Effects of the solvent evaporation technique on the degree of conversion of one-bottle adhesive systems.

This study evaluated the effect of four methods of solvent evaporation on the degree of conversion (DC) of seven one-bottle adhesive systems: Excite (EX), ONE-STEP (OS), Optibond Solo Plus (OB), Prime&Bond 2.1 (PB), Prime&Bond NT (NT), Single Bond (SB) and Single Bond Plus (SP) using Fourier Transform Infrared Analysis (FTIR). Adhesive resins were: 1) applied to KBr pellet surfaces and left undisturbed for 30 seconds (condition 1), 2) left undisturbed for 30 seconds and air-dried with an air stream for 10 seconds (condition 2), 3) left undisturbed for 60 seconds (condition 3) and 4) left undisturbed for 60 seconds and air-dried for 10 seconds (condition 4) before curing.

Degree of conversion of adhesive systems light-cured by LED and halogen light.

This study evaluated the effect of blue light emitting diode (LED) and quartz tungsten halogen (QTH) on the degree of conversion (DC) of an etch-and-rinse Single Bond adhesive system (SB) and a mixture composed of primer solution and resin bond from Clearfil SE Bond self-etching adhesive system (CB) using Fourier transform infrared analysis (FTIR). Adhesives were applied to potassium bromide pellet surfaces and FTIR analyses were performed before and after photo-activation for 10 s with either LED (Freelight 1 - 400 mw/cm(2)) or QTH (XL 3000 - 630 mw/cm(2)) light-curing units (n=8). Additional FTIR spectra were obtained from photo-activated samples stored in distilled water for 1 week.