Nanoscale Heat Transport of Vertically Aligned Carbon Nanotube Bundles for Thermal Management Applications.

Electronic devices continue to shrink in size while increasing in performance, making excess heat dissipation challenging. Traditional thermal interface materials (TIMs) such as thermal grease and pads face limitations in thermal conductivity and stability, particularly as devices scale down. Carbon nanotubes (CNTs) have emerged as promising candidates for TIMs because of their exceptional thermal conductivity and mechanical properties.

Deciphering the structural and kinetic factors in lithium titanate for enhanced performance in Li/Na dual-cation electrolyte.

The widespread application of LiTiO (LTO) anode in lithium-ion batteries has been hindered by its relatively low energy density. In this study, we investigated the capacity enhancement mechanism of LTO anode through the incorporation of Na cations in an Li-based electrolyte (dual-cation electrolyte). LTO thin film electrodes were prepared as conductive additive-free and binder-free model electrodes.

Thermoelectric Limitations of Graphene Nanodevices at Ultrahigh Current Densities.

Graphene is atomically thin, possesses excellent thermal conductivity, and is able to withstand high current densities, making it attractive for many nanoscale applications such as field-effect transistors, interconnects, and thermal management layers. Enabling integration of graphene into such devices requires nanostructuring, which can have a drastic impact on the self-heating properties, in particular at high current densities. Here, we use a combination of scanning thermal microscopy, finite element thermal analysis, and scanning transmission electron microscopy techniques to observe prototype graphene devices in operation and gain a deeper understanding of the role of geometry and interfaces during high current density operation.

Determination of electric and thermoelectric properties of molecular junctions by AFM in peak force tapping mode.

Molecular thin films, such as self-assembled monolayers (SAMs), offer the possibility of translating the optimised thermophysical and electrical properties of high-Seebeck-coefficient single molecules to scalable device architectures. However, for many scanning probe-based approaches attempting to characterise such SAMs, there remains a significant challenge in recovering single-molecule equivalent values from large-area films due to the intrinsic uncertainty of the probe-sample contact area coupled with film damage caused by contact forces. Here we report a new reproducible non-destructive method for probing the electrical and thermoelectric (TE) properties of small assemblies (10-10) of thiol-terminated molecules arranged within a SAM on a gold surface, and demonstrate the successful and reproducible measurements of the equivalent single-molecule electrical conductivity and Seebeck values.

Quantifying the local mechanical properties of twisted double bilayer graphene.

Nanomechanical measurements of minimally twisted van der Waals materials remained elusive despite their fundamental importance for device realisation. Here, we use Ultrasonic Force Microscopy (UFM) to locally quantify the variation of out-of-plane Young's modulus in minimally twisted double bilayer graphene (TDBG). We reveal a softening of the Young's modulus by 7% and 17% along single and double domain walls, respectively.

Nanoarchitecture factors of solid electrolyte interphase formation via 3D nano-rheology microscopy and surface force-distance spectroscopy.

The solid electrolyte interphase in rechargeable Li-ion batteries, its dynamics and, significantly, its nanoscale structure and composition, hold clues to high-performing and safe energy storage. Unfortunately, knowledge of solid electrolyte interphase formation is limited due to the lack of in situ nano-characterization tools for probing solid-liquid interfaces. Here, we link electrochemical atomic force microscopy, three-dimensional nano-rheology microscopy and surface force-distance spectroscopy, to study, in situ and operando, the dynamic formation of the solid electrolyte interphase starting from a few 0.

Combating Li metal deposits in all-solid-state battery via the piezoelectric and ferroelectric effects.

All-solid-state Li-metal batteries (ASSLBs) are highly desirable, due to their inherent safety and high energy density; however, the irregular and uncontrolled growth of Li filaments is detrimental to interfacial stability and safety. Herein, we report on the incorporation of piezo-/ferroelectric BaTiO (BTO) nanofibers into solid electrolytes and determination of electric-field distribution due to BTO inclusion that effectively regulates the nucleation and growth of Li dendrites. Theoretical simulations predict that the piezoelectric effect of BTO embedded in solid electrolyte reduces the driving force of dendrite growth at high curvatures, while its ferroelectricity reduces the overpotential, which helps to regularize Li deposition and Li flux.

Synthesis, characterisation, and feasibility studies on the use of vanadium tellurate(vi) as a cathode material for aqueous rechargeable Zn-ion batteries.

Aqueous rechargeable zinc-ion batteries (AZIBs) have drawn enormous attention in stationary applications due to their high safety and low cost. However, the search for new positive electrode materials with satisfactory electrochemical performance for practical applications remains a challenge. In this work, we report a comprehensive study on the use of the vanadium tellurate (NH){(VO)[TeO(OH)]}·2HO, which is tested for the first time as a cathode material in AZIBs.

Low thermal conductivity in franckeite heterostructures.

Layered crystals are known to be good candidates for bulk thermoelectric applications as they open new ways to realise highly efficient devices. Two dimensional materials, isolated from layered materials, and their stacking into heterostructures have attracted intense research attention for nanoscale applications due to their high Seebeck coefficient and possibilities to engineer their thermoelectric properties. However, integration to thermoelectric devices is problematic due to their usually high thermal conductivities.

Complementary sample preparation strategies (PVD/BEXP) combining with multifunctional SPM for the characterizations of battery interfacial properties.

The cathode/anode-electrolyte interfaces in lithium/sodium ion batteries act as the "gate" for the ion exchange between the solid electrode and liquid electrolyte. Understanding the interfacial properties of these solid-liquid interfaces is essential for better design high-performance lithium/sodium ion batteries. Here, we provide a novel method for studying solid-liquid interfacial properties of battery materials through combining physical vapor deposition (PVD) and beam-exit cross-sectional polishing (BEXP) followed by controlled environment multifunctional Scanning Probe Microscope (SPM).

Quantifying thermal transport in buried semiconductor nanostructures via cross-sectional scanning thermal microscopy.

Managing thermal transport in nanostructures became a major challenge in the development of active microelectronic, optoelectronic and thermoelectric devices, stalling the famous Moore's law of clock speed increase of microprocessors for more than a decade. To find the solution to this and linked problems, one needs to quantify the ability of these nanostructures to conduct heat with adequate precision, nanoscale resolution, and, essentially, for the internal layers buried in the 3D structure of modern semiconductor devices. Existing thermoreflectance measurements and "hot wire" 3ω methods cannot be effectively used at lateral dimensions of a layer below a micrometre; moreover, they are sensitive mainly to the surface layers of a relatively high thickness of above 100 nm.

Scanning Probe Spectroscopy of WS/Graphene Van Der Waals Heterostructures.

In this paper, we present a study of tungsten disulfide (WS) two-dimensional (2D) crystals, grown on epitaxial Graphene. In particular, we have employed scanning electron microscopy (SEM) and µRaman spectroscopy combined with multifunctional scanning probe microscopy (SPM), operating in peak force-quantitative nano mechanical (PF-QNM), ultrasonic force microscopy (UFM) and electrostatic force microscopy (EFM) modes. This comparative approach provides a wealth of useful complementary information and allows one to cross-analyze on the nanoscale the morphological, mechanical, and electrostatic properties of the 2D heterostructures analyzed.

Mapping nanoscale dynamic properties of suspended and supported multi-layer graphene membranes via contact resonance and ultrasonic scanning probe microscopies.

Graphene's (GR) remarkable mechanical and electrical properties-such as its Young's modulus, low mass per unit area, natural atomic flatness and electrical conductance-would make it an ideal material for micro and nanoelectromechanical systems (MEMS and NEMS). However, the difficulty of attaching GR to supports, coupled with naturally occurring internal defects in a few layer GR can significantly adversely affect the performance of such devices. Here, we have used a combined contact resonance atomic force microscopy (CR-AFM) and ultrasonic force microscopy (UFM) approach to characterise and map with nanoscale spatial resolution GR membrane properties inaccessible to most conventional scanning probe characterisation techniques.

Scale-Up of Room-Temperature Constructive Quantum Interference from Single Molecules to Self-Assembled Molecular-Electronic Films.

The realization of self-assembled molecular-electronic films, whose room-temperature transport properties are controlled by quantum interference (QI), is an essential step in the scale-up of QI effects from single molecules to parallel arrays of molecules. Recently, the effect of QI (DQI) on the electrical conductance of self-assembled monolayers (SAMs) has been investigated. Here, through a combined experimental and theoretical investigation, we demonstrate chemical control of different forms of QI (CQI) in cross-plane transport through SAMs and assess its influence on cross-plane thermoelectricity in SAMs.

[Amplitude-frequency characteristics of the retina under diffuse and pattern stimulation and new formalized signs of flicker and pattern electroretinogram].

Unlabelled: The clinical sugnificance of electroretinogram interpretation depends heavily on the employed mathematical apparatus. Currently, conventional calculation of the amplitude and time parameters of electroretinogram (ERG) components and their relations (indices), as well as analysis of the frequency spectrum of the signal are becoming insufficient for interpretation of the obtained data. New approaches to diagnostics are currently being developed, using, among other things, expert systems, and neural network and simulation models.

Micro-Acoustic-Trap (µAT) for microparticle assembly in 3D.

Acoustic tweezers facilitate the manipulation of objects using sound waves. With the current state of the technology one can only control mobility for a single or few microparticles. This article presents a state of the art system where an Acoustic Lens was used for developing a Micro-Acoustic Trap for microparticle assembly in 3D.

Geometrically Enhanced Thermoelectric Effects in Graphene Nanoconstrictions.

The influence of nanostructuring and quantum confinement on the thermoelectric properties of materials has been extensively studied. While this has made possible multiple breakthroughs in the achievable figure of merit, classical confinement, and its effect on the local Seebeck coefficient has mostly been neglected, as has the Peltier effect in general due to the complexity of measuring small temperature gradients locally. Here we report that reducing the width of a graphene channel to 100 nm changes the Seebeck coefficient by orders of magnitude.

Large-Area Heterostructures from Graphene and Encapsulated Colloidal Quantum Dots via the Langmuir-Blodgett Method.

This work explores the assembly of large-area heterostructures comprised of a film of silica-encapsulated, semiconducting colloidal quantum dots, deposited via the Langmuir-Blodgett method, sandwiched between two graphene sheets. The luminescent, electrically insulating film served as a dielectric, with the top graphene sheet patterned into an electrode and successfully used as a top gate for an underlying graphene field-effect transistor. This heterostructure paves the way for developing novel hybrid optoelectronic devices through the integration of 2D and 0D materials.

Thermal transport in epitaxial Si Ge alloy nanowires with varying composition and morphology.

We report on structural, compositional, and thermal characterization of self-assembled in-plane epitaxial Si Ge alloy nanowires grown by molecular beam epitaxy on Si (001) substrates. The thermal properties were studied by means of scanning thermal microscopy (SThM), while the microstructural characteristics, the spatial distribution of the elemental composition of the alloy nanowires and the sample surface were investigated by transmission electron microscopy and energy dispersive x-ray microanalysis. We provide new insights regarding the morphology of the in-plane nanostructures, their size-dependent gradient chemical composition, and the formation of a 5 nm thick wetting layer on the Si substrate surface.

Field-Effect Control of Graphene-Fullerene Thermoelectric Nanodevices.

Although it was demonstrated that discrete molecular levels determine the sign and magnitude of the thermoelectric effect in single-molecule junctions, full electrostatic control of these levels has not been achieved to date. Here, we show that graphene nanogaps combined with gold microheaters serve as a testbed for studying single-molecule thermoelectricity. Reduced screening of the gate electric field compared to conventional metal electrodes allows control of the position of the dominant transport orbital by hundreds of meV.

Formation of Two-Dimensional Micelles on Graphene: Multi-Scale Theoretical and Experimental Study.

Graphene and related two-dimensional (2D) materials possess outstanding electronic and mechanical properties, chemical stability, and high surface area. However, to realize graphene's potential for a range of applications in materials science and nanotechnology there is a need to understand and control the interaction of graphene with tailored high-performance surfactants designed to facilitate the preparation, manipulation, and functionalization of new graphene systems. Here we report a combined experimental and theoretical study of the surface structure and dynamics on graphene of pyrene-oligoethylene glycol (OEG) -based surfactants, which have previously been shown to disperse carbon nanotubes in water.

Subsurface imaging of two-dimensional materials at the nanoscale.

Scanning probe microscopy (SPM) represents a powerful tool that, in the past 30 years, has allowed for the investigation of material surfaces in unprecedented ways at the nanoscale level. However, SPM has shown very little capability for depth penetration, which several nanotechnology applications require. Subsurface imaging has been achieved only in a few cases, when subsurface features influence the physical properties of the surface, such as the electronic states or the heat transfer.

Structural and Electrical Characterization of SiO Gate Dielectrics Deposited from Solutions at Moderate Temperatures in Air.

Silicon dioxide (SiO) is the most widely used dielectric for electronic applications. It is usually produced by thermal oxidation of silicon or by using a wide range of vacuum-based techniques. By default, the growth of SiO by thermal oxidation of silicon requires the use of Si substrates whereas the other deposition techniques either produce low quality or poor interface material and mostly require high deposition or annealing temperatures.