Metal-nanowall grating transparent electrodes: achieving high optical transmittance at high incident angles with minimal diffraction.

A novel architecture has been employed to fabricate transparent electrodes with high conductivity and high optical transmittance at high incident angles. Soft lithography is used to fabricate polymer grating patterns onto which thin metallic films are deposited. Etching removes excess metal leaving tall walls of metal.

Soft holographic interference lithography microlens for enhanced organic light emitting diode light extraction.

Very uniform 2 μm-pitch square microlens arrays (μLAs), embossed on the blank glass side of an indium-tin-oxide (ITO)-coated 1.1 mm-thick glass, are used to enhance light extraction from organic light-emitting diodes (OLEDs) by ~100%, significantly higher than enhancements reported previously. The array design and size relative to the OLED pixel size appear to be responsible for this enhancement.

Fabrication of metallic nanowires and nanoribbons using laser interference lithography and shadow lithography.

Ordered and free-standing metallic nanowires were fabricated by e-beam deposition on patterned polymer templates made by interference lithography. The dimensions of the nanowires can be controlled through adjustment of deposition conditions and polymer templates. Grain size, polarized optical transmission and electrical resistivity were measured with ordered and free-standing nanowires.

Polarized thermal radiation by layer-by-layer metallic emitters with sub-wavelength grating.

Metallic thermal emitters consisting of two layers of differently structured nickel gratings on a homogeneous nickel layer are fabricated by soft lithography and studied for polarized thermal radiation. A thermal emitter in combination with a sub-wavelength grating shows a high extinction ratio, with a maximum value close to 5, in a wide mid-infrared range from 3.2 to 7.