Impact of two thermal processing routes on protein interactions and acid gelation properties of casein micelle-pea protein mixture compared to casein micelle-whey protein one.

The influence of two heating protocols (protocol 1 and 2) on protein interactions and acid-induced gelation properties of casein micelle-pea protein mixture (CM-PP) was investigated and then compared to casein micelle-whey protein mixture (CM-WP). The CM:PP and CM:WP protein weight ratio for mixtures was 7.5:2.

Comparison of the Effect of Hydrostatic and Dynamic High Pressure Processing on the Enzymatic Activity and Physicochemical Quality Attributes of 'Ataulfo' Mango Nectar.

The effects of hydrostatic (HHP) and dynamic (HPH) high-pressure treatments on the activity of pectin methylesterase (PME) and polyphenol oxidase (PPO) as well as the physicochemical quality attributes of 'Ataulfo' mango nectar were assessed. HHP reduced PME relative activity by 28% at 100 MPa for 5 min but increased PPO activity almost five-fold. Contrarily, HPH did not affect PME activity, but PPO was effectively reduced to 10% of residual activity at 300 MPa and at three passes.

Potentialities and Limits of Some Non-thermal Technologies to Improve Sustainability of Food Processing.

In the whole food production chain, from the farm to the fork, food manufacturing steps have a large environmental impact. Despite significant efforts made to optimize heat recovery or water consumption, conventional food processing remains poorly efficient in terms of energy requirements and waste management. Therefore, in the few last decades, much research has focused on the development of alternative non-thermal technologies.

The foaming properties of camel and bovine whey: The impact of pH and heat treatment.

The effect of heat treatment (70°C or 90°C for 30min) on the foaming and interfacial properties of acid and sweet whey obtained from bovine and camel fresh milk was examined. The maximum foamability and foam stability were observed for acid whey when compared to sweet whey for both milks, with higher values for the camel whey. This behavior for acid whey was explained by the proximity of the pI of whey protein (4.

Performances of different protocols for exocellular polysaccharides extraction from milk acid gels: Application to yogurt.

Dextran or xanthan were used as model exocellular polysaccharides (EPS) to compare the extraction efficiency of EPS from skim milk acid gels using three different protocols. Extraction yields, residual protein concentrations and the macromolecular properties of extracted EPS were determined. For both model EPS, the highest extraction yield (∼80%) was obtained when samples were heated in acidic conditions at the first step of extraction (Protocol 1).

The effect of pH and heat treatments on the foaming properties of purified α-lactalbumin from camel milk.

The effect of pH (4.3 or 6.5) and heat treatment (70°C or 90°C for 30min) on the foaming and interfacial properties of α-lactalbumin extracted from camel milk were studied.

Foaming and adsorption behavior of bovine and camel proteins mixed layers at the air/water interface.

The aim of this work was to examine foaming and interfacial behavior of three milk protein mixtures, bovine α-lactalbumin-β-casein (M1), camel α-lactalbumin-β-casein (M2) and β-lactoglobulin-β-casein (M3), alone and in binary mixtures, at the air/water interface in order to better understand the foaming properties of bovine and camel milks. Different mixture ratios (100:0; 75:25; 50:50; 25:75; 0:100) were used during foaming tests and interfacial protein interactions were studied with a pendant drop tensiometer. Experimental results evidenced that the greatest foam was obtained with a higher β-casein amount in all camel and bovine mixtures.

UHPH-processed O/W submicron emulsions stabilised with a lipid-based surfactant: physicochemical characteristics and behaviour on in vitro TC7-cell monolayers and ex vivo pig's ear skin.

Submicron O/W emulsions formulated with sesame oil plus a lipid-base surfactant, and with or without retinyl acetate (RAC) as a model hydrophobic biomolecule, were prepared by single-pass homogenisation at ≥ 200 MPa (UHPH) and an initial fluid temperature (Tin) of 24°C. These emulsions were characterised by a monomodal distribution (peak maximum at 260 nm) and a 2-year potential physical stability at ambient temperature. Submicron droplets were investigated in term of (i) physicochemical characteristics (size distribution curves; ζ-potential value), and (ii) impact on TC7-cell monolayers (MTT-assay and cell LDH-leakage).