Near-Surface Concentration Profile of Sheared Semidilute Polymer Solutions.

Controlling the structure of polymer solutions near a solid surface is crucial for many industrial processes as it significantly impacts solution flow and influences slip at the interface. To date, only a few techniques have been developed to experimentally investigate this type of interface at the nanometric scale of solid/liquid interactions. In this study, we probe the interface between a smooth sapphire surface and a semidilute polystyrene solution, using neutron reflectivity.

Viscoelasticity-Induced Onset of Slip at the Wall for Polymer Fluids.

The progressive onset of slip at the wall, which corresponds to a slip length increasing with the solicitation time before reaching a plateau, has been investigated for model viscoelastic polymer solutions, allowing one to vary the longest relaxation time while keeping constant solid-fluid interactions. A hydrodynamic model based on a Maxwell fluid and the classical Navier's hypothesis of a linear response for the friction stress at the interface fully accounts for the data. In the limit of the linear viscoelasticity of the fluid, we could postulate a Newtonian response for the interfacial friction coefficient, reflecting the local character of solid-liquid friction mechanisms.

Nanorheology with a Conventional Rheometer: Probing the Interfacial Properties in Compatibilized Multinanolayer Polymer Films.

Measuring the viscoelastic behavior of polymers in the vicinity of a surface or under confinement is an experimental challenge. Simple rheological tests of nanolayered films of polyethylene/polyamide 6 compatibilized in situ during the coextrusion process enabled the probing of these interfacial properties. Taking advantage of the different melting points and of the multiplication of the number of interfaces, a drastic increase of dynamic moduli was reported when increasing the interphase volume fraction in the films.

Temperature-Controlled Slip of Polymer Melts on Ideal Substrates.

The temperature dependence of the hydrodynamic boundary condition between a polydimethylsiloxane melt and two different nonattractive surfaces made of either an octadecyltrichlorosilane self-assembled monolayer or a grafted layer of short polydimethylsiloxane chains has been characterized. We observe a slip length proportional to the fluid viscosity. The temperature dependence is deeply influenced by the surfaces.

Friction of Polymers: from PDMS Melts to PDMS Elastomers.

The slip behavior of polydimethylsiloxane (PDMS) polymer melts flowing on weakly adsorbing surfaces made of short nonentangled PDMS chains densely end-grafted to silica has been characterized. For high enough shear rates, slip lengths proportional to the bulk fluid viscosity have been observed, in agreement with Navier's interfacial equation and demonstrating that the interfacial Navier's friction coefficient is a local quantity, independent of the polymer molecular weight. Comparing the interfacial shear stresses deduced from these measured slip lengths to available friction stress measured for cross-linked PDMS elastomers, we further demonstrate the local character of the friction coefficient and compare its value to the monomer-monomer friction.

Influence of grafting on the glass transition temperature of PS thin films.

We present an investigation of the effect of the interaction between a thin polystyrene film and its supporting substrate on its glass transition temperature ([Formula: see text]). We modulate this interaction by depositing the film on end-tethered polystyrene grafted layers of controlled molecular parameters. By comparing [Formula: see text] measurements versus film thickness for films deposited on different grafted layers and films deposited directly on a silicon substrate, we can conclude that there is no important effect of the film-subtrate interaction.

Effect of surface elasticity on the rheology of nanometric liquids.

The rheological properties of liquids confined to nanometer scales are important in many physical situations. In this Letter, we demonstrate that the long-range elastic deformation of the confining surfaces must be taken into account when considering the rheology of nanometric liquids. In the case of a squeeze-flow geometry, we show that below a critical distance D(c), the liquid is clamped by its viscosity and its intrinsic properties cannot be disentangled from the global system response.

Sliding friction at soft micropatterned elastomer interfaces.

In this paper, we present an experimental study of the friction between a smooth elastomer lens and an elastomer substrate micropatterned with hexagonal arrays of cylindrical pillars. Depending on the normal load, the surfaces can be in top or mixed contact. The friction force can be interpreted in terms of friction stresses in the full contact and top contact zones.

Hydrodynamic interaction between a spherical particle and an elastic surface: a gentle probe for soft thin Films.

We study the hydrodynamic interaction between a sphere and an elastic surface at a nanoscale with a dynamic surface force apparatus. We show that the interplay between viscous forces and elastic deformations leads to very rich scaling properties of the force response, providing a unique signature of the surface elastic behavior. These properties are illustrated on three different examples: a thick elastomer, a thin elastomer film, and a layer of micrometric bubbles.

Click chemistry grafting of poly(ethylene glycol) brushes to alkyne-functionalized pseudobrushes.

A versatile method for the grafting of azide-terminated polymer chains to alkyne-functionalized pseudobrushes by the Cu(I)-catalyzed Huisgen 1,3-dipolar cycloaddition has been developed. First, poly[(propargyl methacrylate)-r-(glycidyl methacrylate)-r-(methyl methacrylate)] random copolymers with monomer ratios of respectively 27/27/46, 41/31/28, and 45/55/0 were synthesized by RAFT polymerization. Then, dense alkyne-functionalized pseudobrushes were grafted in melt by thermal ring-opening of the glycidyl groups by the silanols from the silicon substrate.

Contact angle and contact angle hysteresis measurements using the capillary bridge technique.

A new experimental technique is proposed to easily measure both advancing and receding contact angles of a liquid on a solid surface, with unprecedented accuracy. The technique is based on the analysis of the evolution of a capillary bridge formed between a liquid bath and a solid surface (which needs to be spherical) when the distance between the surface and the liquid bath is slowly varied. The feasibility of the technique is demonstrated using a low-energy perfluorinated surface with two different test liquids (water and hexadecane).

Capillary bridge formation and breakage: a test to characterize antiadhesive surfaces.

In order to characterize very weak adhesive surfaces, we have developed a quantitative test inspired by the Johnson, Kendall, and Roberts adhesion test for soft adhesives, which relies on the formation and then the rupture of a capillary bridge between the surface to be tested and a liquid bath. Both the shape and the kinetics of breakage of the capillary bridge for various coatings put into contact with liquids of various viscosities and surface tensions have been studied. Several pull off regimes can be distinguished.

Polymer brushes grafted to "passivated" silicon substrates using click chemistry.

We present herein a versatile method for grafting polymer brushes to passivated silicon surfaces based on the Cu(I)-catalyzed Huisgen 1,3-dipolar cycloaddition (click chemistry) of omega-azido polymers and alkynyl-functionalized silicon substrates. First, the "passivation" of the silicon substrates toward polymer adsorption was performed by the deposition of an alkyne functionalized self-assembled monolayer (SAM). Then, three tailor-made omega-azido linear brush precursors, i.

Adhesion mechanisms at soft polymer interfaces.

Based on several significant examples, we analyse the adhesion mechanisms at soft polymer interfaces with a special emphasis first on the role of connector molecules, that is, polymer chains bound to the interface and which transmit stress through a stretching and extraction mechanism, and second on the necessary relay that must be taken by additional dissipation mechanisms acting at larger scales if one wants to reach typical fracture toughnesses in the range of a few 10 J m(-2). Examples of such bulk dissipation mechanisms will be discussed for interfaces between polymer melts and for pressure-sensitive adhesives in contact with a solid surface. We shall particularly point out the fact that the level of adhesion results from a competition between adhesive failure usually driven by both the interactions and the friction properties of the interface and bulk strong deformations which take place in the bulk of the adhesive layer.

Effect of nanometric-scale roughness on slip at the wall of simple fluids.

It is commonly acknowledged that roughness decreases the aptitude of simple liquids to exhibit flow with slip at solid interfaces. Most available studies have, however, been conducted on substrates for which both the surface chemistry and the roughness were varied simultaneously, making it difficult to identify their respective role on wall slip. To overcome this difficulty, we have developed a series of surfaces formed by grafting hyperbranched polymeric nanoparticles on a smooth, dense, self-assembled monolayer of SiH-terminated short poly(dimethylsiloxane) oligomers, allowing us to vary independently the surface density, the height, and the width of the grafted nanoparticles, and thereby the roughness parameters, while keeping similar surface chemistry.

Effect of plasticizers (water and glycerol) on the diffusion of a small molecule in iota-carrageenan biopolymer films for edible coating application.

Translational diffusion of a fluorescein probe has been measured in iota-carrageenan edible films containing different amounts of glycerol (0, 15, 30, and 45%), using fluorescence recovery after photobleaching (FRAP) experiments. The effects of this plasticizer as well as the plasticizing effect of water on the diffusion of fluorescein have been studied in this edible coating mainly composed of natural biopolymer. Diffusion coefficients of about 10(-13) m2 s(-1) have been measured in these films for water activity (aw) lower than 0.

Sliding friction at a rubber/brush interface.

We study the friction of a poly(dimethylsiloxane) (PDMS) rubber network sliding, at low velocity, on a substrate on which PDMS chains are end-tethered. We thus clearly evidence the contribution to friction of the pullout mechanism of chain ends that penetrate into the network. This interfacial dissipative process is systematically investigated by probing the velocity dependence of the friction stress and its variations with the grafting density and molecular weight of the tethered chains.

Unsteady-State Flow of Flexible Polymers in Porous Media.

In this paper we report an investigation of the unsteady-state flow of polymer solutions through granular porous media. The experiments were performed using high-molecular-weight nonionic and anionic polyacrylamides dissolved in water containing NaCl and model porous media obtained by packing silicon carbide (SiC) grains having a narrow grain size distribution. Before injection in porous media, the polymer solutions were carefully filtered according to a method that was proved to be efficient in removing any possibly remaining microgels.