Graphene oxide functionalized with L-asparagine applied to crystal violet dye removal from water and wastewater.

The efficiency of graphene oxide functionalized with L-asparagine (GO@L-Asn) as adsorbent for crystal violet (CV) dye removal from water and wastewater was investigated. The surface and textural properties of this new nanomaterial were characterized by pH at point of zero charge, Fourier-transform infrared spectroscopy, scanning electron microscopy, X-ray diffraction, and Brunauer-Emmet-Teller technique. The main experimental variables involved in dye adsorption process were evaluated and optimized.

Treatment of textile wastewater using carbon-based nanomaterials as adsorbents: a review.

Waste derived from the textile industry can contain a wide variety of pollutants of organic and inorganic natures, such as dyes (e.g., acid, basic, reactive, mordant dyes) and toxic metals (e.

Novel bionanomaterial based on Spirulina maxima algae and graphene oxide for lead microextraction and determination in water and infant beverages.

A new hybrid bionanomaterial composed of graphene oxide (GO) and Spirulina maxima (SM) algae was synthesized and applied to develop a preconcentration method based on the dispersive micro-solid phase extraction (D-μ-SPE) technique for the determination of Pb in water and infant beverages. In this work, Pb(II) was extracted with 3 mg of the hybrid bionanomaterial (GO@SM) followed by a back-extraction step using 500 µL of 0.6 mol L HCl.

Biohybrid Adsorbent for the Preconcentration of Lead and Its Determination in Fruit Juices by Electrothermal Atomic Absorption Spectrometry.

Background: Fruit juices are one of the most non-alcoholic beverages consumed in the world. Essential elements and other nutrients present in fruit juices play an important role in human well-being. However, fruit juices may also contain potentially toxic elements at trace levels, causing health risks.

Hybrid biomaterials to preconcentrate and determine toxic metals and metalloids: a review.

Toxic elements represent a serious threat to the environment and cause harmful effects on different environmental components, even at trace levels. These toxic elements are often difficult to detect through the typical instrumentation of an analytical laboratory because they are found at very low concentrations in matrices such as food and water. Therefore, preconcentration plays a fundamental role since it allows the effects of the matrix to be minimized, thus reaching lower detection limits and greater sensitivity of detection techniques.

Removal of thallium from environmental samples using a raw and chemically modified biosorbent derived from domestic wastes.

Because of its high toxicity, thallium (Tl) causes environmental pollution even at very low concentrations. Despite its extremely high environmental risk, limited information about Tl removal from water is present on the literature. This work focused on the use of an eco-friendly and low-cost Ilex paraguariensis (yerba mate) biowaste to remove Tl from environmental water samples.

Biosorption of crystal violet dye using inactive biomass of the fungus Diaporthe schini.

An inactive biomass of a new fungus recently discovered, Diaporthe schini, was evaluated for the biosorption of crystal violet (CV) in simulated textile effluents. The characterization assays were performed using X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM) and N adsorption/desorption isotherms. The influences of pH and biosorbent dosage on the biosorption capacity were evaluated.

Magnetic ionic liquid-based dispersive liquid-liquid microextraction technique for preconcentration and ultra-trace determination of Cd in honey.

A simple, highly efficient, batch, and centrifuge-less dispersive liquid-liquid microextraction method based on a magnetic ionic liquid (MIL-DLLME) and electrothermal atomic absorption spectrometry (ETAAS) detection was developed for ultra-trace Cd determination in honey. Initially, Cd(II) was chelated with ammonium diethyldithiophosphate (DDTP) at pH 0.5 followed by its extraction with the MIL trihexyl(tetradecyl)phosphonium tetrachloroferrate(III) ([P]FeCl) and acetonitrile as dispersant.

Macroalgae of Iridaea cordata as an efficient biosorbent to remove hazardous cationic dyes from aqueous solutions.

In the present work, Iridaea cordata (IC), a red marine macroalgae, was used as an efficient biosorbent for the removal of crystal violet (CV) and methylene blue (MB) dyes from aqueous solutions. The effects of pH (5, 7, and 9) and IC concentration (1, 3, and 5 g L) on the biosorption were studied through a 3 full factorial design. Under the optimal conditions (pH: 7, biosorbent concentration: 1 g L), biosorption kinetic studies were developed and the obtained experimental data were evaluated by pseudo-first order and pseudo-second order models.

Intra-regional classification of grape seeds produced in Mendoza province (Argentina) by multi-elemental analysis and chemometrics tools.

The feasibility of the application of chemometric techniques associated with multi-element analysis for the classification of grape seeds according to their provenance vineyard soil was investigated. Grape seed samples from different localities of Mendoza province (Argentina) were evaluated. Inductively coupled plasma mass spectrometry (ICP-MS) was used for the determination of twenty-nine elements (Ag, As, Ce, Co, Cs, Cu, Eu, Fe, Ga, Gd, La, Lu, Mn, Mo, Nb, Nd, Ni, Pr, Rb, Sm, Te, Ti, Tl, Tm, U, V, Y, Zn and Zr).

Powdered grape seeds (PGS) as an alternative biosorbent to remove pharmaceutical dyes from aqueous solutions.

An alternative, low-cost and efficient biosorbent, powdered grape seeds (PGS), was prepared from wastes of a wine industry, and used to remove brilliant blue (BB) and amaranth red (AR) dyes from aqueous solutions. The biosorbent was properly characterized before and after the biosorption operation. The potential of PGS to remove BB and AR dyes was investigated thought kinetic, isotherm and thermodynamic studies.

Stability of iron-quercetin complexes in synthetic wine under in vitro digestion conditions.

Unlabelled: Wine is a dietary source of polyphenolic compounds with reported health benefits when moderately consumed. Several of these compounds can associate with metals forming complexes. Therefore, this work was conducted to reach a better understanding of the nature and chemical stability of wine-derived Fe(3+)-quercetin complexes in a digestion model.

Polymer-supported ionic liquid solid phase extraction for trace inorganic and organic mercury determination in water samples by flow injection-cold vapor atomic absorption spectrometry.

A simple and green technique named polymer-supported ionic liquid solid phase extraction (PSIL-SPE) was developed for mercury (Hg) species determination. Inorganic Hg (InHg) species was complexed with chloride ions followed by its introduction into a flow injection on-line system to quantitatively retain the anionic chlorocomplex (HgCl4(2-)) in a column packed with CYPHOS(®) IL 101-impregnated resin. The trapped InHg was then reduced with stannous chloride (SnCl2) and eluted with the same flow of reducing agent followed by cold vapor atomic absorption spectrometry (CV-AAS) detection.

Bioanalytical separation and preconcentration using ionic liquids.

Ionic liquids (ILs) are novel solvents that display a number of unique properties, such as negligible vapor pressure, thermal stability (even at high temperatures), favorable viscosity, and miscibility with water and organic solvents. These properties make them attractive alternatives to environmentally unfriendly solvents that produce volatile organic compounds. In this article, a critical review of state-of-the-art developments in the use of ILs for the separation and preconcentration of bioanalytes in biological samples is presented.

Liquid-liquid microextraction based on a dispersion of Pd nanoparticles combined with ETAAS for sensitive Hg determination in water samples.

A novel and highly efficient microextraction methodology based on the use of palladium nanoparticles (Pd NPs) was developed for the preconcentration and determination of Hg in water samples. Selective separation of the analyte was achieved by application of dodecanethiolate-coated Pd monolayer-protected clusters (C12S Pd MPCs) in a liquid-liquid microextraction technique (LLME). A volume of 20 μL of toluene phase containing C12S Pd MPCs was used for extraction and final phase was injected in an electrothermal atomic absorption spectrometer (ETAAS) for Hg detection.

Sensitive determination of thallium species in drinking and natural water by ionic liquid-assisted ion-pairing liquid-liquid microextraction and inductively coupled plasma mass spectrometry.

A fast and simple method involving separation and determination of thallium (Tl) species, based on novel ionic liquid-assisted ion pairing dispersive liquid-liquid microextraction (DLLME) method, was developed. Initially, Tl(III) was selectively complexed with chloride ion to form [TlCl(4)](-) chlorocomplex. Subsequently, tetradecyl(trihexyl)phosphonium chloride ionic liquid (CYPHOS(®) IL 101) was used to form the ion-pair with [TlCl(4)](-) anion followed by extraction.

Arsenic speciation analysis in mono-varietal wines by on-line ionic liquid-based dispersive liquid-liquid microextraction.

A highly efficient separation and pre-concentration method for arsenic species determination, based on ionic liquid (IL) dispersive microextraction technique implemented in a flow analysis system, is proposed. Highly selective separation of arsenite species [As(III)] was achieved by chelation with sodium diethyldithiocarbamate (DDTC) followed by dispersion with 40 mg of 1-octyl-3-methylimidazolium hexafluorophosphate ([C(8)mim][PF(6)]) IL. Analyte extraction, retention and separation of IL phase were achieved with a packed microcolumn and As(III) was determined in eluent solution by electrothermal atomic absorption spectrometry (ETAAS).

Dispersive liquid-liquid microextraction and preconcentration of thallium species in water samples by two ionic liquids applied as ion-pairing reagent and extractant phase.

In the present work, a simple and highly sensitive analytical methodology for determination of Tl(+) and Tl(3+) species, based on the use of modern and non-volatile solvents, such as ionic liquids (ILs), was developed. Initially, Tl(+) was complexed by iodide ion at pH 1 in diluted sulfuric acid solution. Then, tetradecyl(trihexyl)phosphonium chloride ionic liquid (CYPHOS(®) IL 101) was used as ion-pairing reagent and a dispersive liquid-liquid microextraction (DLLME) procedure was developed by dispersing 60 mg of 1-hexyl-3-methylimidazolium hexafluorophosphate [C(6) mim][PF(6)] with 500 μL of ethanol in the aqueous solution.

Determination of inorganic selenium species in water and garlic samples with on-line ionic liquid dispersive microextraction and electrothermal atomic absorption spectrometry.

A non-chromatographic separation and preconcentration method for Se species determination based on the use of an on-line ionic liquid (IL) dispersive microextraction system coupled to electrothermal atomic absorption spectrometry (ETAAS) is proposed. Retention and separation of the IL phase was achieved with a Florisil(®)-packed microcolumn after dispersive liquid-liquid microextraction (DLLME) with tetradecyl(trihexyl)phosphonium chloride IL (CYPHOS(®) IL 101). Selenite [Se(IV)] species was selectively separated by forming Se-ammonium pyrrolidine dithiocarbamate (Se-APDC) complex followed by extraction with CYPHOS(®) IL 101.