Performance of HPLC/MS microchips in isocratic and gradient elution modes.

We analyzed the chromatographic performance of particle-packed, all-polyimide high-performance liquid chromatography/mass spectrometry (HPLC/MS) microchips in terms of their hydraulic permeabilities and separation efficiency under isocratic and gradient elution conditions. The separation channels of the chips (with ca 50 microm x 75 microm trapezoidal cross-section and a length of 43 mm) were slurry packed with either 3.5 or 5 microm spherical porous C18-silica particles.

A fluorescent derivatization method of proteins for the detection of low-level impurities by microchip capillary gel electrophoresis.

A novel pre-chip fluorescent derivatization method is presented for protein sizing and quantification by microchip CGE. The derivatization reaction employed a water-soluble and stable fluorescent dye and was performed under conditions that favored the formation of homogeneous reaction products. The method delivered in terms of protein sizing similar results as microchip CGE with on-chip staining but showed an extended linear dynamic range for protein quantification encompassing four orders of magnitude.

Microfluidic HPLC-Chip devices with integral channels containing methylstyrenic-based monolithic media.

Polyimide HPLC-Chip devices containing poly(methylstyrene-bis-p-vinylphenyl)ethane (MS/BVPE) stationary phase within the device channels and with wall attachment were prepared by thermally initiated free radical polymerization. The microfluidic devices were coupled to both UV and MS detectors. The potential of the MS/BVPE monolith as an alternative separation media within chip devices was investigated by side-by-side comparisons to particulate media within commercial devices.

Influence of the polymerisation time on the porous and chromatographic properties of monolithic poly(1,2-bis(p-vinylphenyl))ethane capillary columns.

In order to elucidate the effect of the polymerisation time on the morphology of styrene based monolithic support materials, continuous poly(1,2-bis(p-vinylphenyl))ethane (BVPE) rods were synthesised in 1.0ml glass vials by thermally initiated free radical polymerisations of BVPE in the presence of porogens (toluene, decanol) and a,a'-azoisobutyronitrile (AIBN) as initiator at 65 degrees C for different polymerisation times (60, 90, 150, 300 and 600min). Porosity parameters like pore-size-distribution and total porosity were investigated by mercury intrusion porosimetry, while the specific surface area of the BVPE monolithic supports was determined by N(2)-adsorption (BET) measurements.

High capacity organic monoliths for the simultaneous application to biopolymer chromatography and the separation of small molecules.

A method for controlling the mesoporous structure of monolithic organic copolymers is presented by systematic variation in polymerisation time, employing poly(p-methylstyrene-co-1,2-(p-vinylphenyl)ethane) (MS/BVPE) as a representative styrene system. Decreasing the time of polymerisation introduces a considerable fraction of mesopores (up to 20% of the total pore volume), while keeping the support permeability reasonable high ( approximately 1.3x10(-14)m(2)).

Proanthocyanidins: target compounds as antibacterial agents.

Grape seeds accumulate in huge quantities as byproduct during wine production and are therefore a cheap source for pharmacologically active agents. However, studies prove poor antibacterial activity, and results of analyses are sometimes contradictory. The aim of this study was, thus, to determine the antibacterial activity of grape seed extracts with special focus on the chromatographic characterization of active fractions.

Quality assessment and quantitative analysis of flavonoids from tea samples of different origins by HPLC-DAD-ESI-MS.

Components of green tea ( Camellia sinensis) have been of considerable interest in recent years because of their potential utility as pharmaceutical agents, particularly for their antioxidant and anticarcinogenic activity. Responding to the increasing scientific validation of numerous health benefits of tea, a comprehensive approach was adopted to carry out analysis for the quality assessment of flavonoids in tea samples of different origins. For this purpose, extraction, separation, and mass spectrometric parameters were optimized.

Novel monolithic poly(p-methylstyrene-co-bis(p-vinylbenzyl)dimethylsilane) capillary columns for biopolymer separation.

Hydrophobic organo-silane based monolithic capillary columns were prepared by thermally initiated free radical polymerisation within the confines of 200 microm i.d. fused silica capillaries.

Alternative profiling platform based on MELDI and its applicability in clinical proteomics.

The presence of numerous proteomics data and their results in literature reveal the importance and influence of proteins and peptides on human cell cycle. For instance, the proteomic profiling of biological samples, such as serum, plasma or cells, and their organelles, carried out by surface-enhanced laser desorption/ionization mass spectrometry, has led to the discovery of numerous key proteins involved in many biological disease processes. However, questions still remain regarding the reproducibility, bioinformatic artifacts and cross-validations of such experimental set-ups.

Influence of different polymerisation parameters on the separation efficiency of monolithic poly(phenyl acrylate-co-1,4-phenylene diacrylate) capillary columns.

Monolithic poly(phenyl acrylate-co-1,4-phenylene diacrylate) (PA/PDA) capillary columns were prepared in the confines of 200 microm I.D. fused silica capillaries by thermally initiated free radical copolymerisation of phenyl acrylate (PA) and 1,4-phenylene diacrylate (PDA) in the presence of alpha,alpha'-azoisobutyronitrile (AIBN).

Novel monolithic poly(phenyl acrylate-co-1,4-phenylene diacrylate) capillary columns for biopolymer chromatography.

Monolithic capillary columns were prepared by thermally initiated free radical polymerisation of phenyl acrylate (PA) and 1,4-phenylene diacrylate (PDA) in the confines of 200 microm I.D. fused silica capillaries.

Comparison between monolithic conventional size, microbore and capillary poly(p-methylstyrene-co-1,2-bis(p-vinylphenyl)ethane) high-performance liquid chromatography columns Synthesis, application, long-term stability and reproducibility.

Novel monolithic supports (MS/BVPE) were prepared by thermally initiated free radical copolymerisation of p-methylstyrene (MS) and 1,2-bis(p-vinylphenyl)ethane (BVPE). The polymer was synthesised in fused silica capillaries (80 mm x 0.2 mm and 80 mm x 0.

A new analytical material-enhanced laser desorption ionization (MELDI) based approach for the determination of low-mass serum constituents using fullerene derivatives for selective enrichment.

60]fullerene derivatives (dioctadecyl methano[60]fullerene, [60]fullerenoacetic acid, and IDA-[60]fullerene) were prepared and subjected to a comprehensive characterization study including protein binding properties and capacity. These fullerene derivatives were successfully applied as material-enhanced laser desorption/ionization (MELDI) carrier materials. It is shown that diverse functionalities result in characteristic human serum peak patterns (m/z 2000-20 000) in terms of signal intensity as well as the number of detectable masses.

Material-enhanced laser desorption/ionization (MELDI)--a new protein profiling tool utilizing specific carrier materials for time of flight mass spectrometric analysis.

Over the past couple of years, proteomics pattern analysis has emerged as an effective method for the early diagnosis of diseases such as ovarian, breast, or prostate cancer, without identification of single biomarkers. MALDI-TOF MS, for example, offers a simple approach for fast and reliable protein profiling, especially by using carrier materials with various physical and chemical properties, in combination with a MALDI matrix. This approach is referred to as material-enhanced laser desorption/ionization (MELDI).

Monolithic poly(p-methylstyrene-co-1,2-bis(p-vinylphenyl)ethane) capillary columns as novel styrene stationary phases for biopolymer separation.

Novel monolithic capillary supports (200 microm I.D.) were prepared by polymerisation of methylstyrene (MS) and 1,2-bis(p-vinylphenyl)ethane (BVPE) as a crosslinker in the presence of inert diluents (porogens).