Type I Porous Liquids with Super-Low Viscosities: the Construction through a Rather Simple One-Step Covalent Linkage Strategy and Its Facile Regulation by a Mixed-Ligand Strategy.

Porous liquids (PLs) are a novel class of flowing liquid systems that possess accessible permanent porosity, exhibiting great prospects in gas capture and separation. Nevertheless, the further development of PLs lies in the facile synthesis and regulation of PLs with low viscosities. Herein, a novel strategy of preparing type I PLs with super-low viscosity is proposed through a simple one-step covalent linkage reaction using UiO-66-NH as the pore generator and monoglycidyl ether terminated polydimethylsiloxane (E-PDMS) as the sterically hindered solvent, respectively.

Pore Characteristics and Dye Adsorption Mechanism of Functionalized UiO-66s with Various Ratios of Amino Groups.

A series of UiO-66 samples with various amino functional group ratios were prepared by modulating the proportion of terephthalic acid (HBDC) and aminoterephthalic acid (HBDC-NH) ligands, and the microstructure of the samples and dependence of methyl orange (MO) adsorption properties on the amino group content were investigated by X-ray diffraction, scanning electron microscopy, FTIR spectra, nitrogen adsorption, positron annihilation lifetime spectroscopy, and UV-vis spectra. The results showed that as the ratio of amino groups increased, the specific surface area and total porosity of the samples decreased, primarily due to decrement in the crystallinity as well as the bulky effect of amino groups in inherent pores. Interestingly, the amino-functionalized samples possessed considerable adsorption capacity of MO even in alkaline conditions due to the hydrogen bonding between the MO and -NH groups.

Highly sulfonated poly ether ether ketone chelated with Cu as a proton exchange membrane at sub-zero temperatures.

Improving the proton conductivity (σ) of proton exchange membranes at low temperatures is very important for expanding their application areas. Here, sulfonated poly ether ether ketone (SPEEK) membranes were prepared with different sulfonation degrees, and its maximum ion exchange capacity is 3.15 mmol/g for 10 h at 60 °C.

Designing novel monolayer and multilayer h-CSe crystals with tunable photoelectric properties.

Using the first-principles method, a new structure of monolayer h-CSe was predicted, exhibiting good dynamical and thermal stability. The geometrical, electronic and optical properties of monolayer h-CSe are examined at the HSE level. Furthermore, the influences of the in-plane strain and layer number on the electric properties of the two dimensional h-CSe material are studied.

[Basic Research on Therapy of Leukemia with Nanoparticles Drug Delivery System Modified by Transferrin Receptor Monoclonal Antibody].

Objective: To investigate the therapeutic effect of targeted drug-loaded nanoparticles modified by transferrin receptor monoclonal antibody (TfR mAb) on acute leukemia and its potential anti-tumor mechanism.

Methods: Nanoparticles drug delivery system, which was composed of poly (lactic-co-glycolic acid), poly-l-lysine, polyethylene glycol, TfR mAb (TfR mAb-PLGA-PLL-PEG)-daunorubicin (DNR), was first synthesized. After drug intervention, the intracellular accumulation in leukemia HL60 cells was observed under a fluorescent microscope and concentration of DNR was determined by flow cytometry (FCM).

Neutron Irradiation Effects on Boron Nitride-Based Ceramics for Use in X-ray Detection.

X-ray detectors based on conventional semiconductors with large atomic numbers are suffering from the poor stability under a high dose rate of ionizing irradiation. In this work, we demonstrate that a wide band gap ceramic-boron nitride with small atomic numbers could be used for sensitive X-ray detection. Boron nitride samples showed excellent resistance to ionizing radiation, which have been systematically studied with the neutron- and electron-aging experiments.

Application Progress of PALS in the Correlation of Structure and Properties for Graphene/Polymer Nanocomposites.

Giving a deep insight into the microstructure, and realizing the correlation between microstructure and properties is very important to the precise construction of high-performance graphene/polymer nanocomposites (GPN). For the promising application in microstructure characterization, much attention has been focused on the effective technique of positron annihilation lifetime spectroscopy (PALS). Based on the introduction of the basic principle, this review summarized the application progress of PALS in the correlation of microstructure and properties for GPN, especially for the characterization of free volume and interfacial interaction, and the correlation of these microstructures and properties.

New Aspects of Degradation in Silicone Rubber under UVA and UVB Irradiation: A Gas Chromatography-Mass Spectrometry Study.

In this paper, gas chromatography-mass spectrometry (GC-MS) and positron annihilation lifetime spectroscopy (PALS) were used to probe the changes of oligomers and the polydimethylsiloxane (PDMS) network in silicone rubber, after different durations of UVA/UVB irradiation. At the early stage (<300 h) of UVA/UVB irradiation, the concentration of D4-D9 decreases. The o-Ps intensity of the extracted silicone rubber increases in the stage after UVB irradiation.

Numerical investigation of the thermal effect on flow and dispersion of rooftop stack emissions with wind tunnel experimental validations.

The thermal effect on the flow and dispersion of pollutants emitted from a rooftop stack is investigated by means of CFD (computational fluid dynamics) models with wind tunnel experimental validations. The leeward wall and its nearby ground are heated simultaneously to mimic solar radiation. Seventeen Ri (Richardson number) cases with four inflow wind speeds (1, 3, 6, and 9 m/s) and five temperature differences (0, 60, 120, 180, and 240 K) between the heated surface and ambient air are considered to represent the interaction between thermal buoyancy force and inertia force.

A reclaimed piezoelectric catalyst of MoS@TNr composites as high-performance anode materials for supercapacitors.

A piezoelectric catalyst of the MoS@TNr composite (MoS nanosheets composited with TiO nanorods) was synthesized by a two-step hydrothermal method, and can be recycled and reused as an advanced anode material for supercapacitors. In the dark, the MoS@TNr composite exhibited ultra-fast piezoelectric catalytic performance and good cycle stability on dye degradation; within 10 min, nearly all rhodamine B (50 mL, 20 ppm) was removed from the solution with the assistance of magnetic stirring. After the 5 cycle degradation reaction, the catalyst was reclaimed and applied to electrochemical testing, which showed better supercapacitor capacitance properties than the fresh catalyst due to the introduction of oxygen vacancies generated from the piezoelectric degradation process.

Free volume, gas permeation, and proton conductivity in MIL-101-SOH/Nafion composite membranes.

A series of MIL-101-SO3H/Nafion composite membranes was synthesized. They show an improved proton conductivity, due to the abundance of SO3H groups, which fosters proton conduction by binding the water molecules and enabling a larger number of conducting sites. Gas (including water vapor, hydrogen, and oxygen) permeability, crystallinity, and free volumes of the MIL-101-SO3H/Nafion composite membranes were investigated, as well as their correlation.

Dependence of Dye Molecules Adsorption Behaviors on Pore Characteristics of Mesostructured MOFs Fabricated by Surfactant Template.

In this work, mesostructured metal-organic frameworks (MOFs) of MIL-101-Crs with different specific surface areas were synthesized successfully under solvothermal conditions using cationic surfactant cetyltrimethyl ammonium bromide (CTAB) as a structural template. It was found that crystallinity degrees, specific surface areas, and pore size distributions strongly depended on the loading of CTAB. Nitrogen adsorption and positron annihilation lifetime spectroscopy (PALS) results showed that the mean mesopore size increased with loading more CTAB due to the formation of larger templated mesopores.