoscale accuracy.

High-Throughput Electrical Characterization of Nanomaterials from Room to Cryogenic Temperatures.

We present multiplexer methodology and hardware for nanoelectronic device characterization. This high-throughput and scalable approach to testing large arrays of nanodevices operates from room temperature to milli-Kelvin temperatures and is universally compatible with different materials and integration techniques. We demonstrate the applicability of our approach on two archetypal nanomaterials-graphene and semiconductor nanowires-integrated with a GaAs-based multiplexer using wet or dry transfer methods.

Gigabit per second visible light communication based on AlGaInP red micro-LED micro-transfer printed onto diamond and glass.

Full-color smart displays, which act both as a display and as a high-speed visible light communication (VLC) transmitter, can be realized by the integration of red-green-blue micron-sized light emitting diodes (micro-LEDs) onto a common platform. In this work, we report on the integration of aluminum gallium indium phosphide red micro-LEDs onto diamond and glass substrates by micro-transfer printing and their application in VLC. The device on-diamond exhibits high current density and bandwidth operation, enabled by diamond's superior thermal properties.

Three-dimensional cross-nanowire networks recover full terahertz state.

Terahertz radiation encompasses a wide band of the electromagnetic spectrum, spanning from microwaves to infrared light, and is a particularly powerful tool for both fundamental scientific research and applications such as security screening, communications, quality control, and medical imaging. Considerable information can be conveyed by the full polarization state of terahertz light, yet to date, most time-domain terahertz detectors are sensitive to just one polarization component. Here we demonstrate a nanotechnology-based semiconductor detector using cross-nanowire networks that records the full polarization state of terahertz pulses.

Direct integration of micro-LEDs and a SPAD detector on a silicon CMOS chip for data communications and time-of-flight ranging.

We present integration of singulated micron-sized light emitting diodes (micro-LEDs) directly onto a silicon CMOS drive chip using a transfer printing method. An 8x8 micro-LED device array with individual control over each pixel is demonstrated with modulation bandwidths up to 50 MHz, limited by the large modulation depth of the driver chip. The 2 kHz frame rate CMOS driver also incorporates a Single Photon Avalanche Diode device thus allowing detection and transmission functionality on a single integrated chip.

Gallium nitride micro-light-emitting diode structured light sources for multi-modal optical wireless communications systems.

Gallium nitride-based light-emitting diodes (LEDs) have revolutionized the lighting industry with their efficient generation of blue and green light. While broad-area (square millimetre) devices have become the dominant LED lighting technology, fabricating LEDs into micro-scale pixels (micro-LEDs) yields further advantages for optical wireless communications (OWC), and for the development of smart-lighting applications such as tracking and imaging. The smaller active areas of micro-LEDs result in high current density operation, providing high modulation bandwidths and increased optical power density.

Transfer printing of AlGaAs-on-SOI microdisk resonators for selective mode coupling and low-power nonlinear processes.

The transfer printing of aluminum gallium arsenide (AlGaAs) microdisk resonators onto a silicon-on-insulator (SOI) waveguide platform is demonstrated. The integrated resonators exhibit loaded ${Q}$Q-factors reaching $ 4 \times {10^4} $4×10, and the vertical assembly approach allows selective coupling to different spatial mode families. The hybrid platform's nonlinearity is characterized by four-wave mixing with a measured nonlinear coefficient of $ \gamma = 325\;{({\rm Wm})^{ - 1}} $γ=325(Wm), with the devices demonstrating minimal two-photon absorption and free-carrier absorption losses that are inherent to SOI at telecommunications wavelengths.

Characterization, Selection, and Microassembly of Nanowire Laser Systems.

Semiconductor nanowire (NW) lasers are a promising technology for the realization of coherent optical sources with ultrasmall footprint. To fully realize their potential in on-chip photonic systems, scalable methods are required for dealing with large populations of inhomogeneous devices that are typically randomly distributed on host substrates. In this work two complementary, high-throughput techniques are combined: the characterization of nanowire laser populations using automated optical microscopy, and a high-accuracy transfer-printing process with automatic device spatial registration and transfer.

A wearable phototherapy device utilizing micro-LEDs.

A conformable device for wearable phototherapy applications is presented. The device consists of a 1 mm thick elastomeric membrane edge-lit by specially fabricated micro-sized LEDs. Nanoparticle based scattering films are utilized to extract light and a uniform emission of 15 μW/cm is reported over an area of 2 cm.