Regularities of Structure Formation in 30 mm Rods of Thermoelectric Material during Hot Extrusion.

In this study, Ingots of (Bi, Sb)Te thermoelectric material with p-type conductivity have been obtained by hot extrusion. The main regularities of hot extrusion of 30 mm rods have been analyzed with the aid of a mathematical simulation on the basis of the joint use of elastic-plastic body approximations. The phase composition, texture and microstructure of the (Bi, Sb)Te solid solutions have been studied using X-ray diffraction and scanning electron microscopy.

Wavelength Scanning with a Tilting Interference Filter for Glow-Discharge Elemental Imaging.

Glow discharges have long been used for depth profiling and bulk analysis of solid samples. In addition, over the past decade, several methods of obtaining lateral surface elemental distributions have been introduced, each with its own strengths and weaknesses. Challenges for each of these techniques are acceptable optical throughput and added instrumental complexity.

Factors affecting the formation of the radiation pre-peak at the operation of a Grimm-type source in pulsed DC mode.

The plasma emission pre-peaks of many atomic and ionic spectral lines of Cu and Ar were systematically investigated in a Grimm-type pulsed glow discharge (PGD). To register the pre-peaks with sufficient time resolution, a monochromator with photomultiplier detection was used. When the applied power exceeded a specific threshold, pre-peaks were found in all spectral lines investigated, and it was revealed that the electrical pre-peak was the cause of the atomic emission pre-peak.

The relationship between knee arthroplasty and foot loading.

Surgeons have questioned whether foot deformity applies abnormal loading on a knee implant. A total of 24 patients with mild knee deformity underwent a static recording of foot loading prior to and at 3 months following knee replacement. Of these patients, 13 had a preoperative varus deformity.