Carbon-Impurity Affected Depth Elemental Distribution in Solution-Processed Inorganic Thin Films for Solar Cell Application.

A common feature of the inorganic thin films including Cu(In,Ga)(S,Se)2 fabricated by nonvacuum solution-based approaches is the doubled-layered structure, with a top dense inorganic film and a bottom carbon-containing residual layer. Although the latter has been considered to be the main efficiency limiting factor, (as a source of high series resistance), the exact influence of this layer is still not clear, and contradictory views are present. In this study, using a CISe as a model system, we report experimental evidence indicating that the carbon residual layer itself is electrically benign to the device performance.

Carbon- and oxygen-free Cu(InGa)(SSe)₂ solar cell with a 4.63% conversion efficiency by electrostatic spray deposition.

We have demonstrated the first example of carbon- and oxygen-free Cu(In,Ga)(SSe)2 (CIGSSe) absorber layers prepared by electrospraying a CuInGa (CIG) precursor followed by annealing, sulfurization, and selenization at elevated temperature. X-ray diffraction and scanning electron microscopy showed that the amorphous as-deposited (CIG) precursor film was converted into polycrystalline CIGSSe with a flat-grained morphology after post-treatment. The optimal post-treatment temperature was 300 °C for annealing and 500 °C for both sulfurization and selenization, with a ramp rate of 5 °C/min.

Amorphous Cu-In-S nanoparticles as precursors for CuInSe2 thin-film solar cells with a high efficiency.

CuInSe2 (CISe) absorber layers for thin-film solar cells were fabricated through the selenization of amorphous Cu-In-S nanoparticles, which were prepared by using a low-temperature colloidal process within one minute without any external heating. Two strategies for obtaining highly dense CISe absorber films were used in this work; the first was the modification of nanoparticle surface through chelate complexation with ethanolamine, and the second strategy utilized the lattice expansion that occurred when S atoms in the precursor particles were replaced with Se during selenization. The synergy of these two strategies allowed formation of highly dense CISe thin films, and devices fabricated using the absorber layer demonstrated efficiencies of up to 7.

CuInSe₂ thin-film solar cells with 7.72 % efficiency prepared via direct coating of a metal salts/alcohol-based precursor solution.

A simple direct solution coating process for forming CuInSe₂ (CIS) thin films was described, employing a low-cost and environmentally friendly precursor solution. The precursor solution was prepared by mixing metal acetates, ethanol, and ethanolamine. The facile formation of a precursor solution without the need to prefabricate nanoparticles enables a rapid and easy processing, and the high stability of the solution in air further ensures the precursor preparation and the film deposition in ambient conditions without a glove box.

CuInSe2 (CIS) thin films prepared from amorphous Cu-In-Se nanoparticle precursors for solar cell application.

CuInSe(2) (CIS) absorber layers for thin film solar cells were formed via a nonvacuum route using nanoparticle precursors. A low-temperature colloidal process was used to prepare nanoparticles by which amorphous Cu-In-Se nanoparticles were formed within 1 min of reaction without any external heating. Raman spectra of the particles revealed that they were presumably mixtures of amorphous Cu-Se and In-Se binaries.