Enhancing diesel engine performance and emission reduction through hydrogen enrichment in algal biodiesel blends.

The introduction of hydrogen into the engine could enhance its combustion efficiency and emission characteristics. The current study examines the attributes of compression ignition (CI) engines by introducing hydrogen into a biodiesel blend derived from algae. The improved thermal properties of hydrogen, when combined with algae biodiesel, significantly affect the performance, combustion, and emissions of dual-fuel engines.

A life cycle assessment of the laboratory-scale oxidative liquefaction as the chemical recycling method of the end-of-life wind turbine blades.

According to the latest reports, estimated values of 50,000-66 000 t of end-of-life wind turbine blades (WTB) are expected to be decommissioned in Europe in 2025-2030, posing a significant threat from the environmental and waste management perspectives. This study aims to present the preliminary Life Cycle Assessment (LCA) with sensitivity and uncertainty analysis of the lab-scale oxidative liquefaction process of the WTB, as the original method to recover the high-quality glass fibers with simultaneous production of the secondary chemicals: phenols, ketones, acids, and fatty acids, from the oxidation of the epoxy resin from the polymer matrix. The LCA is based on the experimental results of the oxidative liquefaction process carried out on a laboratory scale using a Parr 500 ml batch reactor, at two different conditions sets for the functional unit (FU) of 1 kg of treated WTB.

Life cycle assessment of the hydrothermal carbonization process applied to the wet fraction mechanically separated from municipal mixed waste.

The under-sieve fraction (USF), obtained as one of the output streams from the mechanical pretreatment of mixed municipal solid waste, is usually aerobically biologically stabilized before being landfilled. For its characteristics (i.e.

Green Deal and Circular Economy of Bottom Ash Waste Management in Building Industry-Alkali (NaOH) Pre-Treatment.

This study aims to investigate the possibilities of municipal waste incineration bottom ash (MSWIBA) utilization in the construction sector. MSWIBA development fits into the European Green Deal, Sustainable Development Goals (SDGs), and the Circular Economy (CE). This manuscript describes current MSWIBA treatment such as solidification, ceramization, vitrification, chemical activation (NaOH, CaOH, NASiO + NaOH, NaCO + NaOH, NHOH), acid treatment with diluted solutions (HCl, HSO), chemical stabilization (FeSO, PO), chelation, etc.

Environmental life cycle assessment of polyhydroxyalkanoates production from cheese whey.

Cheese whey (CW) is the main by-product of the dairy industry and is often considered one of the main agro-industrial biowaste streams to handle, especially within the European Union, where the diary activities play an essential role in the agrarian economy. In the paper, Life Cycle Assessment (LCA) is used to analyse the feasibility of producing polyhydroxyalkanoates (PHA) as the main output of an innovative CW valorisation route which is benchmarked against a conventional anaerobic digestion (AD) process. To this aim, the LCA inventory data are derived from lab-scale PHA accumulation tests performed on real CW, while data from the literature of concern are used for modelling both the PHA extraction from the accumulating biomass and for the alternative CW valorisation through AD.

Organic waste biorefineries: Looking towards implementation.

The concept of biorefinery expands the possibilities to extract value from organic matter in form of either bespoke crops or organic waste. The viability of biorefinery schemes depends on the recovery of higher-value chemicals with potential for a wide distribution and an untapped marketability. The feasibility of biorefining organic waste is enhanced by the fact that the biorefinery will typically receive a waste management fee for accepting organic waste.

Accelerated carbonation of wood combustion ash for CO removal from gaseous streams and storage in solid form.

In this work, ash generated by the combustion of wood in a central heating plant was used to remove and permanently store by accelerated carbonation CO contained in a gas mixture simulating biogas. The process was studied as an alternative treatment to the ones currently available on the market for biogas upgrading. The process was investigated at laboratory scale by setting up a facility for directly contacting the wood ash and the synthetic biogas in a fixed bed reactor.

Environmental comparison of alternative treatments for sewage sludge: An Italian case study.

A Life Cycle Assessment (LCA) was applied to compare different alternatives for sewage sludge treatment: such as land spreading, composting, incineration, landfill and wet oxidation. The LCA system boundaries include mechanical dewatering, the alternative treatment, transport, and final disposal/recovery of residues. Cases of recovered materials produced as outputs from the systems, were resolved by expanding the system boundaries to include avoided primary productions.

Evaluation of the environmental sustainability of different waste-to-energy plant configurations.

Residual municipal solid waste (MSW) has an average lower heating value higher than 10GJ/Mg in the EU, and can be recovered in modern Waste-to-Energy (WtE) plants, producing combined heat and power (CHP) and reaching high levels of energy recovery. CHP is pinpointed as the best technique for energy recovery from waste. However, in some cases, heat recovery is not technically feasible - due to the absence of a thermal user (industrial plant or district heating) in the vicinity of the WtE plant - and power production remains the sole possibility.

Comparative life cycle assessment of alternative strategies for energy recovery from used cooking oil.

The separate collection of Used Cooking Oil (UCO) is gaining popularity through several countries in Europe. An appropriate management of UCO waste stream leads to substantial benefits. In this study, we analyse two different possibilities of UCO energy reuse: the direct feed to a reciprocating internal combustion engine (ICE) for cogeneration purpose, and the processing to generate biodiesel.

A review of technologies and performances of thermal treatment systems for energy recovery from waste.

The aim of this work is to identify the current level of energy recovery through waste thermal treatment. The state of the art in energy recovery from waste was investigated, highlighting the differences for different types of thermal treatment, considering combustion/incineration, gasification and pyrolysis. Also different types of wastes - Municipal Solid Waste (MSW), Refuse Derived Fuel (RDF) or Solid Refuse Fuels (SRF) and some typologies of Industrial Waste (IW) (sludge, plastic scraps, etc.

Performance of a biogas upgrading process based on alkali absorption with regeneration using air pollution control residues.

This work analyzes the performance of an innovative biogas upgrading method, Alkali absorption with Regeneration (AwR) that employs industrial residues and allows to permanently store the separated CO2. This process consists in a first stage in which CO2 is removed from the biogas by means of chemical absorption with KOH or NaOH solutions followed by a second stage in which the spent absorption solution is contacted with waste incineration Air Pollution Control (APC) residues. The latter reaction leads to the regeneration of the alkali reagent in the solution and to the precipitation of calcium carbonate and hence allows to reuse the regenerated solution in the absorption process and to permanently store the separated CO2 in solid form.

Life cycle assessment of biogas upgrading technologies.

This article evaluates the life cycle assessment (LCA) of three biogas upgrading technologies. An in-depth study and evaluation was conducted on high pressure water scrubbing (HPWS), as well as alkaline with regeneration (AwR) and bottom ash upgrading (BABIU), which additionally offer carbon storage. AwR and BABIU are two novel technologies that utilize waste from municipal solid waste incinerators - namely bottom ash (BA) and air pollution control residues (APC) - and are able to store CO(2) from biogas through accelerated carbonation processes.

Analysis of energy recovery potential using innovative technologies of waste gasification.

In this paper, two alternative thermo-chemical processes for waste treatment were analysed: high temperature gasification and gasification associated to plasma process. The two processes were analysed from the thermodynamic point of view, trying to reconstruct two simplified models, using appropriate simulation tools and some support data from existing/planned plants, able to predict the energy recovery performances by process application. In order to carry out a comparative analysis, the same waste stream input was considered as input to the two models and the generated results were compared.