Evaluation of methods for characterizing the fine particulate matter emissions from aircraft and other diffusion flame combustion aerosol sources.

The U. S. Environmental Protection Agency in collaboration with the U.

Measuring the Air Quality Using Low-Cost Air Sensors in a Parking Garage at University of Minnesota, USA.

The concentration of air pollutants in underground parking garages has been found to be higher compared to ambient air. Vehicle emissions from cold starts are the main sources of air pollution in underground parking garages. Eight days of measurements, using low-cost air sensors, were conducted at one underground parking garage at the University of Minnesota, Minneapolis.

Experimental verification of principal losses in a regulatory particulate matter emissions sampling system for aircraft turbine engines.

A sampling system for measuring emissions of nonvolatile particulate matter (nvPM) from aircraft gas turbine engines has been developed to replace the use of smoke number and is used for international regulatory purposes. This sampling system can be up to 35 m in length. The sampling system length in addition to the volatile particle remover (VPR) and other sampling system components lead to substantial particle losses, which are a function of the particle size distribution, ranging from 50 to 90% for particle number concentrations and 10-50% for particle mass concentrations.

Assessment of a regulatory measurement system for the determination of the non-volatile particulate matter emissions from commercial aircraft engines.

The SAE International has published Aerospace Information Report (AIR) 6241 which outlined the design and operation of a standardized measurement system for measuring non-volatile particulate matter (nvPM) mass and number emissions from commercial aircraft engines. Prior to this research, evaluation of this system by various investigators revealed differences in nvPM mass emissions measurement on the order of 15-30% both within a single sampling system and between two systems operating in parallel and measuring nvPM mass emissions from the same source. To investigate this issue, the U.

Impact of Biofuel Blends on Black Carbon Emissions from a Gas Turbine Engine.

Presented here is an overview of non-volatile particulate matter (nvPM) emissions, i.e. "soot" as assessed by TEM analyses of samples collected after the exhaust of a J-85 turbojet fueled with Jet-A as well as with blends of Jet-A and Camelina biofuel.

Gravimetric Measurements of Filtering Facepiece Respirators Challenged With Diesel Exhaust.

Elevated concentrations of diesel exhaust have been linked to adverse health effects. Filtering facepiece respirators (FFRs) are widely used as a form of respiratory protection against diesel particulate matter (DPM) in occupational settings. Previous results (Penconek A, Drążyk P, Moskal A.

Lagrangian Hotspots of In-Use NOX Emissions from Transit Buses.

In-use, spatiotemporal NOX emissions were measured from a conventional powertrain transit bus and a series electric hybrid bus over gradients of route kinetic intensity and ambient temperature. This paper introduces a new method for identifying NOX emissions hotspots along a bus route using high fidelity Lagrangian vehicle data to explore spatial interactions that may influence emissions production. Our study shows that the studied transit buses emit higher than regulated emissions because on-route operation does not accurately represent the range of engine operation tested according to regulatory standards.

Comparison of particle mass and solid particle number (SPN) emissions from a heavy-duty diesel vehicle under on-road driving conditions and a standard testing cycle.

It is important to understand the differences between emissions from standard laboratory testing cycles and those from actual on-road driving conditions, especially for solid particle number (SPN) emissions now being regulated in Europe. This study compared particle mass and SPN emissions from a heavy-duty diesel vehicle operating over the urban dynamometer driving schedule (UDDS) and actual on-road driving conditions. Particle mass emissions were calculated using the integrated particle size distribution (IPSD) method and called MIPSD.

Carbon nanotubes among diesel exhaust particles: real samples or contaminants?

During three separate studies involving characterization of diesel particulate matter carbon nanotubes (CNTs) were found among diesel exhaust particles sampled onto transmission electron microscopy (TEM) grids. During these studies, samples were collected from three different diesel engines at normal operating conditions with or without an iron catalyst (introduced as ferrocene) in the fuel. This paper is to report the authors' observation of CNTs among diesel exhaust particles, with the intent to stimulate awareness and further discussion regarding the formation mechanisms of CNTs during diesel combustion.

Simultaneous reduction of particulate matter and NO(x) emissions using 4-way catalyzed filtration systems.

The next generation of diesel emission control devices includes 4-way catalyzed filtration systems (4WCFS) consisting of both NOx and diesel particulate matter (DPM) control. A methodology was developed to simultaneously evaluate the NOx and DPM control performance of miniature 4WCFS made from acicular mullite, an advanced ceramic material (ACM), that were challenged with diesel exhaust. The impact of catalyst loading and substrate porosity on catalytic performance of the NOx trap was evaluated.

Comparison of methods for online measurement of diesel particulate matter.

Gravimetric analysis is the regulatory method for diesel particulate mass measurement. Because of issues such as adsorption/volatilization artifacts, it faces obstacles in measuring ultra low level emissions from modern diesel engines. Alternative methods of suspended particle mass measurement have been developed that show improvements in time resolution, sensitivity, and accuracy.

Alternatives to the gravimetric method for quantification of diesel particulate matter near the lower level of detection.

This paper is part of the Journal of the Air & Waste Management Association's 2010 special issue on combustion aerosol measurements. The issue is a combination of papers that synthesize and evaluate ideas and perspectives that were presented by experts at a series of workshops sponsored by the Coordinating Research Council that aimed to evaluate the current and future status of diesel particulate matter (DPM) measurement. Measurement of DPM is a complex issue with many stakeholders, including air quality management and enforcement agencies, engine manufacturers, health experts, and climatologists.

Evaluation of a portable photometer for estimating diesel particulate matter concentrations in an underground limestone mine.

A low cost, battery-operated, portable, real-time aerosol analyzer is not available for monitoring diesel particulate matter (DPM) concentrations in underground mines. This study summarizes a field evaluation conducted at an underground limestone mine to evaluate the potential of the TSI AM 510 portable photometer (equipped with a Dorr-Oliver cyclone and 1.0-mum impactor) to qualitatively track time-weighted average mass and elemental, organic, and total carbon (TC) measurements associated with diesel emissions.

Effect of organometallic fuel additives on nanoparticle emissions from a gasoline passenger car.

Particle size measurements were performed on the exhaust of a car operating on a chassis dynamometer fueled with standard gasoline and gasoline containing low levels of Pb, Fe, and Mn organometallic additives. When additives were present there was a distinct nucleation mode consisting primarily of sub-10 nm nanoparticles. At equal molar dosing Mn and Fe gave similar nanoparticle concentrations at the tailpipe, whereas Pb gave a considerably lower concentration.

Reducing motor vehicle greenhouse gas emissions in a non-California state: a case study of Minnesota.

Approaches for reducing greenhouse gas (GHG) emissions from motor vehicles include more-efficient vehicles, lower-carbon fuels, and reducing vehicle-kilometers traveled (VKT). Many U.S.

The effect of federal fuel sulfur regulations on in-use fleets: on-road heavy-duty source apportionment.

From 2002 to 2007 fuel sulfur content in the Minneapolis/St Paul area decreased from about 325 ppm S to <15 ppm S as a result of EPA regulations. We hypothesized that the reduction in fuel sulfur would result in a reduction of fuel specific heavy duty (HD) particle number emissions for the on-road diesel fleet. Fuel specific emissions were estimated by collecting on-road aerosol data, and exploiting the difference in the relative volumes of HD and light duty (LD) traffic on the roadway.

Effect of fuel and lube oil sulfur on the performance of a diesel exhaust gas continuously regenerating trap.

The continuously regenerating trap (CRT) is a diesel exhaust emission control that removes nearly all diesel particulate matter on a mass basis, but under some circumstances oxidation of sulfur leads to the formation of nanoparticles. The objective of the four year study was to determine CRT performance under controlled, real-world, on-road conditions, and to develop quantitative relationships between fuel and lubrication oil sulfur concentration and particle number exhaust emissions. It was shown that nanoparticle emissions are minimized by the use of ultralow sulfur fuels and specially formulated low sulfur lubrication oil.

Physical and chemical properties of bio-oils from microwave pyrolysis of corn stover.

This study was aimed to understand the physical and chemical properties of pyrolytic bio-oils produced from microwave pyrolysis of corn stover regarding their potential use as gas turbine and home heating fuels. The ash content, solids content, pH, heating value, minerals, elemental ratio, moisture content, and viscosity of the bio-oils were determined. The water content was approx 15.

Nuclei-mode particulate emissions and their response to fuel sulfur content and primary dilution during transient operations of old and modern diesel engines.

The effects of fuel sulfur content and primary dilution on PM number emissions were investigated during transient operations of an old and a modern diesel engine. Emissions were also studied during steady-state operations in order to confirm consistency with previous findings. Testing methods were concurrent with those implemented by the EPA to regulate PM mass emissions, including the use of the Federal Transient Testing Procedure-Heavy Duty cycle to simulate transient conditions and the use of a Critical Flow Venturi-Constant Volume System to provide primary dilution.

Effects of on-road highway aerosol exposures on autonomic responses in aged, spontaneously hypertensive rats.

Epidemiological studies associate ambient particulate pollution with adverse health outcomes in elderly individuals with cardiopulmonary diseases. We hypothesized that freshly generated ultrafine particles (UFP) contribute to these effects, as they are present in high number concentrations on highways and vehicle passengers are exposed directly to them. Aged spontaneously hypertensive rats (9-12 mo) with implanted radiotelemetry devices were exposed to highway aerosol or filtered, gas-denuded (clean) air using an on-road exposure system to examine effects on heart rate (HR) and heart-rate variability (HRV).

Chemical and physical properties of ultrafine diesel exhaust particles sampled downstream of a catalytic trap.

The chemical and physical properties of exhaust particles produced by a Caterpillar 3176 C-12 heavy duty diesel engine equipped with a catalytic trap (CRT) are reported. The engine was operated at 600 Nm and 1500 rpm, using fuels containing 15 and 49 ppm sulfur. A two-stage dilution tunnel designed to simulate the reactions that occur when hot combustion products mix with cooler atmospheric air was used.

Characteristics of SME biodiesel-fueled diesel particle emissions and the kinetics of oxidation.

Biodiesel is one of the most promising alternative diesel fuels. As diesel emission regulations have become more stringent, the diesel particulate filter (DPF) has become an essential part of the aftertreatment system. Knowledge of kinetics of exhaust particle oxidation for alternative diesel fuels is useful in estimating the change in regeneration behavior of a DPF with such fuels.

Enhanced coagulation due to evaporation and its effect on nanoparticle evolution.

A new explanation for the evolution of particles near a roadway is proposed. The explanation starts with data that suggest that small (<15 nm) liquid nanoparticles shed semivolatile organics ( View Article and Find Full Text PDF

Mass, surface area and number metrics in diesel occupational exposure assessment.

While diesel aerosol exposure assessment has traditionally been based on the mass concentration metric, recent studies have suggested that particle number and surface area concentrations may be more health-relevant. In this study, we evaluated the exposures of three occupational groups-bus drivers, parking garage attendants, and bus mechanics-using the mass concentration of elemental carbon (EC) as well as surface area and number concentrations. These occupational groups are exposed to mixtures of diesel and gasoline exhaust on a regular basis in various ratios.