Crystallography is an invaluable tool in materials science, solid state physics and protein science. Understanding crystallography requires grasping the powerful but abstract concept of reciprocal space. Here a simple but insightful experiment using a laser pointer and Au microdisc arrays to explore and illustrate Bragg diffraction and reciprocal space is demonstrated.
View Article and Find Full Text PDFJ Synchrotron Radiat
January 2022
Coherent X-ray imaging techniques, such as in-line holography, exploit the high brilliance provided by diffraction-limited storage rings to perform imaging sensitive to the electron density through contrast due to the phase shift, rather than conventional attenuation contrast. Thus, coherent X-ray imaging techniques enable high-sensitivity and low-dose imaging, especially for low-atomic-number (Z) chemical elements and materials with similar attenuation contrast. Here, the first implementation of in-line holography at the NanoMAX beamline is presented, which benefits from the exceptional focusing capabilities and the high brilliance provided by MAX IV, the first operational diffraction-limited storage ring up to approximately 300 eV.
View Article and Find Full Text PDFUsing multilayer zone plates (MZPs) as two-dimensional optics, focal spot sizes of less than 10 nm can be achieved, as we show here with a focus of 8.4 nm × 9.6 nm, but the need for order-sorting apertures prohibits practical working distances.
View Article and Find Full Text PDFNanoscale X-ray detectors could allow higher resolution in imaging and diffraction experiments than established systems but are difficult to design due to the long absorption length of X-rays. Here, we demonstrate X-ray detection in a single nanowire in which the nanowire axis is parallel to the optical axis. In this geometry, X-ray absorption can occur along the nanowire length, while the spatial resolution is limited by the diameter.
View Article and Find Full Text PDFHere it is demonstrated how nanofocused X-ray beam induced current (XBIC) can be used to quantitatively map the spatially dependent carrier collection probability within nanostructured solar cells. The photocurrent generated by a 50 nm-diameter X-ray beam was measured as a function of position, bias and flux in single p-i-n doped solar-cell nanowires. The signal gathered mostly from the middle segment decays exponentially toward the p- and n-segments, with a characteristic decay length that varies between 50 nm and 750 nm depending on the flux and the applied bias.
View Article and Find Full Text PDFThe properties of semiconductors can be controlled using doping, making it essential for electronic and optoelectronic devices. However, with shrinking device sizes it becomes increasingly difficult to quantify doping with sufficient sensitivity and spatial resolution. Here, we demonstrate how X-ray fluorescence mapping with a nanofocused beam, nano-XRF, can quantify Zn doping within in situ doped III-V nanowires, by using large area detectors and high-efficiency focusing optics.
View Article and Find Full Text PDFWe demonstrate x-ray absorption fine structure spectroscopy (XAFS) detected by x-ray beam induced current (XBIC) in single n -i-n doped nanowire devices. Spatial scans with the 65 nm diameter beam show a peak of the XBIC signal in the middle segment of the nanowire. The XBIC and the x-ray fluorescence signals were detected simultaneously as a function of the excitation energy near the Ga K absorption edge at 10.
View Article and Find Full Text PDF