Time-stretch spectroscopy for fast infrared absorption spectra of acetylene and hydroxyl radicals during combustion.

We have developed a diagnostic that uses time-domain spectroscopy to measure transient infrared absorption spectra in gases. Using a time-stretch Fourier transform approach, we can determine pressure, temperature, and gas concentrations with sub-microsecond time resolution for over two milliseconds. We demonstrate high-resolution (0.

Time-stretched photonic Doppler velocimetry.

Inertial confinement fusion facilities generate implosions at speeds greater than 100 km/s, and measuring the material velocities is important and challenging. We have developed a new velocimetry technique that uses time-stretched spectral interferometry to increase the measurable velocity range normally limited by the detector bandwidth. In this approach, the signal is encoded on a chirped laser pulse that is stretched in time to reduce the beat frequency before detection.

Simultaneous broadband laser ranging and photonic Doppler velocimetry for dynamic compression experiments.

A diagnostic was developed to simultaneously measure both the distance and velocity of rapidly moving surfaces in dynamic compression experiments, specifically non-planar experiments where integrating the velocity in one direction does not always give the material position accurately. The diagnostic is constructed mainly from fiber-optic telecommunications components. The distance measurement is based on a technique described by Xia and Zhang [Opt.

Thermal transport in shock wave-compressed solids using pulsed laser heating.

A pulsed laser heating method was developed for determining thermal transport properties of solids under shock-wave compression. While the solid is compressed, a laser deposits a known amount of heat onto the sample surface, which is held in the shocked state by a transparent window. The heat from the laser briefly elevates the surface temperature and then diffuses into the interior via one-dimensional heat conduction.

Reflectance changes during shock-induced phase transformations in metals.

In performing shock wave experiments to study the characteristics of metals at high pressures, wave profiles (i.e., velocity measurements of the surface of the sample) are an established and useful way to study phase transformations.