A novel setup for wafer curvature measurement at very high heating rates.

The curvature evolution of a thin film layer stack containing a top Al layer is measured during temperature cycles with very high heating rates. The temperature cycles are generated by means of programmable electrical power pulses applied to miniaturized polysilicon heater systems embedded inside a semiconductor chip and the curvature is measured by a fast wafer curvature measurement setup. Fast temperature cycles with heating duration of 100 ms are created to heat the specimen up to 270 °C providing an average heating rate of 2500 K/s.

Anthropometric measurements of the femur change with component positioning in total knee arthroplasty.

Background: To analyze aspect ratio (AP size/ (ML) size) of osteoarthritic knees at four different areas of the femur and to observe if proximalization of the femoral cut would change the ML size as well as confirm that external rotation increases the measurements for the AP dimensions of the femur.

Method: From the available MyKnee database (Medacta International, Castel San Pietro, Switzerland) 1030 patients were randomly selected within 20° of deformity consisting of 400 men with a mean (SD) age of 67.5 (9) years and 630 women with a mean (SD) age of 69 (10) years (p<0.

MyHip: supporting planning and surgical guidance for a better total hip arthroplasty : A pilot study.

Purpose: Total hip arthroplasty (THA) aims to restore patient mobility by providing a pain-free and stable artificial joint. A successful THA depends on the planning and its execution during surgery. Both tasks rely on the experience of the surgeon to understand the complex biomechanical behavior of the hip.

A procedure to estimate the origins and the insertions of the knee ligaments from computed tomography images.

The estimation of the origin and insertion of the four knee ligaments is crucial for individualised dynamic modelling of the knee. Commonly this information is obtained ex vivo or from high resolution MRI, which is not always available. Aim of this work is to devise a method to estimate the origins and insertions from computed tomography (CT) images.

Analysis of hip range of motion in everyday life: a pilot study.

Patients undergoing total hip arthroplasty are increasingly younger and have a higher demand concerning hip range of motion. To date, there is no clear consensus as to the amplitude of the "normal hip" in everyday life. It is also unknown if the physical examination is an accurate test for setting the values of true hip motion.