Pure and palladium-loaded Co3O4 hollow hierarchical nanostructures with giant and ultraselective chemiresistivity to xylene and toluene.

Pure and palladium-loaded Co3O4 hollow hierarchical nanostructures consisting of nanosheets have been prepared by solvothermal self-assembly. The nanostructures exhibited an ultrahigh response and selectivity towards p-xylene and toluene. The responses (resistance ratio) of the palladium-loaded Co3O4 hollow hierarchical nanostructures to 5 ppm of p-xylene and toluene were as high as 361 and 305, respectively, whereas the selectivity values (response ratios) towards p-xylene and toluene over interference from ethanol were 18.

Extremely sensitive and selective NO probe based on villi-like WO3 nanostructures for application to exhaled breath analyzers.

Self-assembled WO3 thin film nanostructures with 1-dimensional villi-like nanofingers (VLNF) have been synthesized on the SiO2/Si substrate with Pt interdigitated electrodes using glancing angle deposition (GAD). Room-temperature deposition of WO3 by GAD resulted in anisotropic nanostructures with large aspect ratio and porosity having a relative surface area, which is about 32 times larger than that of a plain WO3 film. A WO3 VLNF sensor shows extremely high response to nitric oxide (NO) at 200 °C in 80% of relative humidity atmosphere, while responses of the sensor to ethanol, acetone, ammonia, and carbon monoxide are negligible.

Ultraselective and sensitive detection of xylene and toluene for monitoring indoor air pollution using Cr-doped NiO hierarchical nanostructures.

Ultraselective and sensitive detection of xylene and toluene with minimum interferences of other indoor air pollutants such as benzene, ethanol, and formaldehyde is achieved using NiO hierarchical nanostructures doped with Cr. Pure and 1.15-2.

Selective detection of NO2 using Cr-doped CuO nanorods.

CuO nanosheets, Cr-doped CuO nanosheets, and Cr-doped CuO nanorods were prepared by heating a slurry containing Cu-hydroxide/Cr-hydroxide. Their responses to 100 ppm NO(2), C(2)H(5)OH, NH(3), trimethylamine, C(3)H(8), and CO were measured. For 2.

Design of highly sensitive C2H5OH sensors using self-assembled ZnO nanostructures.

Various ZnO nanostructures such as porous nanorods and two hierarchical structures consisting of porous nanosheets or crystalline nanorods were prepared by the reaction of mixtures of oleic-acid-dissolved ethanol solutions and aqueous dissolved Zn-precursor solutions in the presence of NaOH. All three ZnO nanostructures showed sensitive and selective detection of C(2)H(5)OH. In particular, ultra-high responses (R(a)/R(g) = ∼1,200, R(a): resistance in air, R(g): resistance in gas) to 100 ppm C(2)H(5)OH was attained using porous nanorods and hierarchical structures assembled from porous nanosheets, which is one of the highest values reported in the literature.

Ultra-fast responding and recovering C2H5OH sensors using SnO2 hollow spheres prepared and activated by Ni templates.

Ultra-fast responding and recovering C(2)H(5)OH sensors were prepared using nanoscale SnO(2) hollow spheres with NiO-functionalized inner walls. The exceptional ultra-fast recovery characteristics were attributed to the catalytic surface reaction assisted by NiO at the inner shell.